"user manual"
Contents
1. Dehumidifier User Manual Models KU34293 30 Pint KU34393 40 Pint KU34643 65 Pint Before Operating this products please read the instructions carefully and save this manual for future use SAFETY PRECAUTIONS To prevent injury to the user or other people and property damage the following instructions must be followed Incorrect operation due to ignoring of instructions may cause harm or damage E The seriousness is classified by the following indications WARNING This symbol indicates the possibility of death or serious injury CAUTION This symbol indicates the possibility of injury or damage to property E Meanings of symbols used in this manual are as shown below A WARNING of the power outlet or Do not operate or stop the Do not damage or use an unit by switching on or off unspecified power cord connection device the power Otherwise it may cause electric It may cause electric shock or fire It may cause electric shock or fire shock or fire due to excess heat due to heat generation generation QDo not modify power cord Do not exceed the rating Do not place the unit near Do not inser or pull out length or share the outlet plug with wet hands a heat source with other appliances It may cause electric shock or It may cause electric shock Plastic parts may melt and cause fire due to heat generation a fire You should never try to take2. Before cleaning turn off strange sounds smell or apart or repair the unit by the power and unplug the smoke comes from it yourself it may cause fire and electric It may cause failure of machine It may cause electrical shock or shock or electric shock injury Disconnect the power if unit Do not open the unit Do not drink or use the water drained from air conditioner Do not use the machine near flammable gas or combustibles such as gasoline benzene thinner etc during operation t may cause an explosion or fire It contains contaminants and t may cause electric shock could make you sick When using in closets or Do not put in places where Place the unit on a other small spaces be water may splash onto the level sturdy section of sure to keep doors open unit the floor e Lack of ventilation can cause Water may enter the unit and If the unit falls over it may overheating and fire degrade the insulation It may cause water to spill and cause an electric shock or fire damage belongings or cause electrical shock or fire Do not cover the intake or exhaust openings with cloths or towels A lack of air flow can lead to overheating and fire When the unit is to be cleaned switch off and turn off the circuit breaker Do not clean unit when power is on as it may cause fire and electric shock it may Cause an
3. OFF times are now programmed e Turning the unit ON or OFF at any time or adjusting the timer setting to 0 0 will cancel the Auto Start Stop function e When LED display window displays the code of P2 the Auto Start Stop function will also be cancelled IDENTIFICATION OF PARTS Identification of parts Tl ront Control panel Air intake grille Air outlet grille Handel Water bucket Water level window 00000 AJ ear Drain hose outlet O Qe Caster Power Cord and plug 4 Power cord Buckle model A or Band model B Used only when storing the unit NOTE A the pictures inthe manual are for explanation purposes only The actual shape ofthe unit you purchased may be slightly different but the operations and functions are the same LY MLL ML KAJ AS Fig 2 Fig 3 OPERATING THE UNIT Removing the collected water 1 Pull out the bucket a little There are two ways to remove collected water 1 Use the bucket e When the unit is off if the bucket is full the unit will beep 8 times and the Full indicator light will flash the digital display shows P2 e When the unit is on if the bucket is full the compressor turns off and the fan turns off after 3 minutes for drying the water of the condenser then the unit will beep 8 times and the Full indicator light will flash the digital display shows P2 e Slowly pull out the bucket Grip the left and right ha
4. dity sensor error Unplug the unit and plug it back in If efror repeats call for service ES Temperature sensor error Unplug the unit and plug it back in If error repeats call for service P1 Unit is defrosting Allow the unit time to automatically defros The error will clear after the unit self defrosts P2 Bucket is full Empty the bucket and replace in the right position E1 Unit malfunction Unplug the unit and plug it 6 back in If error repeats call for service Power Outage In the case of a power outage or interruption the unit will automatically re start in the settings last used after the power is restored etting the Timer e When the unitis on first press the Timer button the TIMER OFF indicator light illuminates It indicates the Auto Stop program is initiated e When the unit Is off first press the Timer button the TIMER ON indicator light illuminates It indicates the Auto Start program is initiated Press or hold the UP or DOWN pad to change the Auto time by 0 5 hour incre ments up to 10 hours then at 1 hour in rements up to 24 hours The control will count down the time remaining until Start e The selected time will register in 5second and the system will automatically revert back to display the previous humidity setting e When the Auto start amp Auto stop times are set within the same program sequence TIMER ON OFF indicator lights illuminate identifying both ON and
