SMRR 7000 User Manual EN 0666220627 Jan
Contents
1. Dark Operated N O Enables the output to be active Turn switch to full counter when there is an object present clockwise position Output Logic Detection Output mode Output status Yellow LED CUS pesoni Dark operated N O Closed On __ gt Light operated N C Open Off Cec aseeni Light operated N C Closed On lt ad Dark operated N O Open Off Sensitivity Adjustment Maximum sensitivity can be used for most applications and is advised for applications with contaminated environments Increase the sensitivity to maximum by turning the potentiometer to full clockwise position Sensitivity adjustment may be required in applications where objects to be detected are small or translucent Proceed with the following steps Start with the sensitivity at maximum by turning the potentiometer to full clockwise position 2 Select target object with smallest dimensions and most translucent surface Do not connect black wire Do not connect white wire 3 Place target object between the sensor and retro reflector If the output status changes adjustment is not required If the output has not changed proceed to step 4 MRR 7 me ae Hee an ae bo Decrease the sensitivity by turning the potentiometer counter clockwise until the output 4 changes If the output has not changed attempt to move the sensor and retro reflector further apart or angle the sensor retro reflector Then repeat procedure from step 1 Connection Wires Pins Sig2. ETT q pig a plug 5 Remove target object Check the output status has changed Supply Blue Pin 3 Pin 3 Output White Pin 2 Pin 2 Output Black Pin 4 Pin 4 Sensor plug Sensor plug Website www telcosensors com Warning V 1 0 Part Number 0666220627 E Mail info telcosensors com This product is not a safety system and must not be used as such January 2011 edition Made in Denmark It is not designed for personnel safety applications and must not be used Telco A S reserves the right to make changes without prior notice as a stand alone personnel safety system
3. SMRR 7600 USER MANUAL SpaceMaster Series Photoelectric retro reflective sensors Product Data Electrical Data Supply Voltage 10 30 V dc Voltage ripple 15 Reverse polarity protected Yes Short circuit protected Yes Current consumption 20 mA Max output load 120 mA 30 V dc Environmental Data Temperature operation 20 to 60 C Sealing class IP 67 Approvals CE Available Models Supply Output Sensing Model Voltage ee Mode Range Retro SMRR 7600 10 30 V dc NPN PNP Light dark 0 3 m reflective Note Measured against 85 mm retro reflector Illustration j Output indicator V 047 Light dark switch Power on indicator Sensitivity adjustment Connection Wiring Diagrams Lad eosl Telco o SENSOTS Mounting amp Alignment Mounting amp Alignment 1 Position the sensor pointing at a retro reflector Align by moving sensor horizontally and vertically until the output status changes when aiming at retro reflector and when no object is present refer to Output Logic table Fasten the sensor securely using the enclosed locking nuts and or a mounting bracket Avoid acute angles on cable close to sensor Output Mode Selection The output mode can be selected via an integral light dark switch Refer to Output Logic table for output mode reference Light Operated N C Enables the output to be inactive Turn switch to full clockwise when there is an object present position
Download Pdf Manuals
Related Search