USER MANUAL - Reliable Corporation
Contents
1. ND 52 RELIABLE PANTMAN USER MANUAL Model F1 IMPORTANT SAFEGUARDS When using an electric appliance basic precautions should always be followed including the following WARNING DANGER OF SCORCHING Read all instructions before using this pant press to reduce the risk of fire electric shock or injury This product is designed for domestic use only Do not use outdoors Do not leave your pant press unattended while switched on Turn off the switch and unplug the electrical cord when not in use To unplug grasp the plug not the cord Do not allow to be used as a toy Close attention is necessary when used near children pets or plants The appliance is not intended for use by any children or infirm persons without supervision Children should be supervised to ensure that they do not play with the appliance Do not immerse the pant press into water or other liquids Do not use with damaged cord or plug If unit is not working as it should has been dropped damaged left outdoors or immersed into liquid contact a licensed service technician for assistance Do not pull or carry by cord use cord as a handle close a door on the cord or pull cord around sharp edges or corners Keep cord away from heated surfaces Do not use extension cords or outlets with inadequate current carrying capacity Do not handle or use this unit while hands are wet Use only as described in this manual O2. nctioning Unit is not plugged in Plug into electric socket Unit fails to heat up The press board has Immediately stop use been damaged or is and let the unit cool malfunctioning down completely Contact a licensed technician NP E WN RELIABLE Reliable Corporation 5 100 Wingold Avenue Toronto Ontario Canada M6B 4K7 www reliablecorporation com P 416 785 0200 F 416 785 7038 TF 800 268 1649 sales reliablecorporation com
3. of the front pressing plate with the side seam as indicated in Figure 3 aligned with the groove in the padding figure not shown in the front pressing plate C To close the front pressing plate 1 Pull the press board bar to the 2 step 1 step is for thick trousers or pants 2 Hold the waistline of the pants and gently pull upwards This will smooth out any wrinkles and ensure that pants or trousers are lying flat between the front pressing plate and press board 3 Pull the press board bar down firmly until the front pressing plate is fully locked into the closed position Pull the pants upwards once again D Plug the cord into the power socket The power indicator light will illu minate and the press will start automatically E The press will automatically shut off when the job is completed and the power indicator light will also go off To restart the pressing press the button the power indicator light will illuminate again and start the pressing cycle TROUBLESHOOTING GUIDE Below is a chart detailing the most common problems their causes and solutions Prior to troubleshooting isolate the unit by removing the cord from the power socket PROBLEM CAUSE SOLUTION Plug into electric socket and make sure the power indicator light is on Please contact a licensed technician Unit is not plugged in Unit fails to operate properly Unit is damaged or malfu
4. perating unit in any way other than recommended may result in damage to unit or injury to operator Do not disassemble unit or attempt to make any repairs yourself Incorrect assembly or repair could result in a risk of fire electric shock or injury to persons when operating store your pant press in a cool dry place Allow unit to cool completely and loop power cord loosely around unit before storing SAVE THESE INSTRUCTIONS F1 pant press product information Power Indicator Light On Button Placement for watch keys etc Safety chain Press board bar Press board Front pressing plate Foot Cord wrap Cord Plug Awe Ono OF ASSEMBLY INSTRUCTIONS Accessories EN Screw A Attach the support to the foot B Insert the attached screws into each hole in foot and tighten them securely with screwdriver Support OPERATING INSTRUCTIONS A To open the front pressing plate Pull the press board bar to open the front pressing plate slowly The press board bar will hold the front pressing plate in an open position B How to insert the pants Place the cuffs or bottoms of legs of trousers or pants as far down as possible between the front pressing plate and the press board The waistline of the pants should be hung over the top edge of the front pressing plate 2 Tidy up the slack of pants 3 Make sure to place the pants in the middle
Download Pdf Manuals
Related Search