USER MANUAL OF THE PROGRAM CARD FOR
Contents
1. to the program card at the top right corner position marked with CG Usually a receiver battery pack is a good choice a Disconnect the power pack from the ESC b Disconnect the BEC cable of the ESC trio wires from your receiver then connect the BEC cable or the individual data cable Please refer to the following Note4 to the program card at the top right corner position marked with O U c Connect the additional battery pack to the program card at the top right corner d Connect the main power pack to the ESC e After several seconds the digit LEDs on the program card light to show the current programmable value of the ESC Note 3 The sequence of step b c and step d cannot be reversed Otherwise the program card cannot work properly Note 4 For ESC with an individual data cable that is a short trio wire just nearby the BEC cable of the ESC you need to connect the program card with this individual date cable while not the BEC cable Warning Do not use a battery pack more than 6V to supply the program card OPERATION Press the ITEM button to select the programmable items in a loop The serial number of the programmable items will be shown by 2 digit LEDs marked with TEM and the current value corresponding to the selected programmable item will be shown by another digit LED marked with VALUE Press the VALUE button to choose the parameter value you need After that press the OK2. User Manual Of The Program Card For Brushless ESC PROGRAM CARD FOR BRUSHLESS ESC FUNCTIONS AND FEATURES Thank you for purchasing the program card for the brushless ESC Electronic Speed Controller The program card has a friendly user interface so you can easily set the programmable parameters of the ESC with this device It is pocket sized so you can bring it to the racing or flying field conveniently Please refer to the user manual of the ESC for detail information about each programmable item SPECIFICATION 1 Size 88mm 58mm 14mm 2 Wight 40g WIRING SEQUENCE When you are using an ESC with a built in BEC Battery Elimination Circuit a Disconnect the power pack from the ESC b Disconnect the BEC cable of the ESC trio wires from your receiver then connect it to the program card at the top right corner position marked with OSSU c Connect the main power pack to the ESC d After several seconds the digit LEDs on the program card light to show the current programmable value of the ESC Note 1 The sequence of step b and step c cannot be reversed Otherwise the program card cannot work properly Note 2 It takes several seconds for program card to communicate with speed controller before the LEDs lights please wait patiently 1 When you are using an ESC without a built in BEC If the ESC hasn t a built in BEC you must use an additional battery pack 4 8V 6V to power the program card Please connect the battery
3. button a bright symbol appears in the middle position of the digit LED marked with VALUE for about 1 2 seconds that means the new setting is accepted and stored in the ESC The RESET button is used for restoring all the items of the ESC to the default vales DECLARATION The program card is ONLY suitable for the ESC made by the same manufacturer
Download Pdf Manuals
Related Search