Home

GlowShift Instructions

image

Contents

1. INSTALLATION INSTRUCTIONS asd GL UNE PERFORMANCE GAUGES amp PODS TechSupportogionshifteaages com 7 Color Series 35 PSI 60 PSI 100 PSI Boost Gauge For Product Numbers GS C701_35 GS T701_35 GS W701_35 GS C701_60 GS T701_60 GS W701_60 GS C701_100 GS T701_100 GS W701_100 1 4 lt 1 1 2 gt 2 3 16 NN Color Change Button lt 2 1 16 or 52 MM gt Intake Manifold Wire Color Code Yellow 12v Constant unswitched Source Black Vehicle Ground Red 12v switched Source Orange 12v Dimmer switched Source optional 1 Disconnect the negative battery cable Gauge Installation 2 Connect the boost line to the gauge using the female compression fitting Once this is connected run the boost line through the firewall and to your intake manifold e Note Make sure the boost line is not pinched the use of a rubber grommet through the firewall is required 3 Drill and tap your intake manifold to 1 8 27 NPT Next connect the included male compression fitting which is attached to the boost line to the tapped 1 8 27 NPT hole you just drilled in your intake manifold e Note After drilling and tapping your intake manifold be sure to use vacuum and pen magnet to safely remove all shavings from the manifold You may also remove the top of your intake manifold before drilling for extra protection against drill shavings e Note Ifyou are installing this g
2. whichever is greater GlowShift does not provide a warranty on replacement gauge sensors INSTALLATION INSTRUCTIONS z Tech Support 856 768 8 PERFORMANCE GAUGES amp PODS TechSuppertOuiowshifiGanges com 2 EXCLUSIVE REMEDY ACCEPTANCE Purchaser s exclusive remedy and GlowShift s sole obligation is to supply or pay for all labor necessary to repair any Product found to be defective within the repair or replacement fails to remedy the defect Purchaser s failure to make a claim as provided in paragraph above or continued use of the Product shall constitute an unqualified acceptance of such Product and a waiver by Purchaser of all claims thereto 3 EXCEPTIONS TO LIMITED WARRANTY GlowShift shall have no obligation to Purchaser with respect to any Product that is subjected to any of the following abuse improper use negligence accident modification failure to follow the operating procedures outlined in the user s manual failure to follow the maintenance procedures in the service manual for the Product attempted repair by non qualified personnel operation of the Product outside of the published environmental and electrical parameters or if the Product s original identification trademark serial number markings have been defaced altered or removed GlowShift excludes from warranty coverage Products sold AS IS and or WITH ALL FAULTS GlowShift also excludes from warranty coverage any consumable items such as fuses and batteries All s
3. N REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER GOVERNING LAW This non transferrable limited warranty shall be governed by the law of the State of New Jersey U S A and the United States of America excluding their conflicts of laws principles The courts of Camden County New Jersey shall have the exclusive jurisdiction over any legal action with respect to this warranty This limited warranty gives specific legal rights You may also have other rights that may vary from state to state or from country to country Some states or countries do not allow the exclusion or limitation of incidental or consequential damages so the above limitations and exclusions may not apply to you You are advised to consult applicable state or country laws for a full determination of rights
4. auge into a Dodge Ram model years 98 to 07 5 you can install a boost bolt directly to your intake manifold Installing this boost bolt does not require any drilling or tapping and can be purchased at www GlowShift com Connecting the Power Wire Harness 4 To make the wiring of your gauges easier you can purchase an expandable circuit This component easily fits into your fuse panel and provides an additional fused power wire for accessories such as gauges The expandable circuit is available for purchase at www GlowSshift com 5 Using automotive grade wiring 18 gauge connect the yellow wire to a positive 12 volt constant un switched source either on the vehicle or in the fuse box e Note If you are connecting the yellow wire directly to the battery you MUST install a 3 amp fuse within 6 8 inches of the battery connection 6 Using automotive grade wiring 18 gauge connect the red wire to a positive 12 volt ignition switched source It may be connected to the fuse panel an accessory wire or any positive 12 volt source that turns on and off with the ignition 7 Using automotive grade wiring 18 gauge connect the black wire to any good unpainted ground connection You may also route a wire directly to the negative side of the vehicle s battery 8 The Night Time Dimming feature decreases the brightness of the gauge face by 30 Connect the orange wire to the 12 volt positive headlamp source This allows the mode to be ac
5. e 1 year from the purchase date For a period of one 1 year from the date of purchase at no charge to the Purchaser GlowShift will repair or replace this Product if it is determined by GlowShift to be defective After the warranty period the Purchaser must pay all charges for parts and labor Coverage under this warranty is only valid within the United States including its territories as well as in certain other countries Purchasers should check our website www GlowShift com to determine the warranty coverage in the countries in which they are located GlowShift does not warrant the installation of the Product which is the sole responsibility of the Purchaser Installation should be done by licensed professionals Improper installation may cause damage to the Product and any vehicle in which it is installed and may cause burns and electrical injury to individuals GlowShift s warranty does not cover any expenses incurred in removing Products that are defective or re installing replacement Products in their place During the warranty period to have the Product repaired or replaced the Purchaser must return the Product freight prepaid by the Purchaser to GlowShift but for customers in the contiguous United States GlowShift will pay the shipping charges if any Product fails during the first thirty 30 days after purchase The Product must be returned in its original carton or in a similar package affording an equal degree of protec
