Manual click here
Contents
1. SpatJoy Important Considerations Electrical Service A 110V 60HZ 15AMP GFCI protected ground must be used to supply power to each indivisual pedicure spa And the main circuit breaker MUST be at 25AMP for maximum of two unit Water Supply All plumbing connections must conform to local codes Water supply to the spa should be provided with adequate water pressure and water temperature Water pressure To fill the basin correctly up to level Normal water pressure should be between 30 to 80 P S I Water temperature The hot water supply temperature must not exceed 140 Adjust your hot water accordingly For hot and cold water supply fittings and drain fittings location see below diagram Carefully connect the water supply line to the appropriate fittings located on the rear of the pedicure spa Backflow Preventive Device All pedicure spas are pre installed with Dual Back flow Preventive Device for the following state CA AZ NV OR WA and NE This Device is optional therefore yot need to order seperately Salontech does not guarantee the quality of this device Specification Backflow preventive device for faucet Vacuum breaker comply with ANSI NSF 61 2000 ASMB A112 18 1 2000 ASSE1014 and CSA standard B125 98 ANSI ASME A112 18 3M performance requirements for backflow preventive device and systems in plumbing fixture fittings is applicable to plumbing fixture fittings with outlets not protected by an air g2. Shipment Inspection Examine the components immediately upon arrival to make sure no damages have occurred to the pedicure spa and chair during the shipment It is very important that you notify the driver on the face of the freight bill or bill lading of any damage Failure to note damage on the bill of lading may prevent any claims you may have against the carrier If damage is found you MUST notify the carrier at once and request an inspection DO NOT DISCARD THE SHIPPING CARTON If you do you do so at your own risk and expense Precaution Do not stand in the basin of the spa Excessive water temperature is dangerous and should be checked before use Maximum water Temperature should not exceed 150 F 65 C Always enter and exit the spa slowly and carefully Never bring or operate any electrical device near pedicure spa The unit has a weight capacity of 250 pounds Health Warning Individuals whose feet or legs are inflamed or have open wounds should not be allowed to use the pedicure spa at any time The technician should advise clients to consult their physician before using the spa if there is any sign of fungal infection swelling fracture or persistent pain In some cases diabetics may experience improved circulation in their feet but should first consult their physician prior to receiving a pedicure If the client experiences any pain or discomfort discontinue the use of the pedicure spa immediately
3. salontech AK Products Inc Whirlpool Pedicure Spa Manual 2014 by Salontechspa All Rights Reserved Printed in USA salontech Thank you for choosing salontech the leading manufacturer well known worldwide for its innovation and design in pedicure spas salontechspa takes pride in bringing you quality products that meet today s demand for safety and service The Spa Joy Whirlpool Pedicure Spa has been designed for dependability and to benefit all with a health conscious clientele PLEASE TAKE TIME TO READ THIS MANUAL THOROUGHLY BEFORE USE If you have any questions or problems with your pedicure spa please contact our Customer Service and Technical Support at 516 932 8888 Monday thru Friday 9AM 6PM or Email us at info salontechspa com Important Requirements salontech requires that you contact your local licensed plumber and licensed electrician to install your new spa Installation MUST be in compliance with all local and state building codes Your Pedicure spa cannot operate efficiently or safely unless it is provided with adequate electrical power sufficient water pressure proper water temperature and required drainage capabilities Contact your local building inspector for information and local code compliance procedure that need to be followed when having your new pedicure spa installed Subsequent inspections and approvals that may be required are the responsibility of the purchaser
4. by improper installation including NOT meeting local and state plumbing electrical and building codes 5 Staining fading or discoloration of the leather chair and urethane footrest 6 Damage resulting from standing in basin 7 Freight damage misuse neglect accident natural disaster and abuse 8 Unauthorized repairs Should service be required for any reason or any question on our product s please contact salontech AK Products Inc Technical Support 90 Alpha Plaza Hicksville NY 11801 T 516 932 8888 F 516 932 8880 E mail info salontechspa com www salontechspa com No distributor or other person has any authority to bind salontech to change or add this warranty or its products salontech is not responsible for such warranties or representations Due to continuous improvements on all of our products specification characteristics packing color and design are subject to change without notice salontech AK Products Inc Spa Joy Whirlpool Pedicure Spa Serial Number Order Number Installed by salontech AK Products Inc ASTER TE 90 Alpha Plaza Hicksville NY 11801 8 Tel 516 932 8888 877 725 6683 c US Fax 516 932 8880 MisTED www Salontechspa com
