View - PHEI KUAN Electronic Co., Ltd. 飛管電子股份有限公司
Contents
1. LPC amp EPC EDGE CONTROL SYSTEM H O W THE SERVO WORKS EFFICIENTLY A the three kinds of conditions might be occurred as follows The best situation Distance Stable Target position gt Start The acceptable situation Stable Distance Target position The worst situation Hunting The hunting is for too long or never stops l r Ya Start Can not get the targe position fast Timing Using EPC to do initiate and material setup or using LPC to do the twice setup to achieve the setup procedure Please refer to the operation manual or instruction card for more detail information The setup procedure is correct but the material condition is drastically unstable caused by edge not even bad tint printing and unstable transparence The initiate and material setup of EPC was not setup properly or the adjustment of sensitive or resolution is too high Tension control was not setup properly Wind blowing by fan makes the material flutter The sensor might be in the improper installation The edge of object material is bended or curled badly If cannot achieve the effects as item 1 amp 2 please contact us right away dm 1E The good working quality and producing efficiently will be achieved The result of accuracy might be in 0 05mm 0 2mm but no damage occurred at any equipment and components If the hunting cannot stop fo2. r long that will occur 1 The motor over heat and commutator will be worn out 2 The controller and mechanical structure will be damaged 3 The quality of produced material damaged SOLUTION Please keep on the good performance manner and apply the EPC or LPC products of PHEI KUAN in your jobs During the carrying of materials do not hit or damage the edge of material 1 Please apply the Simple Instruction Card to complete the setup procedure 2 Setup the tension control and make sure the material is attached properly on the roller To change the LPC or EPC from run model to stop model when machine is in the standby situation 3 Please remove the fan and do not blow the material directly 4 For sure the sensor is installed properly please refer the user s manual or contact us for further information Tel 02 2962 0335 Fax 02 2953 5681 AES TS IRA wi 1980527 E mail pheikuan ms5 hinet net PHEI KUAN Electronic Co Ltd SINCE 1980 Web site http www pheikuan com tw
Download Pdf Manuals
Related Search