6. ine to your GlowShift engine monitoring instruments Never use wire nuts to fasten or bound vehicle gauge or sensor wiring Always use securing crimp connectors or solder individual wire junctions together for optimum gauge installation and operation e GlowShift Gauges Approved Installation Accessories GlowShift Gauges may require the installer or user to provide additional products accessories or adapters for the correct installation and operation of a gauge or sensor as per the GlowShift Installation Instructions When installing and routing hoses to or from the engine compartment to inside the vehicle cabin always employ the use of a rubber grommet This will prevent and deter the stretching or pinching of hoses that is necessary to deliver vital statistics about your engine to your GlowShift engine monitoring instruments e GlowShift Gauges Installation Instructions Installation documents are solely to provide a guide for individuals that are mechanically and electronically able to install products If you are unsure about the correct procedure of installation for a product or device you should consult a professional mechanic or an Authorized GlowShift Installer ONE YEAR NON TRANSFERRABLE LIMITED WARRANTY AND DISCLAIMER GlowShift Gauges LLC GlowShift warrants to the original retail consumer purchaser and not any other purchaser or subsequent owner that this Product will be free from defects in material or workmanship for a period of on
7. oftware and accompanying documentation furnished with or as part of the Product is furnished AS IS i e without any warranty of any kind except where expressly provided otherwise in any documentation or license agreement furnished with the Product 4 PROOF OF PURCHASE REGISTRATION The Purchaser s dated bill of sale must be retained as evidence of the date of purchase and to establish warranty eligibility Registration of any Product or of this limited warranty is voluntary and failure to register will not diminish any rights available under this warranty DISCLAIMER OF WARRANTY EXCEPT FOR THE FOREGOING WARRANTIES GLOWSHIFT HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2 312 3 OF THE UNIFORM COMMERCIAL CODE OR IN ANY OTHER STATE STATUTE LIMITATION OF LIABILITY THE LIABILITY OF GLOWSHIFT IF ANY AND PURCHASER S SOLE AND EXCLUSIVE REMEDY FOR DAMAGES FOR ANY CLAIM OF ANY KIND WHATSOEVER REGARDLESS OF THE LEGAL THEORY AND WHETHER ARISING IN TORT OR CONTRACT SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT FOR WHICH SUCH CLAIM IS MADE IN NO EVENT SHALL GLOWSHIFT BE LIABLE TO PURCHASER FOR ANY SPECIAL INDIRECT INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING BUT NOT LIMITED TO COMPENSATIO
8. tion GlowShift will return the repaired or replaced Product freight prepaid to the Purchaser GlowShift does not provide Purchasers with temporary replacement units during the warranty period or at any other time This limited warranty is non transferrable and will automatically terminate if the original retail consumer purchaser resells the Product or transfers the vehicle in which the Product is installed An original retail consumer purchaser is a person who originally purchases the Product or a gift recipient of a new Product that is in its original packaging and unopened This limited warranty is subject to all of the following terms and conditions TERMS AND CONDITIONS 1 NOTIFICATION OF CLAIMS WARRANTY SERVICE If Purchaser believes that a Product is defective in material or workmanship written notice with an explanation of the claim shall be given promptly by Purchaser to GlowShift All warranty claims must be made within the warranty period and any Products returned to GlowShift must be shipped in accordance with GlowShift s procedures including use of RMA numbers supplied by GlowShift after notification The repair or replacement of any Product or part thereof shall not extend the original warranty period The specific warranty on the repaired part only not including gauge sensors shall be in effect for a period of ninety 90 days following the repair or replacement of that part or the remaining period of the Product warranty
9. tivated when the headlights come on This step is optional and will not affect operation of the gauge if it is omitted e Note Do not connect the orange wire to a dimmer wheel This will cause the gauge lighting to flicker 9 Reconnect the vehicle s negative battery cable e If your gauge s do not illuminate or do not recall your last saved color your switched and un switched sources are reversed e If your gauge s only illuminate red then the yellow wire for constant source is not connected properly e Be sure all of your wiring is correct to ensure proper gauge operation INSTALLATION INSTRUCTIONS Tech Suppor 856 768 8300 EXT 2 PERFORMANCE GAUGES amp PODS TechSupport GlowShiftGauges com Additional Installation Information amp Material Requirements e GlowShift Gauges Approved Conductor Wires Successfully installing GlowShift Gauges may require lengths of wire sizes and quantity depend on vehicle gauge type gauge location and or sensor location For correct and proper GlowShift Gauge installation and operation the use of 18 Gauge wire diameter automotive grade conductor wire with sheathing is recommended for one or more gauges per vehicle When installing and routing wires from the engine compartment to inside the vehicle cabin always employ the use of a rubber grommet This will prevent and deter the stripping of power supply and or sensor wires that is necessary to deliver vital statistics about your eng

Download Pdf Manuals

image

Related Search

Related Contents

KADIAS データ解析処理説明書  Photini Documentation  November Svc Bulletin.qxd  取扱説明書 フューエルゲート パネル ご使用前に必ずご確認ください    アルミグリップエンド 取扱説明書  T'nB ACGP03495 holder  Baldwin 4706.150.BIN Installation Guide  HT20 - Manual - General Tools And Instruments  Rexel Economy L Folders  

Copyright © All rights reserved.
Failed to retrieve file