AW900x - AvaLAN Wireless
Contents
1. AW900x Point to point Industrial grade ultra long range 900 MHz non line of sight wireless Ethernet systems AW900x Non line of sight 900 MHz Thank you for your purchase of the AW900x AW900x Kit point to point wireless Ethernet bridge i F G pA AD Aa Long range 900 MHz wireless outdoor Ethernet If you have any questions when configuring gt amp your AvaLAN system please send an e mail l to support avalanwireless com For a live technician please call technical support at 650 384 0000 For advanced installation information please visit www avalanwireless com Pi x 2 AW900x outdoor radios bridge Kit includes 2 110 VAC to 12 VDC power adapters e 2 Power over Ethernet injectors Requires antennae Use with AW2 AW5H 900 AW5P 900 AW6 AW10 AW11 or AW15 all FCC approved Operational summary The AW900x replaces costly wiring with a wireless Ethernet bridge that can enable remote Wi Fi access points Ethernet pan tilt zoom security cameras VolP phones or Internet kiosks AvaLAN s product offers the ideal combination of price range data rate security interference avoidance quality of service and ease of use The AW900x is the best solution when a Broadband Ethernet drop will cost too much or is impractical to install guaranteed DSL rate throughput is required kiosks Wi Fi access points PTZ cameras guaranteed latency for voice or video2. the device client or switch Power adapter 110 VAC Power 9 to 48 VDC Power over aaa Ethernet injector Data CAT5 cable not included CAT5 cable not included Ethernet RJ45 10BaseT AW900x J RF connector RP TNC www avalanwireless com RF connector Lo RP TNC 2 eee Oe AW900x 900 MHz digital Ethernet bridge Ethernet RJ45 10BaseT CAT5 cable not included CAT5 cable not included Data x Power adapter 110 VAC lt ___ Power over Ethernet injector Power 9 to 48 VDC PAGE 3 Technical support 650 384 0000 AW900x LED display Name Function CS Coor Unit has power and has successfully booted Red RF Link The radio has successfully synchronized with it Green partner RF TX RF RX Radio reception is occurring Eth Link The Ethernet Port has a valid Ethernet connection Activity The AW900m is processing data 1 channel By adding the numbers that are lit the user can Green 2 channel determine the current radio channel 4 channel 1 903 12500 MHz 7 915 62500 MHz 8 channel 2 905 20833 MHz 8 917 70833 MHz 3 907 29167 MHZ 9 919 79167 MHz 4 909 37500 MHz 10 921 87500 MHz 5 911 45833 MHz 11 923 95833 MHz 6 913 54167 MHz 12 926 04167 MHz Excellent link quality Green No retransmissions Very good link quality Green Good link quality Amber Occasional retransmissions The more LEDs that Sn shire om E are lit the higher
3. by this document Particular uses or applications may invalidate some of the specifications and or product descriptions contained herein The customer is urged to perform its own engineering review before deciding on a particular application AvaLAN Wireless products are not designed for use in medical life saving or life sustaining applications 07 07 2007 L S
4. is required PTZ cameras VoIP Wi Fi is too slow due to saturation or 2 4 GHz interference airport mall PTZ cameras ultra low current consumption is required 1 Watt solar powered systems Features include foliage penetrating non line of sight wireless Ethernet bridging does not interfere with Wi Fi networks Highest Quality of Service QoS available synchronous point to point protocol enables extremely low data latency and jitter 128 bit encrypted payload protection provides secure data delivery simple plug and play pre configured as matched pairs with no user programming required power over Ethernet enabled operates in the 902 928 MHz band and does not require an FCC license to operate or install VLAN extensions supported Technical support 650 384 0000 PAGE 2 www avalanwireless com Quick setup User s Manual ESAN 1 Plug in the AW900x using the supplied injector and power adapter 2 Connect an Ethernet cable from each AW900x to a network device 3 Send Ethernet traffic For troubleshooting see Page 4 System diagram Each AW900x radio automatically selects the best radio channel encrypts the Ethernet traffic and transports the data wirelessly to its mate Any Ethernet device can be connected to the AW900x The AW900x functions in place of an Ethernet cable and provides a trans parent wireless point to point Ethernet cable replacement Crossover cables are not necessary as the AW900x automatically senses
5. AW900x can perform a site survey With this mode activated the radios send and receive at 100 percent capac ity by transceiving self generated simulated data The installer can monitor the Link Quality display to assess channel quality while optimizing antennae orientation The installer can manually select each channel to evaluate performance and identify the best channels for operation By identifying channels with poor performance it is possible to identify possible interferers and use manual frequency selection mode to avoid portions of the band or select a fixed operating frequency Note Ethernet traffic does not get transported while the radios are in this mode Power save mode DIP switch 1 default is OFF for normal LED display In this mode the display LEDs can be turned off for low power applications solar www avalanwireless com PAGE 5 Technical support 650 384 0000 AW900x Technical specifications CHARACTERISTIC RF transmission rate SPECIFICATION DESCRIPTION 1 536 Mb s Ethernet throughput 935 Kb s Output power 21 dBm 4 Watts EIRP used with 15 dBi antenna Receive sensitivity 112 dBm at 10e 4 BER with 15 dBi antenna Latency lt 2 ms assuming a dedicated wireless link to client device Jitter 0 5 ms depending on packet size interference and SNR Power consumption FX 0 6 W TX 1 4 W Voltage 4 to 48 VDC Radio channels 12 non overla
