User Manual
Contents
1. User Manual 1S DC DC BOOSTER HW SM815DUL 20140320 Introduction 1S DC DC BOOSTER is a DC DC power booster module which can draw power rom the 1S Lipo battery then boosts it to the voltage level 6V suits the receiver amp servo and provides the continuous output current up to 3Amp It is mainly applied in 1 12th scale RC vehicles he 1 12th scale car usually uses 1S Lipo battery and BEC in ordinary speed controller is step down In that case the BEC output voltage will be lower than 4 2V that cannot meet the power demand of the receiver amp servo herefore 1 12th scale car has to run with purpose built 1S ESC with the built in DC DC booster or external receiver battery connected if the speed controller asn t the built in DC DC booster However things will be different after adopted this booster Then the receiver batteries can be abandoned and users can be free rom charging and maintaining the receiver batteries Input Voltage 1S Lipo or 3 4 Cell NiMH Output Voltage 6V Output Current Continuous 3A Burst 6A Dimension 28 0mm x 26 8mm x 11 8mm L x W x H Weight 10 2g Wiring Diagram To Receiver Connect to Battery 1 When the ESC Electronic Speed Controller has the built in BEC function Users need to cut off the internal BEC output first that is to disconnect the red wire between the speed controller and receiver as shown in the picture below then connect the positive amp negative poles of the2. input end of the 1S DC DC BOOSTER with the positive amp negative poles of the battery and plug the output end of the booster into any unoccupied channel of the receiver at last i E Recommendation Please use a little tapering screwdriver to remove the red wire in the middle from the connector and insulate it well for future use If want to restore the built in BEC function you only need to reinsert E it into the slot 2 When the ESC Electronic Speed Controller has no built in BEC function Then no need to make any change to the ESC except connecting the positive amp negative poles of the input end of the 1S DC DC BOOSTER with the positive amp negative poles of the battery and insert the output end of the booster into any unoccupied channel of the receiver
Download Pdf Manuals
Related Search