5. NG Adopt the various tactics to carry on automatic massage r to different position of the uppper part of the body The SES massage position covers the whole upper part of the body To carrying on automatic massage around the neck A shoulder mainly Carry on automatic massage around the waist mainly Method of Usage Function Button Display Status Adjust Massage Balls Speed Strength Speed Width Strength Method Speed Strength Speed Width Strength Speed Width Strength Speed 5 Speed options available Width 3 Width options available Upper body overall trip massage Backrest l Stretch Small area partial trip massage Fixed position fixed massage Salontech Maintenance Manufacturer requires that the pedicure spa be thoroughly cleaned at the end of the day in following manner Daily 1 Remove the jet cover fig 1 All debris trapped on or behind the cover must be removed The jet cover must be free of debris 2 Before placing the jet cover the cover must be immersed with EPA registered disinfectant 3 Flush out the whirlpool with low foaming detergent and warm water for 10 minutes 4 With fresh water EPA registered cleanser for run the no pipe motor for 5 minutes 5 Rinse with fresh water Weekly 1 Fill the basin with hot water up to its level 2 Add 3 to 4 table spoons of a low foaming agent 3 Run whirlpool for 5 m
6. ap Included in the possible range of applications are fittings with hose connected outlets fitting with pull out spout hand held showers shampoo fittings and deck mounted fittings ASME A112 18 3M is now referenced in ASME A112 18 1M plumbing fixture fittings and CSA B125 Backflow preventive devices are listed to both standards with the Canadian Standard Association APMO and UL ANSI American National Institute ASME American Society of Mechanical Engineers CSA Canadian Standard Association APMO International Association of Plumbing and Mechanical Officials UL Underwriters Laboratory Drain Facilities The pedicure spa drain must meet local plumbing codes Check valve for Drain not provided Must be installed by a licensed plumber Plumbing Connections 1 1 2 PVC Drain Outlet 3 8 PIP Cold Water Supply Inlet 3 8 Hot Water Supply Inlet Back of the pedicure spa salontech Identifying Components Head Rest Tongue Manicure Tray Armrest Shower Spray Footrest Polish Tray On Off Due to continuous improvements on all of our products specification characteristics packing color and design are subject to change without notice SpaJoy Specifications Dimension amp Weight SpaJoy Base Unit 29 3 4 W x 54 1 4 L x 14 1 4 H Wt 165Lbs SpaJoy Chair 22 W x 34 1 2 L Incline 50 L Recline Stool
7. careful handling this product Close supervision is necessary when unit is used by on or near children and the disabled Use this unit only for its intended use as described in this manual Do not use any attachments not recommended by MFG Keep the cord away from heated and wet surfaces Do not use outdoors Do not operate where aerosol products are being used or where oxygen is being administered Never operate If it has a damaged cord or plug or dropped in the water To disconnect press power button to turn off then remove the plug from the outlet Allow 30 minutes break time between operations Do not place any heavy object on the chair and do not let children play with it The maximum weight capacity for the massage chair is 250lbs Your massage chair is simple to operate using the handheld controller included with your chair Before you use your chair we recommend that you familiarize yourself with the remote control and the basic massage functions Due to continuous improvements on all of our products specification characteristics packing color and design are subject to change without notice SpatJoy Massage Chair Remote Control Instruction P Controller Operate Button Adjust Massage Balls To start or stop massage of the upper body the button does not work when the massage system is at its position of recovery Three modes of timing 10 mins 20 mins 30 mins TIMI
8. inutes 4 Stop whirlpool and sit for 5 to 7 minutes 5 Open air control and whirlpool for 5 minutes 6 Drain completely 7 Fill the basin with warm water up to its level 8 Apply EPA registered disinfectant according to its direction 9 Run whirlpool for 5 minutes 10 Drain completely 11 Wipe out excessive water with soft cloth 12 Repeat step 7 to 10 if necessary double locking covers cleaning instruction suggested by manufacturer 1 Gently turn the cover counter clock wise to remove Shown fig 1 This will expose the entire water chamber 2 Use antibacterial soap or a solution of 3 hydrogen peroxide to wipe the inner chamber Warning DO NOT use chlorine or chlorinated products such as diluted bleach as this will damage the plastic chrome cover and VOID your warranty Figa JJT Motor Cover Luraco Motor Cover SpatJoy Discharge Pump Discharge Pump Installation Instruction 1 Make a hole size 1 3 8 for the on off switch as shown Fig Pre drill required Place 1 8 clear hose into the rear of the switch and on off switch into the hole The discharge pump kit is made to fit into the pedicure unit as shown in Fig Connect EZ connector to the drain elbow Plug discharge pump outlet into black 2 minute timer Plug black 2 minute timer into the wall outlet NY Eh nA A UU N It is very important that tip of white tube remain above the water leve
