Home
HMX280 - Koopjedrone
Contents
1. HSK www hiskyhobby com Fo e AE HiSKY HVIAZGU Instruction Manual E Than ony Gaz ing o ee and products E Read th ual c G Fi Table of Contents Foreword Declaration Caution 1 Definition of Flight Direction 2 Box Contents 3 Instructions of Charger 3 1 Instructions of Charger 3 2 Charging Procedure 4 Low voltage Protection of the Battery 5 Install the Landing Gear 5 1 Installation Procedure of the Landing Gear 6 Install the Motors 6 1 Installation Procedure of Rotors 7 Preparing the HMX280 for Flight and Reek the Motors 7 1 Mode choice of Transmitter 7 2 Steps of Flight 7 3 Unlock the Motors 7 4 Lock the Motors 7 5 Caution 8 Selection of Flight Modes 8 1 3 axis Flight Mode 8 2 6 axis Flight Mode 9 Flight Control Diagram 9 1 Flight in Normal Status 9 2 Practice Flips w 10 End the Flight 11 Exploded View 11 1 Parts of HMX280 12 HMX280 Data Ports 13 14 16 17 K Foreword Dear Customers Thanks for purchasing a HiSKY radio control aircraft product In order to quickly and safely master the operation of the HMX120 please read the manual carefully and then keep it properly for future consultation and reference a Declaration HMX280 quadcopter has potential danger Please operate itin the open spaces away from people Improper assembly damage of the air frame mal performance of the radio mal operation will result in injury or damage
2. to the right side Step3 Step4 Make the antenna pass through the Finish the installation landing gear and fasten the copper bush in the inner side A 6 Install the rotors 6 1 Installation Procedure of the motors 1 Unscrew the bullet head with screwdriver 2 Install the clockwise rotors to M2 and M4 motors 3 Install the counter clockwise rotors to M1 and M3 motors Step1 Step2 Unscrew the bullet head on the motors Don t mistake the up or down side of with the cross screwdriver the rotor as down or up side The side with 2 dots besides the hole is the up side while 4 dots is the down side Step3 Step4 Fasten the bullet head with the screwdriver Do the other three rotors same as the above 3 steps see the above picture Rotors of M1 and M2 are orange M1 is counter clockwise rotor while M2 is clockwise rotor Rotors of M3 and M4 are black M3 is counter clockwise rotor M4 is clockwise rotor Orange rotors Orange rotors Black rotors Black rotors M3 l A M4 M1 and M3 rotors are counter clockwise The direction of leading edge is counter clockwise see the following picture wi Tann edge M2 and M4 rotors are clockwise The direction of leading edge is clockwise see the following picture Leading edge Note The quad cannot fly if place the wrong rotors at the motors Please ensure the rotors of clockwise and counter clockwise are loaded accordingly 17 Prepa
3. use of other charger may cause the injury and damage to the people and property Step 1 Connect the power wire of the charger Connect the battery joint with the at the back of the charger 3S port on the charger gt Step 3 Step 4 Plug the other side of the power wire When finish the charging into the power socket there will be on the LED lights turn green Take out the three red LED lights It is the status of battery then you can enjoy the flight charging 6 Ms 4 Low voltage Protection of the Battery J Low voltage Protection has set in HMX280 system The default parameters are as following White Light White Light Class 1 Low voltage Protection 10 5V 10 8V When the voltage of the battery reach in this range the red rear decoration lights are flashing slowly which is reminding the low voltage Class 2 Low voltage Protection 9 6V 9 8V When the voltage of the battery reach in this range the quadcopter will land slowly in the position flying Please change the Red Light Red Light battery or charge for the battery REMINDER Please fly with the battery correctly Overcharging or over discharging the battery will cut down its service life _ 5 Install of Landing Gear E 5 1 Installation Procedure of the Landing Gear see the following Step1 Step2 Put the land gear on the groove of Fasten the landing gear with two screws the airframe please make left to the left side right