5. e bucket backin the unit and make sure that itis located correctly Fig 9c e Select the desired humidity setting and fan speed on the unit for continuous draining to start SE Fig 5 2 Hold both sides of the bucket with even strength and pull it out from the unit Fig NOTE If the unit stops operating check that the bucket full light is illuminated If it is remove the bucket a d empty the contents and then check the seal between the hose and the drip tray If there is a small leak then replace tne hose gasket and re tignten the hose CARE AND MAINTENANCE Care and cleaning of the dehumidifier Turn the dehumidifier off and remove the plug from the wall outlet before cleaning 1 4 Clean the bucket Clean the air filter Clean the Grille and Case Use water and a mild detergent Do not use bleach or abrasives Do not splash water directly onto the main unit Doing SO may cause an electrical shock cause the insulation to deteriorate or cause the unit to rust The air intake and outlet grilles get soiled easily so use a vacuum attachment or brush to clean Every few weeks clean the bucket to prevent growth of mold mildew and bacteria Partially fill the bucket with clean water and add a little mild detergent Swish it around in the bucket empty and rinse NOTE Do not use a dishwasher to clean the bucket After clean the bucket must be in place and securely seated for the dehumidifi
6. eactive the airborne chemical vapors and dust particles Press it again to stop the function Other features Bucket Full Light Glows when the bucket is ready to be emptied or when the bucket is removed or not replaced in the proper position Auto Shut Off The dehumidifier shuts off after 3 minutes when the bucket is full or when the bucket is removed or not replaced in the proper position When the setting humidity is reached the unit will be shut off automatically Auto Defrost When frost builds up on the evaporator coils the compressor will cycle off and the fan will continue to run until the frost disappears Wait 3 minutes before resuming operation After the unit has stopped it can not be restart opertation in the first 3 minutes This is to protect the unit Operation will automatically start after 3 minutes Check filter feature The system starts to count the time once the fan motor operates The check filter feature can be only activated when the accumulated operation time achieves 250 hours or more The CHECK FILTER indicator light flashes at 1Hz after finishing clean the air filter press the Filter pad and the CHECK FILTER indicator light goes off Displa Shows the set humidity level from 35 to 85 or auto start stop time 0 24 while setting then shows the actual 5 accuracy room humidity level in a range of 30 RH Relative Humidity to 90 RH Relative Humidity Error Codes AS Humi
7. eature coils Wat f Hose to connector or hose connection may be loose ao ee Intend to use the bucket to collect water but the back drain plug is removed ES AS P1 or P2 appear These arg error codes See the CONTROL PADS ON THE in the display DEHUMIDIFIER section
8. er to operate Remove the filter every two weeks based on normal operating conditions To remove the filter remove Bucket the pull filter downwards Wash the filter with clean water then dry Re install the filter replace Bucket CAUTION DO NOT operate the dehumidifier without a filter because dirt and lint will clog it and reduce performance When not using the unit for long time periods After turning off the unit wait one day before emptying the bucket Clean the main unit water bucket and air filter Twist the cord on the buckle Fig 12a or wrap the cord and bundle it with the band Fig 12b Cover the unit with a plastic bag Store the unit upright in a dry well ventilated place Fig 12b TROUBLESHOOTING TIPS Before calling for service review the chart below first yourself ae A er Te ate aaa ane DOU VP Pesan Soe beet taal et ka duc ea te a ee EEA Ea T test ee area IN RA Problem What to check a Sa AR Rung iss h aiit Make sure the dehumidifier s plug is pushed completely into the outlet Unit does not start Dehumidifier does not ity control may not be set low enough dry the air as it should all doors windows and other openings are securely The unit makes a loud The unit ig tilted instead of upright as it should be noise when operating The floor urface is not level Frost appears on the This is notmal The dehumidifier has Auto defrost f