9. iod All components One 1 year from date of shipment All optional items 180 days from date of shipment If Salontech receives defective product notice during the applicable warranty period salontech shall either repair or replace the defective parts at Salontechspa s option Replacement product part may be either new or equivalent in performance NO CONSEQUENTIAL INCIDENTAL OR CONTINGENT DAMAGE WILL BE ALLOWED WHATSOEVER This warranty is null and void if the spa is removed from its place of initial installation or is not in accordance with federal state or local codes and ordinances Furthermore this warranty does not apply if the spa has been subject to misapplication improper installation or maintenance negligence improper cleaning refurbished or tampered with in any way or other circumstances beyond Salontechspa s control salontech s warranty is valid in only within the continental 48 U S The warranty may be available from any authorized SAIONTECH service facility where the product is distributed by Salontechspa or by an authorized distributar Not Covered Damage to motor and or motor parts due to obstruction in plumbing etc pa 2 Staining fading or discoloration of surface due to exposure and or the use of harmful cleaning substance or chemical 3 Staining fading or discoloration caused by improper or poor water additives not related to maintenance of proper water 4 Malfunctions or damage caused
10. l with one big loop as shown in Fig3 Wall of Base gt Fastener On Off Switch a em Outlet Fig 1 2 Min Timer Clear Tube Electrical Cord Fig 3 White tube must have the loop N Joo ag em e e d a ER Seck D l l H Discharge H D CR Pump Ga EEN tane 1 1 4 Drain Elbow Loop to Connect Main e Drain Must have the loop ee eee before the main drain 1 PVG Pipe to prevent AIRLOCK 3 4 x 1 Adapter Pre Assembled Discharge Pump Fig 2 1 2 Check Valve Provided by MFG Operation Instruction Discharge Pump Kit Please DO NOT run dry 1 Turn to open the drain plug wait 2 seconds 2 Press on off switch to activate the timer 5 3 After the water has drained out from the basin Press the Du a E in on off switch again to stop OO ee saloniech LIMITED WARRANTY salontech manufactures Whirlpool Pedicure Spa with the highest standards for quality materials with UL listed components and highest workmanship for duration of the warranty period Duration begins on the date of purchase by the customer end user Each customer is responsible for maintaining the proof of purchase invoice to initiate the warranty The customer MUST send in warranty card in the manual booklet Read and fill out warranty form carefully and return to SAIONTECH within 15 days from purchase Warranty Per
11. ocation And Support Select a level location The floor structure beneath the pedicure spa must be capable of supporting the occupied pedicure spa For the seat back to full recline the pedicure spa base must be mounted 22 inches from the wall as shown below How to use adjustable footrest oward the front as shown fig2 15 3 4 ge Place right hand on the front of the footrest and gently pull up for desired height and use locking lever to secure the footrest WALL are A Minimum space from the wall Due to continuous improvements on all of our products specification characteristics packing color and design are subject to change without notice Deem CRT 51 2 a Ge gt n 37 Adjustable P trap 1 5 PVC Drain Pipe and Connector POWER DRAIN Sa apay lt pm Cp E ch d i CE Discharge Pump See Detailed Installation Page NOTE The requirement for vacuum breaker varies from state to state and province to province Please consult with the licensed plumber salontech Massage System Important Safety Instructions AA Warning To reduce risk of burns fire electric shock or injury READ ALL INSTRUCTIONS BEFORE USE burns will result from improper use please be
12. x 44 H Incline 34 H Recline Wt 125Lbs 19 W x 19 L x 22 HWt 13Lbs Capacity of Tub 4 25 US Gallon Switch On Off Air Activated Switch Whirlpool JJT Impeller Motor Jets Hydro Therapeutic Motor Jet with Impeller System Air Control Air Induction System Power Source Motor 115V 1 2Amp 60Hz 55W Discharge Pump Optional 115V 32Amp 60Hz Massage System 110V 120V 60Hz 90W 5Amp Plumbing Source Hot Water 1 2 inch Fitting pre installed Cold Water 1 2 inch Fitting pre installed Drain 1 1 2 inch see Plumbing Instruction Warranty Unit One Year see Warranty Optional Item 180 Days Due to continuous improvements on all of our products specification characteristics packing color and design are subject to change without notice salontech Dimension FRONT VIEW lt a 30 1 2 Re al 24 1 2 oo WALL Spa Joy SIDE VIEW N Back of the pedicure spa salontech INSTALLATION SPECIFICATONS SUMMARY 0 Warning Failure to comply with federal state or local codes and ordinances will result in warranty being null and void As stated the pedicure spa installation must comply with all plumbing and electrical codes A licensed plumber and licensed electrician must complete the applicable connections of the pedicure spa L
Download Pdf Manuals
Related Search