KEYPAD ELECTRONIC DEADBOLT INSTALLATION INSTRUCTIONS
Contents
1. PL3 PL3 KEYPAD ELECTRONIC DEADBOLT INSTALLATION INSTRUCTIONS The BACKSET is the distance between the center of cross bore and edge bore of the door Adjustable latch fits both BACKSET of 2 3 8 60mm and 2 3 4 70mm Please follow the steps shown below for BACKSET adjustment Latch Backset Adjustment Rotate the latch case as diagram on the right for backset 2 3 4 70mm or reverse direction for 2 3 8 60mm N A 1 MARK THE DOOR WITH TEMPLATE 2 DRILL HOLES Select the height and backset as Using the marks as a guide to drill a desired on the door face use the hole 2 1 8 54mm through the door TEMPLATE as an indication to face for the lockset then a hole of 1 mark the center of the circle on 25 4mm for latch the door face and the center of the door edge 4 INSTALL STRIKE M a Insert the latch and ensure it is paralleled to the door face Mark the outline of the faceplate then take out the latch a To identify the center of strike close the door on the basis of the faceplate mark horizontal center line of strike Ensure the center of faceplate and the center of strike are aligned Use the mark as a guide outlines the strike b Chisel 5 64 2mm deep along the strike outline to allow the strike to be aligned with the doorframe b Chisel 1 8 3mm deep along the outline to allow the faceplate to be aligned with the door edge c2. Insert the strike and tighten it with screws Note please use tapping screws for metal door c Insert the latch and tighten it with screws Note please use tapping screws for metal door 5 Install Keypad Assembly a Ensure the latch bolt must be b Please refer to the diagram below for Cylinder Installation c Pass the IC wire under the latch to the retracted Place deadbolt against keypad with tailpiece in horizontal interior side of the door position inserted through hub of the latch Cylinder PL3 PL3 PL3 6 Install Inside Mounting Plate Pass the IC wire through the wire hole of the mounting plate Fix the mounting plate with screws If outside lock assembly is lopsided please loosen the screws to adjust it s position and tighten the screws again Mounting Plate Screws SIOK 7 Identify Door Handing Face the door from outside the door is left handed if the hinge is on the left hand side of the door whereas the door is right handed if the hinge is on the right hand side of the door Interior ON t EEE Door Left Handed Exterior Right Handed 8 Adjusting Turn Piece Turn the turn piece to left for 45 degrees when it s right handed door Turn the turn piece to right for 45 degrees when it s left handed door Turn Piece For Right Handed door For Left Handed door PL3 9 Install rec
3. eiver module a Remove the battery cover push it up and pull it out Battery Cover b Connect the IC wire and ensure the tailpiece is engaged with turn piece then attach receiver module to the door with screws It s optional to use wood screws Wood screws only for wood door S SA c Insert 4 AA 1 5V alkaline batteries and put the battery cover back to the receiver module Please refer to the User Manual for function setting TEMPLATE 54mm 2 1 8 FOR BACKSET 70mm 2 3 4 Fit here on door edge Z Yi FOR BACKSET 60mm 2 3 8 Tt 45 40 35 1 3 4 1 9 16 1 3 8 51 p Mark 1 25 4mm hole at center of door edge PL3 Lockeyusa P O Box 543 Mt Pleasat MI 48858 www lockeyusa com
Download Pdf Manuals
Related Search