MOB1 Installation in welded in bladder life jackets
Contents
1. ERAT D MOB1 USER MANUAL Supplement LIFE JACKET INSTALLATION FOR WELDED IN BLADDERS Note For description of parts mentioned below please refer to page 6 in the User Manual available on line at http oceansignal com wordpress wp content uploads MOB1 user manual pdf If your rescueME MOB1 is not already pre installed into the lifejacket please follow the instructions below carefully The diagrams below assume that the life jacket inflation tube is on the left hand side as viewed If the tube is on the right hand side then the activation tape should be fitted on the opposite sides shown Slide the red Arming Slide down Carefully move the grey Activation Slide to just expose the slot at the C3 edge of the slide Do not move it too far otherwise the antenna will be released RO Pass the loop at the end of the Activation Tape through the slot in the Activation Slide and pass the tape back through the loop Return the Activation Slide to the centre and move the red Arming Slide back to lock the slide in place RO Take the lifejacket Fixing Buckle Supplied and pass the tape through the slots as shown below making sure that tape does not get twisted roy Peel the protective backing off the back of the Fixing Buckle Patch Stick the fixing Buckle to the buckle patch as shown Clip the Mounting Bracket to the MOB1 so that the MOB1 is sited between the oral tube and the patch as shown2. Q The MOB1 should be mounted as low down on the oral tube as possible without interfering with closing the lifejacket over the MOB1 but with the MOB1 always sited between the tube and the patch Attach the Mounting Buckle and patch directly to the bladder at a distance which will ensure that as the bladder inflates the tape will pull the Activation Slide from the MOB1 Fold up the bladder and pull the Activation Tape tight with the free end of the tape so that the bladder is free to inflate and remains folded in accordance with the life jacket manufacturer s instructions Ensure that the tape is tight enough that when the life jacket inflates the MOB1 will activate Do not over tighten the tape Once the MOB1 is fully attached to the life jacket you are ready to arm the device by sliding the red Arming Slide down Q Failure to arm the MOB1 will inhibit the auto activation of the MOB1 when needed and will STOP the life jacket inflating correctly Q If the MOB1 has turned on during the installation process make sure it is turned off by pressing and holding the TEST OFF Key until the LED flashes red twice and then release Repack the bladder into the cover ensuring the bladder does not get trapped in the fastening mechanism or tangled up The above illustrations indicate a typical installation Please ensure that the position selected to attach the MOB1 to the oral tube does not hinder the inflation of the li
3. fe jacket but at the same time allows enough pull on the Activation Tape to fully remove the Activation Slide when the life jacket inflates Version 01 10 17 03 2015 2 Part No 912S 01772
Download Pdf Manuals
Related Search