TUM 1039_(9090 030).indd
Contents
1. ratched controlled crimp pliers See also installation instructions of the relevant heat tracing cable and junction thermostat enclosure All dimensions shown in illustration are in mm Remove the outer jacket if applicable over a length of 140 mm YY YY Push braid back so that the opening in the braid get wider Y DIYS IDSIDY IDI TEF 9090 030 POWER TERMINATION KIT USER MANUAL Pull the heating cable through the braid near the overjacket Twist the braid Remove the inner jacket over 125 mm Remove the flat section of the matrix between the conductors over the total bare length Remove the remainder of the matrix material from the conductors Shrink the yellow green shrink sleeve over the braid and the black sleeves on the conductors TEF 9090030 POWER TERMINATION KIT USER MANUAL Stretch the braid along the conductors Shrink the transparent sleeve over the inner jacket and conductors as shown Squeeze with a long nosed pliers between the conductors and over inner jacket as shown until the adhesive is applying at the end Mount wire pins TRANBERG Tranberg AS P O Box 8033 N 4068 Stavanger Norway Tel 47 51 57 89 00 Fax2. 47 51 57 89 50 E mail info tranberg com www tranberg com Tranberg Systems Hjulmagervej 15C 7100 Vejle Denmark Tel 45 75 85 83 80 E mail mail tranbergsystems com www tranbergsystems com
3. TEF 9090 030 POWER TERMINATION KIT USER MANUAL IMPORTANT Read this instruction carefully before installing the product TRANBERG Tranberg AS PO Box 8033 N 4068 Stavanger Norway Tel 47 51 57 89 00 Fax 47 51 57 89 50 E mail info tranberg com www tranberg com Tranberg Systems Hjulmagervej 15C 7100 Vejle Denmark Tel 45 75 85 83 80 E mail mail tranbergsystems com www tranbergsystems com TEF 9090030 POWER TERMINATION KIT USER MANUAL INTRODUCTION APPROVALS Thank you for purchasing this product NA For installation maintenance and assurance of a long life of this product please follow this manual SAFETY PRECAUTIONS Note that changes made to the product and or installation of components which do not conform to the approval may be a safety violation The manufacturer will in no circumstance be held responsible for such activity For your health and safety always use safety gear suited for the task Be certain to follow codes regulations and or specific procedures that are related to the installation INSTALLATION Power termination kit for Self Regulating Heating Cables in hazardous areas Caution This product must be installed correctly Water ingress must be avoided before during and after installation to prevent electrical shock short circuit or arcing Before installing the product read these instruction completely Connect the metallic braid to earth Use only
Download Pdf Manuals
Related Search