inno racks bra590 air cruiser cargo box assembly installation
Contents
1. These additional instructions are for the slide feature After reading this manual keep it in a safe place along with the instructions for the rest of your carrier system If you have any questions regarding the information in this manual please contact the service center listed at the end The slide block includes the parts listed below Verify that they are included with the carrier you have purchased In the event that any of these is missing contact our service center as listed at the end of this manual When using the slide system park the car on horizontal ground O wn e xL 1 1 Lift lever to release lock for sliding 3 After loading your gear push the base back to its original position until clicks into place 2 Pull back on the lever to slide out the base Rail O Push whole lever 2 Pull the slide block and slide it out from the plate Knob bolts REMOVING THE SKI CRADLES 1 Lift the cradle latch 2 Pull the latch down 3 Slide out ski cradles CARRYING SKIS The ski cradles must be inserted in this order Place skis back to back in pairs in each cradle Load skis with the tail end toward the front of the box From lever side A A A B C The arrow points toward the lever Ski cradle A CARRYING SNOWBOARDS Follow step 3 the insert the rubber seal into the track on the slide block Rubber Seal Binding w C JE CN J Fon m 6 After loading gear use the suppl2. ADVANCED CAR RACKS Read and understand this user s manual thoroughly before using your new cargo box and be sure to follow all usage instructions Keep this manual in a safe place so that it s handy for reference anytime If you have any questions regarding the information in this manual please contact the service center listed at the end of this manual AN Precautions There should be a distance of at least 60 cm 2 feet between the front and rear crossbars Cross bars Resa ea ice An AN When loading spread your cargo Front Center Rear evenly throughout the box Avoid 10kg 27kg 13kg loading more than 10 kg 22 Ibs 22 bs 60 lbs _ 28 Lbs jn the front area of the box a Unbalanced loading may result in Safety problems Obey posted speed limits Under high wind or poor road condtions drive at a lower speed Do not expose the cargo box to hurricane or gale force wind conditions Do not apply lubricants oil or grease to damper hinges or box surface as they may damage the box A damaged box may be Structurally weaker and may not perform Safely Avoid loading gear that you do not want to get wer While the box is water resistance it is not waterproof Cargo may get wet when the box is used in rainy conditions The installed box increases the height of your vehicle Pay close attention to this new height so that you do not
3. hit objects such as signs trees or garage ceilings and doors If you do hit an object with the rack check to ensure that it is stil securely attached Direct sunlight on the box can elevate the temperature inside the box and damage or harm the above items While our box is designed to mount to a variety of crossbar types we have no control over non Inno rack quality We cannot guarantee the performance of our carrier when mounted on a rack made by Do attempt to modify the box in any way Make sure before driving that the box is securely closed and locked If it is not securely closed or unlocked it may open accidentally and you may lose your Cargo or cause a Serious accident Avoid loading the following types of cargo 1 Highly pressurized spray cans 2 Flammable goods 3 Sensitive or delicate machines and electronics 4 Pet animals 5 Perishables Make sure that the box does not interfere with opening of the rear door If you cannot avoid interference apply a protective pad to avoid 7 damage to either the Box or car body Pay close attention when opening and closing the box under high wind conditions The wind may cause the box to open or close more quickly than normal Be careful with your fingers in these situations Do not drive your cargo box through a car wash Always remove the carrier system before running your car through a car wash Care and Storage Wash a
4. CARMATE Cargo Box Installation Instructions 5735 70195 yz mMNnNnoO ADVANCED CAR RACKS These instructions are for the installation and use of the Inno carrier system attachment After reading this manual keep it in a safe place along with the installation instructions for the rest of your carrier system If you have any questions regarding the information in this manual please contact the service center listed at the end PRECAU TIONS Do not overload your cargo box Maximum load Capacity varies by vehicle Check the appropriate limits for your car in the Fit Guide and your vehicle owner s manual and determine your maximum loading capacity with the formula below Nin Ht Use the lower of the 2 options below Weight of Cargo box Max load of OR vehicle or cross bar Max load of cargo box 110 Ibs The Cargo box includes the parts listed below Verify that they are included with the carrier you have purchased In the event any of these is missing contact our service center as listed at the end of this manual knob 8 Hole Covering 6 the ring on the Plate is on the side nearest the side of box Attach the Box to front cross bar with Plate U Bolt and Knobs Make sure that Make sure to tighten the right and left knobs evenly so that the U bolt sits square with the bar If U bolt is not tightened correctly it may allow the box to come loose Cargo Box Cross Bar Threa
