Suhr Jack Rabbit User Guide Final 10/30.key
Contents
1. lt 20mA 25 50 hours continuous use 2 50 Width x 4 50 Depth x 1 25 Height 0 75 pound 1 8 stereo 3 3Vdc Activate on off External Tap Yes N A WARRANTY FOR SUHR AMPLIFIERS AND ELECTRONIC PRODUCTS SUHR COM JST warrants for lifetime from date of purchase by the initial retail purchaser that this product shall be free from defects in workmanship Electronic components such as capacitors resistors filters transformers jacks and pots are covered for 5 years Any parts determined defective by JST within the five 5 year term shall be repaired or replaced by JST without charge for parts and labor provided the unit is returned transportation costs prepaid to JS Technologies Inc 601 Crane Street Unit A Lake Elsinore CA 92530 or to such facility authorized by JST JST will pay shipping costs to return the unit to its owner Defects in workmanship will be determined by JST for limited lifetime coverage This warranty does not cover damage caused by accident misuse abuse neglect unauthorized or improperly performed repairs alterations and or wear and tear occasioned by use of the product and does not include any expense for inconvenience or loss of use while the product is being repaired or replaced JST expressly disclaims any liability for consequential damaged arising from the sale use or inability to use the product Any warranty implied by law including any warranty of merchantability or fitness is expres2. modulation rate tap the footswitch three times to mark the beginning and end of the modulation rate The first footswitch press will turn off the LED Should only one press be detected within the minimum 1 second period the LED will begin to flash at the current rate indicating that a new sequence is ready The rate will only be updated once the second switch press is detected within the 1 second period Strum Tempo Mode Strum tempo works the same as Tap tempo except that instead of using your foot you simply strum the guitar Ensure that there is sufficient level from your guitar in order for the signal detector to work properly The same requirements must be met for Strum tempo three strums must be detected to mark the beginning and end of the modulation rate Jack Rabbit Boost The Jack Rabbit can be used as a boost pedal simply by setting the Depth control fully counter clockwise Set the desired boost with the Level control Activate the boost by turning the pedal on Rate Depth Waveform Level Subdivision FX Link True Bvpass LED Set the Rate control for the desired modulation rate from 1Hz to 20Hz Set the Depth control from 0 to 100 for the desired amount of the effect Select a modulation waveform Square Wave Sine Wave Triangle Wave Reverse Ramp or Ramp Set the desired output level Set the 3 position switch to subdivide the tempo into quarter notes eighth notes o
3. Jack Rabbit gt USER GUIDE Jack Rabbit Thank vou for purchasing the Suhr Jack Rabbit Tremolo Pedal Please take the time to read this manual to get the most out of vour pedal The more vou familiarize vourself with the features of this pedal the more vou will enjov its benefits and maximize its potential OVERVIEW Jack Rabbit is a high qualitv analog pedal that delivers a wide varietv of tremolo effects from warm wobble to whacked out It features simple control over tempo by incorporating both tap and strum tempo modes It s modulation rate spans from 1Hz to 20Hz and utilizes a tempo subdivision switch The Jack Rabbit Tremolo is housed in a sturdy aluminum enclosure for maximum protection from abuse It can be remote controlled via the FX Link jack The Jack Rabbit Tremolo is True Bypass and can be powered from 9 18Vdc drawing low current for extended battery life It is protected from both over voltage and reverse voltage TEMPO SUBDIVISION SWITCH Jack Rabbit features quarter note eighth note and quarter note triplet subdivisions CONTROLS Jack Rabbit features an easy to tweak layout which includes Rate Level Waveform and Depth controls Rate Controls the speed of the tremolo effect from 1Hz to 20Hz Level Controls the output level of the pedal from 0dB to 14dB Note in normal mode with the Depth knob set to zero Jack Rabbit becomes a boost pedal In bypass mode boost is off Depth Control