4. MX280 Its head is to the front and its tail is to the back The direction in which main body of HMX280 is facing up and its skids are facing down A UP front X 1 b D Q D L oe a a Se SER Pee ae Pes oS ee U w d down A back aans T weon uas T Ris Outrunner Motor 1300y nanes tris items in BNF version 65 Specifications Flying Weight 4g H H 2 Box of Contents Contents HiSKY MHX280 airframe 1350mAh 3S 11 1V 25C Li po Battery 3S 2S Li po Battery Charger Landing Gear Screws Charging Wire X 6S transmitter No this item in BNF version Bullet Head Landing Gear 4 EJ 3 Instruction for Charger im 3 1 Instruction for Charger Please ensure there is no heat emission curve transformation impale and damage before charging It is suitable for charging 3S 11 1V and 2S 7 4V Li ion batteries and Li po batteries 3 2 Charging Procedure see the following steps 1 Connect the charger to 220V AC power 2 Connect the charger wire 3 Take the battery from the battery bay in the airframe connect the balance joint of the battery with the 3S charging port on the charger 4 It is charging when the indication LED become red If the LED turn green the battery is full charged 5 Disconnect the battery with the charger when finished charging 6 The time to charge the battery full is 60 minutes Caution Only the designated Charger can be allowed to charge for HMX280 battery The
5. ansmitter then connect the battery of the quadcopter with the main board in 10s The light of signal will change from flash to ever green in 1 3s Then the binding succeeds 2 Fail to connect the battery in 10s please disconnect the battery turn off the transmitter and repeat the step above Trouble shooting a flashing receiver light after connecting the battery Possible causes Solutions Turn transmitter off and then on and Fail the binding reconnect the battery rebind The throttle stick of transmitter is Pull down the throttle stick to the not at the lowest position lowest position and rebinding The transmitter battery is low and Replace transmitter battery and empty rebinding The HMX280 battery is low and Replace the HMX280 battery and empty rebind No function of receiver and Replace receiver or transmitter and transmitter rebind 11 L 8 Selection of Flight mode SI 8 1 3 axis flight mode Pull down the fifth channel of the transmitter to the 3 axis flight mode In this mode the flight control system has no restriction to the flight poses and angles 8 2 6 axis flight mode Pull up the fifth channel of the transmitter to the 6 axis flight mode In this mode the flight control system auto correct the flight pose when the model out of control OA GYRO SENS 1V im 9 Flight Control Diagram i 9 1 Flight in Normal Status see left picture There is a GYRO SENS button a
6. blades of high main rotors and tail rotors G Protect from heat HMX280 quadcopter is made from metal fiber plastic and electronic components etc Please keep away from heat and sunshine in order to avoid distortion and damage caused by high temperatures F Age Recommendation Not for children under 14 years This is not a toy E Caution before Flight K A Ensure the battery packs both transmitter and receiver are fully charged B Ensure the throttle stick of your transmitter stay at the lowest position before operation C Please strictly obey the order of turn on and turn off before operation When starting your flight please turn on your transmitter first and connect the power cable of your HMX280 last When finishing your flight please disconnect the power cable of your HMX280 first and turn off your transmitter last Please cultivate a correct habit of turn on and turn off D Continuous shakes and fierce movement may cause the disconnect of the battery and result in the lose control of the model Please ensure the fastened connection of battery and motors before flight ir 1 Definition of Flight Direction El HiSKY defines the directions of HMX280 in order not to cause confusion in the following descriptions That is to say the tail of HMX280 is facing the pilot and its head facing forward front of the pilot The left hand of pilot is the left side of HMX280 while the right hand of pilot is the right side of H
7. ed Tapping screws 1 5 3 Tapping Screws 2 0 8 37 Tapping screws 1 5 5 board semi finished HMX280 battery hatch E 12 HMX280 Data Ports There are four ports at the bottom of the airframe see the above picture USB Port DSMX II satellite receiver port The four screw holes marked with white circles in the picture are left for gimbals 1
8. ep 4 Take out the battery of the quad 13 135 4 U 1 Ore N DSS NS RN N L o lt lt lt 22 TAA L N w Be oX S gt gt Oo Q G 2 Q x E r r E 14 10 1 Parts of HMX280 HMX280 left rear leg decoration light piece HMX280 semi finished red light HMX280 counter clockwise rotor black Counter clockwise motors with M4 caps za HMX280 Upper cover decoration mN piece s HMX280 Upper cover ey HMX280 left finger position 7 decoration piece Luminous diode white to white super bright N o HMX280 left rear light N 10 HMX280 right rear light a IES HMX280 clockwise rotor black EJ Tua Clockwise motors with M4 caps Eg HMX280 right finger position decoration pi HMX280 right rear leg decoratio light piece HMX280 left front leg decoration light piece 16 HMX280 clockwise rotor orange ra HMX280 left front light ca Luminous diode white to red super bright 19 HMX280 right front light ral HMX280 counter clockwise rotor orange HMX280 semi finished white light HMX280 rig front leg decoration light piece Sn Tapping screws 2 0 8 Le 24 HMX280 CC3D Main Board semi finished 16 Machine screws 2 0 5 HMX280 CC3D USB 27 semi finished XY1001 receiving board semi finished Machine screws 2 0 8 Tapping screws 2 0 8 HMX280 CC3D power socket semi finish
