di-GPS USB User Guide v1.00 - di
Contents
1. States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Warning Precaution for Use e Keep out of reach of children This device contains small parts which may pose a choking hazard Consult a physician immediately if a child swallows any part of this device e Under no circumstances should you attempt to disassemble the product and repair it yourself Doing so may result in electric shock or product malfunction Should the product break open as the result of a fall or other accident send the unit to Dawn Technology Limited service for inspection For more information please visit our web site at www di gps com e Do not handle with wet hands or immerse in or expose to water or rain Failure to observe this precaution could result in fire or electric shock e Do not use in the presence of flammable gas Failure to observe this precaution could result in explosion or fire Do not expose to flame or excessive heat e Do not expose to high temperatures e Do not leave the device in a closed vehicle under the sun or in other areas subject to extremely high temperatures Failure to observe this precaution could result in fire or in damage to the casing or internal parts e Disconnect the GPS device immediately in the event of malfunction Should you notice smoke or an unusual smell coming from this device remove the 10 pins connector immediately and send the unit2. press lt set gt Select Connect Select OK then press lt set gt Connecting to USB device will display a few second USB device is connected then press lt set gt 7 The Green LED on the WFT unit will start to blinking The Green LED will stop blinking once GPS signal has been established and the receiver is ready to supply the current position di GPS USB will automatically to start receive satellites signal when connecting to the camera The di GPS use the power from the WFT unit Please disconnect the di GPS USB when not in use to save power Please following step to disconnect the GPS device Under thel Tab INEF Select WFT settings Select USB device connec GPS Select Disconnect Select OK then press lt set gt Disconnecting USB device will display a few second e USB device is disconnected then press lt set gt Disconnect the di GPS USB from the WFT USB terminal Each satellite broadcasts a digital message that contains two types of information One type is ephemeris data which includes the assigned serial number of the satellite the status of the satellite healthy or faulty the current Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 date and time The second type is almanac data and includes precise orbital p
3. to Dawn Technology Limited service for inspection For more information please visit our web site at www di gps com Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Mounting The di GPS USB receiver provides two mounting method The GPS unit can be mounted on the flash accessory shoe or attached to the camera strap di GPS USB Mounted on the flash accessory shoe di GPS USB attached to the camera strap Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Connect a di GPS USB The di GPS USB must work with Canon WFT E3 40D or WFT E2 1D Ds Mark III Connect the DSLR camera and di GPS USB as described below 1 Turn off the camera 2 Remove the Cap from the US terminal on the WFT unit 3 Connect the di GPS USB to the WFT USB terminal Do not use any extension cord 4 Turn the camera on 5 If the di GPS USB is properly connected the LED on top of the GPS unit will light up The GPS receiver will start to searching for a GPS signal 6 Setup and connect the GPS unit e Under thell Tab skok ai Sh j Select WFT settings Select USB device connec Select Category Select GPS then
4. B LED Flashing Not fixed Signal searching Green USB LED On Position fixed Current location information will be recorded in the image files LED on the di GPS USB will only represent the status of di GPS USB but not the reception of GPS data to the DSLR camera GPS data are only recorded when the Green USB LED displayed in the WFT unit Please make sure that the Green USB LED is On before shooting Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Specifications General Chipset Atmel ANTARIS TM 4 SuperSense Frequency L1 1575 42 MHz C A code 1 023 MHz chip rate Channels 16 channel all in view tracking Sensitivity Cold Starts 142 dBm Reacquisition 148 dBm Tracking amp Acquisition 158 dBm Accuracy Open Sky 2 5 meters CEP 2 0 meters CEP WAAS EGNOS enabled Time 5us synchronized to GPS time Datum WGS 84 Acquisition Time Open sky stationary requirements Reacquisition lt 1 sec average Hot start 3 5 sec average Warm start 33 sec average Cold start 64 sec average Dynamic Conditions Altitude 18 000 meters 60 000 feet max Velocity 515 meters second 1000 knots max Power 5V Supply from USB port of WFT E3 WFT E2 Power consumption less than 40mA Protocol Direct connect to C DSLR via WFT E3 WFT E2 USB port Output message N
5. MEA 0183 Interface USB V1 1 V2 0 compatible Physical Characteristics Dimension 50mm 32mm 13mm Weight 30g Operating Temperature 10 to 45 Degrees Celsius Operating Humidity 5 to 85 No Condensing Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Specifications are subject to change without any notice Warranty e Dawn Technology Limited guarantees its product which is determined to be defective or faulty materials and workmanship for a period of one year after the date of purchase During the one year warranty Dawn Technology will repair or replace the product free of charges Please keep your original invoice as proof of purchase e Customers who have products covered under the warranty are required to contact Dawn Technology Limited by e mail for troubleshooting issues before returning product e Customer should responsible for shipping and insurance charges for returning the product to Dawn Technology Limited e Charges will be imposed for repair product which is out of warranty coverage or invalid warranty e The guarantee is not valid if defect is due to damage caused by incorrect use poor maintenance or if alterations or repairs have been carried out by persons not authorized by Dawn Technology Limited e For the device to be used correctly the use
6. di GPS USB digital images GPS Users Guide Ver 1 00 Please visit our website www di gps com for the latest version of the user guide Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Introduction Thank you for purchasing the di GPS USB Receiver The di GPS USB digital images GPS is specially designed for Canon EOS DSLR Digital Single lens reflex camera It provides real time position latitude longitude elevation and the precise time UTM time information to your DSLR camera It records the locations to each digital image file so that you would never forget the exact location where you took the pictures di GPS USB allows you to save your present location data to your digital image file Its State Of The Art technology provides extremely fast TTFF Time To First Fix unrivaled high sensitive and superior performance at virtually any outdoor environments The di GPS USB can work in a place where GPS was not possible before in the woods under very heavy foliage canyon terrain obstructions in cities with densely populated high rise buildings and even inside a train or a car with no external antenna required It is designed to meet the rigorous demands of today s digital photographers Canon and EOS are registered trademark or a trademark of Canon Inc in the United
7. osition of every satellite in the system At the initialize stage di GPS USB needs all these data for the position fixed It usually takes a minute to few minutes to receive all data An open sky outdoor environment will enable faster acquisition process It will take a longer time at a weak signal environment Once di GPS USB locked to the satellites it will take a few seconds for reacquisition even at weak signal environment Note e Please refer to user manual of your DSLR for more information on taking photographs with a GPS e Do not carry the camera by the di GPS USB or subject the camera or cord to physical shocks while the cord is connected Failure to observe this precaution could result in physical damage of the cord e Re place the caps on the WFT unit when the terminals are not in use Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00 Status LED indicator for di GPS USB fix or not fix LED OFF WET unit not connected or USB device setting not correct or USB device disabled in the WFT menu LED ON No fixed Signal searching LED Flashing Position Fixed Green USB LED on the WFT unit indicator for di GPS fix or not fix Green USB LED Off di GPS USB not connected to WFT unit or USB device setting not correct or USB device disabled in the WFT menu Green US
8. r should strictly adhere to all instructions included in the user guide and should abstain from any actions or uses that are described as undesired or which are warned against in the user guide Information in this document is subject to change without notice Dawn Technology Limited reserves the right to change or improve their products and to make changes in the content without obligation to notify any person or organization of such changes or improvements Canon and EOS are registered trademark or a trademark of Canon Inc in the United States and or other countries Products and brand names are trademarks or registered trademarks of their respective companies V1 00
Download Pdf Manuals
Related Search