4. cted to the jack If the FX Link jack is not utilized Jack Rabbit will power up in the OFF state Left Jack Rabbit will power up in the OFF state Battery Monitor Upon powering up the pedal the battery voltage is measured If the voltage is at a low voltage 4 5V the LED will flash 3 times to alert the user Normal operation will then resume Should the battery fail completely lt 4V the Jack Rabbit Tremolo will switch to true bypass mode and the LED will begin to flash This will ensure that the signal continues uninterrupted and undistorted Should the LED flash become too annoying press the foot switch to turn it off It s time to replace the battery Vintage Tube Tremolo Vintage style tremolo inspired by the best tube tremolo circuits of the 1960 s Jack Rabbit SAMPLE SETTINGS Stutter An on off tremolo that ranges from slow choppy stutter to helicopter whirl Jack Rabbit Backwards Psychedelic swells give your playing a reverse feel NA NI ih SA Jack Rabbit SPECIFICATIONS Input Impedance Output Impedance Power Connector Operating Voltage Maximum Voltage Reverse Batterv Protection Over Voltage Protection Current Consumption Estimated Batterv Life Dimensions Weight FxLink Connector FxLink max Voltage Shield Tip Shield Ring ROHS Compliant Agency Approvals 1M ohm 600 ohm 9Vdc center negative 2 1mm x 5 5mm 5V to 18V nominal 9V 20Vdc yes yes
5. r quarter note triplets If an external cable is plugged in the pedal will power up into the state dictated by the FX Link jack Note If external control is desired the switch MUST be set to the center position To have the effect engaged at power up set the slide switch toward the Power jack To have the effect off at power up set the slide switch toward the FX Link jack True bypass can be defeated allowing the pedal to be used as a buffer by switching the internal True Bypass switch Remove the cover and set the switch located between the 1 4 jacks Note the nomenclature printed on the circuit board True Bypass TBYP is toward the input jack whereas Buffered BUF mode is toward the output jack In normal operating mode the LED color is green When Tap Tempo is selected the LED color will be orange In Strum Tempo mode the LED color will be red LEFT CENTER RIGHT U E FX Link Switch Position EXCLUSIVE FEATURES True Bvpass True Bvpass via a relav FX Link The FX Link can be utilized to remotely control the pedal Shorting between the shield and the tip will activate the pedal Opening the connection will turn off the pedal The shield to ring connection is used to sense an external tap switch Right Jack Rabbit will power up in the ON state Center Jack Rabbit can be switched remotely via the FX Link jack In this position Jack Rabbit s state will be dictated by the status of foot switch conne
6. s the depth of the tremolo effect Waveform Selects the modulation waveform which includes Sine Square Triangle Reverse Ramp and Ramp OPERATION Install a 9V battery in the unit see below or plug in a suitable 9Vdc center negative power supplv Plug vour guitar into the input jack and connect vour amp to the output jack Note as in virtuallv all pedals connecting a cable to the input jack will also power up the pedal If using the internal battery remember to unplug your cable from the input jack when you are done playing in order to insure a long battery life Tap the footswitch to engage the Jack Rabbit The LED will flash at the current tempo Tempo Modes To activate either Tap Tempo or Strum Tempo mode press and hold the footswtich for 2 seconds The LED will change color to indicate the tempo mode During Tempo mode the rate control will not affect the modulation rate Rather it can be used to change the Tempo mode to from Tap Tempo and Strum Tempo To switch the Tempo mode press and hold the footswitch while turning the Rate control Turning clockwise will activate Strum Tempo whereas turning counter clockwise will activate Tap Tempo The Subdivision switch is active in either tempo mode To return to normal mode press and hold the footswtich for 2 seconds When returning to normal mode the Rate control will be active again allowing the user to override the Tap or Strum tempo setting Tap Tempo Mode To set the
7. sly limited to the one 5 year warranty term for the parts on our amplifiers and electronic products The foregoing statements of warranty are exclusive and in lieu of all other remedies Workmanship lifetime warranty is limited strictly to the original retailer purchaser of the instrument registered with JST within 10 days of purchase from an authorized JST dealer or distributor JST will pay shipping costs to return the unit to its owner within the mainland U S The above warranty policy only applies to customers in USA If you are an international customer please check with your distributor and the dealer in your country for warranty matters Warranty issues must be handled through your dealer or distributor If you are an international customer who purchased or plan to purchase from a US dealer we can handle warranty matters direct but you will be responsible for shipping both ways We encourage international customers to purchase through your local distributor or dealer for this reason Our international distributors are set up to handle warranty issues in their respective countries If you do not have an authorized Suhr dealer in your country please contact us direct for further details Rev 10 30 12
Download Pdf Manuals
Related Search