User Manual - Emergency Caller Products
Contents
1. Components 1 The Universal Transmitter TR 300 TR 300 Extended Range Transmitter is Long Life battery operated and connects to Sensor Pads The transmitter is attached to posts on Wheelchair Beds etc with Fast Install Velcro Straps When sensor is activated by weight of patient getting ON or OFF sensor pad the transmitter sends the signal to the Enunciator ON OFF switch allows caretaker to attend patient The TR 300 transmitter is selectable to monitor chair bed floor and rail oed sensor pads Transmitter is selectable for INSTANT or DELAY operation allowing patient to move around in chair or bed without sending alarm The TR 300 Extended Range Transmitter has a switch to turn the transmitter on for instant or delayed operation or off to allow the caregiver to work with a patient and not have the alarm sound There is also a switch to set the sensor for Normally Open position O to acti vate the alarm when weight is getting on the pad or Normally Closed position C to activate the sensor when weight is getting off the pad We strongly recommend that you test the transmitter with the receiver enun ciator system frequently From the time of installation it is absolutely necessary to test the system at least once a week to ensure that the TR 300 transmitter will be ready when needed Changing Batteries The batteries should be replaced every year or as needed with your transmitting unit To replac2. e the batteries in your transmitter you will need two 3 volt Lithium batteries CR2025 or equivalent Carefully remove the screws on the transmitter case and separate the transmitter housing Observe the plastic housing inside that has the transmitting unit itself Plastic Housing Carefully remove the screws on the plastic housing Open the housing being careful not to pull the wires loose from the board Now carefully remove the circuit board inside and avoid touching any of the compo nents Remove the old batteries from the battery clip and place the new batteries under the clip with the posi tive ends of both batteries facing up Batteries Place the circuit board back in the housing and re assemble Then reassemble the main transmitter case DO NOT OVER TIGHTEN SCREWS After changing the batteries be sure to test the transmitter to make sure you have installed the batteries properly Now you can feel Safe Secure and at Ease whenev er patients family members or friends are confined to bed home or facility and need fast assistance Emergency Caller Products T 800 227 2474 F 800 762 7613 www emergencycaller com sales emergencycaller com U S A and World Patents Issued and Pending on Certain Products gen ITOR Universal Transmitter TR300 USER MANUAL QUICK START GUIDE Emergency Caller Products
Download Pdf Manuals
Related Search