9. ration for flight and Unlock the motor 7 1 Mode choice of Transmitter 1 Please choose Fixed Wing Mode to fly the quadcopter with X 6S and H 6 transmitters 7 2 Steps of Flight 1 Install the battery Open the battery bay of the quad and place the battery into the battery bay 2 Pull the throttle stick of the transmitter to the lowest position and turn on the transmitter Connect the battery joint with that of the main board in the airframe and close the battery cover 3 Bind the model with the transmitter 4 After the binding the signal light will Bind the model with the transmitter and make sure the distance of them within 10cm Step 1 Step 2 connect the battery of the model with the main board turn on the transmitter first Step 3 Step 4 succeeding the binding the signal light You can fly the quad after close the battery on the airframe turn flash in green slowly back hatch Notice Please follow the order turn on the transmitter first and then connect the battery of the model 10 7 3 Unlock the motors 7 4 Lock the motors Push the aileron stick left side down for Push the aileron stick right side down for 2 3S and release then unlock the motors 2 3S and release then Lock the motors When lock the motors the green signal light will flash more slowly 7 5 Notice 1 Please follow the order turn on the transmitter first and then connect the battery of the model After turn on the tr
10. t the right up side of the transmitter which can switch between 0 and 1 0 is for 6 axis flight mode while 1 is for 3 axis oN ca Aileron throttle 1 When the stick of Aileron turn left 2 When the stick of throttle turn up or right the quad will turn left or right or down the quad will turn up or down accordingly accordingly 6 gals elevator 3 When the stick of rudder turn left or 4 When the stick of elevator turn up right the head of quad will turn left or or down the quad will be forward or right accordingly backward accordingly 12 9 2 Practice Flips HMX280 can do excited stunt actions such as forward and backward rolling right and left 1 Find a spacious ground with soft grass to practice 2 Select roll flight mode 3 axis mode 3 Itis advised the beginners increase the servo distance of ELEV and AILE of the transmitter to 100 110 It can be adjusted according to personal skill The default setting is 100 4 It is a must to practice with the throttle of the transmitter When the HMX280 quadcopter change from normal flight to stunt flight the throttle stick needs to pull down slowly When the model exchanges from stunt flight to normal the throttle stick needs to pull up accordingly Please adjust it according to personal skill S 10 End the flight ira Step 1 Push the aileron stick to the right side down Step 3 turn off the transmitter St
11. to the product people unexpectedly The pilot should operate the model ina safe manner and know the responsibility he she needs to take after if any failure of following the manner A Keep away from obstacles and people HMX280 quadcopter can fly at uncertain speed which poses potential dangers Please keep your HMX280 away from people high buildings high tension lines etc and avoid operating in rain storms thunder and lightening B Keep away from Humidity HMX280 should be kept away from humidity and vapor because its complex and precise electronic components and mechanical parts may be damaged C Proper operation and maintenance Please use HiSKY original parts to upgrade modify or maintain your HMX280 within the range or functions permitted It is forbidden to use it against of the safety laws or regulations D Avoid Flying alone At the beginning of learning about radio controlled flight there are some difficulties to overcome Please avoid flying alone Invite experienced pilots to guide you two of the most effective methods to practice are via a PC flight simulator and or under the supervision of a skilled pilot E Safe operation Please fly your HMX280 according to your physical status and flight skills Fatigue listlessness and mis operation will the increase the possibilities of accidental hazard F Away from highly spinning parts Please keep pilot people and objects away from the spinning
Download Pdf Manuals
Related Search
Related Contents
Manual de Instruções Audiovox GMRS100 User's Manual LineGuard 2300 Program - Welcome to Emerson Process PRORACER ZZ SpectrumWorx BENCH PILLAR DRILL TDM1022 Installation and Service Manual Chapter 05 Time Limits/Maintenance Checks SPT SO-337T Use and Care Manual Copyright © All rights reserved.
Failed to retrieve file