6. ect and continuously optimize the performance of its radio channel The radio channel is monitored to ensure it is providing low error rates necessary for successful radio transmission In the event that the error rate rises the AW900x will autonomously change to a new channel There are 12 non overlapping channels Manual frequency selection mode To restrict the operation of the AW900x to a subset of the 902 928 band the user may activate a manual selection mode that allows the radio to automatically choose the best channel within a grouped subset of the 12 available channels This is enabled by the 8 position DIP switch on the master unit These settings allow the AW900x to operate on the optimal channel in one of three subsets LOW 4 MID 4 or HIGH 4 The DIP switch settings are Channels DIP Setting Frequenc MID 4 5 6 7 or 8 2 Off 3 On 910 918 MHz HIGH 4 9 10 11 or 12 2 On 3 On 918 927 MHz Or the user may wish to select a specific channel This can be done by setting DIP switches 5 8 as shown in the table below turn DIP 2 Off 3 Off Channel DIP Setting Center Frequency 5 On 6 Off 7 Off 8 On 919 79167 MHz 5 Off 6 On 7 Off 8 On 921 87500 MHz 5 On 6 On 7 Off 8 On 923 95833 MHz 5 Off 6 Off 7 On 8 On 926 04167 MHz CT lt SNNCOC t S S NCOR 6 Off 7 Off 8 On 917 70833 MHz Site survey mode DIP switch 4 default is OFF for normal operation In this mode the
7. ir or replace the defective part at its option at no cost This warranty does not cover defects resulting from misuse or modification of the product Compliance Statement Part 15 19 This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation Warning Part 15 21 Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment RF Exposure OET Bulletin 65 To comply with FCC RF exposure requirements for mobile transmitting devices this transmitter should only be used or installed at locations where there is at least 20cm separation distance between the antenna and all persons Information to the User Part 15 105 b Note This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular ins
8. pping Automatic frequency select Yes radio channel automatically selected and adaptively optimized Manual frequency mode Yes Status LEDs Power Ethernet Link RF RX RF TX 4 Channel and 6 Link Quality MAC pass through filter Yes can be disabled Error correction technique Sub block error detection and retransmission Adjacent band rejection SAW receiver filter attenuates cellular and pager interference Enclosure type NEMA 4X Temperature range 40 C to 70 C Power over Ethernet Includes injectors power supplies 9 to 48 VDC ready Range Tree attenuation 38 dB tree at 5 8 GHz 22 dB tree at 2 4 GHz 8 dB tree at 900 MHz 802 11a g and WiMAX 5 0 4 5 4 0 3 5 4 AvaLAN Wireless non line of sight wireless F Ethernet bridges enable broadband Internet anywhere Tree Tree Tree Longest range wireless Ethernet solution gt ACTUAL THROUGHPUT MBIT S With 11 dBi antennae With 15 dBi antennae With 2 5 dBi antennae 250 500 1000 2000 OUTDOOR RANGE FT 10000 Technical support 650 384 0000 PAGE 6 www avalanwireless com User s Manual Be Tel ed Warranty This product is warranted to the original purchaser for normal use for a period of 180 days from the date of purchase If a defect covered under this warranty occurs AvaLAN will repa
9. tallation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Sample applications AWSO0n 11d Bi Mletwerk UF Camera www avalanwireless com PAGE 7 Technical support 650 384 0000 A V N W R aLA E support avalanwireless com Technical support 650 384 0000 For advanced installation information visit www avalanwireless com 2004 2007 AvaLAN Wireless Systems Incorporated All rights reserved AvaLAN Wireless and the AvaLAN Wireless logo are registered trademarks of AvaLAN Wireless Systems Incorporated All other trademarks are property of their respective owners AvaLAN Wireless makes no representations or warranties with respect to the accuracy utility or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any time without notice No license express or implied by estoppel or otherwise to any patents or other intellectual property rights is granted
10. the A ee Many retransmissions No link quality No link available Troubleshooting See the online installation tutorial and FAQ at www avalanwireless com No Power LED Check the power connections No Radio Link LED The radio is looking for its matched partner If both units are powered up and the Power LEDs are active they may be too far away to create the radio connection Try other locations that may have a less obstructed path or try to reorient the antennae Yagi type antennae get their best range when they are oriented to point directly at each other with the antenna elements oriented in the same place eg vertically or horizontally Radio LINK LED is on but Link Quality Indicator is low The units may be too far away to create a good radio connection Try other locations that may have a less obstructed path or try to reorient the antennae No Ethernet LINK LED Check your network connections Installing multiple systems in close proximity See the online installation tutorial and FAQ at www avalanwireless com Still not working Temporarily use an Ethernet cable to see if the network is working over a wired connection If an Ethernet cable does not work then the problem is with the network Technical support 650 384 0000 PAGE 4 www avalanwireless com User s Manual ENAN Advanced settings Automatic frequency selection mode DIP switches all OFF for automatic mode The AW900x is designed to automatically sel
Download Pdf Manuals
Related Search