5. d Strap trough two Rings on each side of the box and fasten Attach Strap Hooks inside box lid just above Straps Before driving the vehicle shake the rack in all directions to ensure that there is no looseness in any of the mounting knobs and screws Retighten any loose knobs or screws If using an aftermarket base rack system make sure that it is installed properly according to the procedures described in the installation instructions for that rack N CAUTION The distance between the front and rear crossbars should be at least 60cm 2 feet Temporarily put the Box on cross bars And Insert key turn clockwise and push button to open the Box push button Adjust the location of the Box to align with holes at A Rooftop Box Front Place plugs into the 6 unused holes to seal Rear Trim Molding to the proper size and insert into slot U Bolt Cut Molding to this size Push Box in all directions to make sure that there is no loosenesss If you notice any play in the box retighten 8 Knobs Insert Key into key cylinder and turn it clockwise to Open position Lift Box Lid by A Caution pushing release button Leave Key in key cylinder until Box is closed to avoid locking it in the box Box lid oe accidentally To close lid make sure that Key is in the OPEN position Make sure that Hooks line loading Load cargo Unhook Straps and fasten it to secure cargo from moving while up with latches and close Box all the
6. ied straps to hold skis and snowboards from moving around Attaching the strap to the cargo box is described in the main instructions for the box This is the way to use the strap for Snowboards To carry skis and snowboards at the same time load them as in the illustration to the right Carry up 2 skis Snowboards Strap Skis and 2 snowboards at the same time Remove ski cradles A B and C from the slide block Side opposite the lever Snowboard Stra Slide block Genuine Inno Replacement P arts The following genuine replacement parts are available for this Inno carrier system Ski cradle component Specifications and the appearance of the carrier system and genuine replacement Ski Cradle Set parts are subject to change without prior notice in the interest of product improvement SkicradleA 3 sk cradle B 1 SkicradleC 1 Knob Bolt Rubber Seal Contact Information If you have any questions or comments please contact us at the service center listed below Car Mate USA shall not be held liable for any accidents or incidental losses arising from improper installation or use nor for those arising from installation or use after the customer has made any change to the system s original configuration or specifications 7 INNO ADVANCED CAR RACKS Car Mate USA Inc 383 Van Ness Ave Suite 1603 Torrance CA 310 533 9881 www innoracks com Support rv inno com CAR MATE Important Notes on the Cargo Box riialalee
7. ny mud off the carrier 2 After cleaning carrier check for any of the following system Use a damp towel to wipe away dust and dirt Do not use any thinner or solvents to clean any part of the carrier system 1 Worn screw threads 2 Key deformation 3 Holder deformation 4 Cracks in any of the components of the carrier system Store all components of the carrier system together in one place to prevent any component from being lost Avoid storage in areas Subject to direct sunlight high temperature or excessive humidity
8. way Unfasten Buckle and hang Straps on Strap Hooks to keep them out of the way while driving Strap Hook Try to lift the lid at the latch points shown below to make sure that the hooks have full engaged with the latches The front and rear red stickers will disappear from when lid is properly closed Turn Key counter clockwise to the CLOSE position Genuine Inno Replacement Parts ISP952 Strap p55 Seep ice The following genuine replacement parts are available for this Inno carrier system component Specify the part number when ordering parts from your dealer Specifications and the appearance of the carrier system and genuine replacement parts are subject to change without prior notice in the interest of product l improvement ISP193 Molding ISP588 Hole Plugs 4 pack 2 Key Verify Instruction Manual Key number eee ee mee Contact Information If you have any questions or comments please contact us at the service center listed below CarMate shall not be held liable for any accidents or incidental losses arising from improper installation or use nor for those arising from installation or use after the customer has made any change to the system s original configuration or specifications Ye ADVANCED CAR RACKS Car Mate USA 383 Van Ness Ave Suite 1603 Torrance CA 310 533 9881 www innoracks com support rv inno com CAR MATE 5735 70195 Slide Block Additional Instructions rz mnno
Download Pdf Manuals
Related Search