9. injury Always insert the filters securely Clean filter once every two weeks Operation without filters may cause failure Do not underany circumstances cut remove orbypass the grounding prong This unit is grounded through the power cord plug when plugged into amatching wall outlet NOTE The illustrationis for explanation purpose only The actualshape of the plug and walloutlet may bedifferent SAFETY PRECAUTIONS CAUTION Care should be taken when using the unit in a room with the following persons Do not use in areas where chemicals are handled This will cause the unit deterioration due to chemicals and solvents dissolved in the air Infants children elderly people and people not senstive to humidity Do not climb up on or sit on the unit Do not place heavy object on the power cord and take care so that the cord is not compressed You may be injured if you There is danger 9 fire or fall or if the unit falls over electric shock lf water enters the unit turn the unit off and disconnect the power contact a qualified service technician Do not place flower vases or other water container on top of the unit It may cause failure of appliance or accident Water may spill inside the unit causing insulation failure and electrical shock or fire Electrical Information The manufactures nameplate is located o
10. n the rear panel of the unit and contains electrical and other technical data specific to this unit Be sure the air conditioner is properly grounded To minimize shock and fire hazards proper grounding is important The power cord is equipped with a three prong grounding plug for protection against shock hazards Your air conditioner must be used in a properly grounded wall receptacle If the wall receptacle you intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker have a qualified electrician install the proper receptacle Ensure the receptacle is accessible after the unit installation Do not use extension cords or an adapter plugs with this unit However if it is necessary to use an extension cord use an approved air conditioner extension cord only available at most local hardware stores To avoid the passibility of personal injury always disconnect the power supply to the unit before installing and or servicing CONTROL PADS ON THE DEHUMIDIFIER NOTE The control panel ofthe unit you purchased may be slightly different according to the models Timer on off Continuous Clean filter Pump Low fan High fan indicatot light Bucket full operation on lon Power on indicator light indicator light indicator light nd ator light indicator light indicator light indigator light indicator light Fig 1 Control pads When you push the button to change operation modes the unit will make a beep so
11. ndles securely and carefully pull out straight o water does not spill Do not put the tank on the floor e because the bottom of the bucket is uneven Otherwise the bucket will fall and cause the water to spill Throw away the water and replace the bucket The bucket must be in place and securely seated for the dehumidifier to operate e The machine will re start when the bucket is restored in its correct position NOTES e When you remove the bucket do not touch any parts inside of the unit Doing so may damage the product e Be sure to push the bucket gently all the way into the unit Banging the bucket against anything or failing to push it in securely may cause the unit not to operate e When you remove the bucket if there is some water in the unit you must dry it 2 Continuous draining Water canbe automatically emptied into a flogr drain by attaching the unit with a water hose 24mm not included e Remove the water bucket from the unit andet aside e Lift up the side flap located on the right side of the unitas looking from the front Fig 8 e Insert the female threaded end ofthe hose through the opening Fig 9a e Screw the garden hose onto the threaded portion of the tray underneath the bucket opening Fig 9b Make sure the hoseis secure so there are no leaks Direct the hose toward the drain making sure that there areno kinks that will stop the warter flowing Place the end of the hose into the drain Place th
12. und to indicate thatit is changing modes Pump Pad optional 2 Fan Pad Control the fan speed Press to select either High or Normal fan speed Set the fan control to High for maximum moisture removal When the humidity has been reduced and quiet operation is preferred set the fan control to Normal 06 C Down Up Pads e Humidity Set Control Pads The humidity level can be set within a range of 35 RH Relative Humidity to 85 RH Relative Humidity in 5 increments For drier air press the pad and set to a lower Press to activate water pumped drainage feature Press it again to cancel Filter Pad The check filter feature is a reminder to clean the Air Filter for more efficient operation The LED light will illuminate after 250 hours of operation To reset after cleaning the filter press the CHECK FILTER pad and the light will go off percent value For damper air press the pad and set a higher percent value Timer Set Control Pads Use the Up Down pads to set the Auto start and Auto stop time from 0 0 to 24 CONTROL PADS ON THE DEHUMIDIFIER Timer Pad Press to initiate the Auto start and Auto stop feature in conjuction with the and key pads Continue Pad press to activate the continuous dehumidifying operation POWER Pad Press to turn the dehumidifier on and off ION Pad optional Press to activate the ionizer Anions are automatically generated by ionization The anions d
Download Pdf Manuals
Related Search