Single Color Slimline Underbody Kit
Contents
1. Coverage under this warranty is only valid within the United States including its territories as well as in certain other countries Purchasers should check our website www LEDGlow com to determine the warranty coverage in the countries in which they are located LEDGlow does not warrant the installation of the Product which is the sole responsibility of the Purchaser Installation should be done by licensed professionals Improper installation may cause damage to the Product and any vehicle in which it is installed and may cause burns and electrical injury to individuals LEDGlow s warranty does not cover any expenses incurred in removing Products that are defective or re installing replacement Products in their place During the warranty period to have the Product repaired or replaced the Purchaser must return the Product freight prepaid by the Purchaser to LEDGlow but for customers in the contiguous United States LEDGlow will pay the shipping charges if any Product fails during the first thirty 30 days after purchase The Product must be returned in its original carton or in a similar package affording an equal degree of protection LEDGlow will return the repaired or replaced Product freight prepaid to the Purchaser LEDGlow does not provide Purchasers with temporary replacement units during the warranty period or at any other time This limited warranty is non transferrable and will automatically terminate if the original retail co2. 10 11 12 13 14 15 16 17 18 19 20 21 22 23 INSTALLATION INSTRUCTIONS Li Y Tech Support SDGLOW 856 168 5700 EXT 2 A OY TechSupport LEDGlow com Be extremely aware of the location of the brake lines and fuel lines and do not mount any of the underbody tubes too close to the exhaust Leave at least 8 inches between the exhaust and the underbody tubes Keep the tubes and the power wires away from any moving parts Note 3 brackets are provided for each tube one for each end of the tubes as well as one for the center of the tubes First mount the front 36 inch tube to your vehicle with the male connector facing the driver s side using the included mounting brackets Make sure the tube is at least 8 inches away from any direct heat source and away from all moving parts IMPORTANT DO NOT MOUNT THE TUBE TO THE RADIATOR Next mount the driver s side 48 inch tube with the male connector facing the rear of the vehicle using the included mounting brackets A good mounting location for this tube is either to the pinch weld or side skirt Next mount the rear 36 inch tube with the female connector facing the passenger side of the vehicle using the included mounting brackets Then mount the passenger s side 48 inch tube with the female end towards the front of the vehicle using the included mounting brackets A good mounting location for this tube is either to the pinch weld or side skirt Mou
3. to verify the safe limit on the maximum amount of tubes you can connect per channel if you are planning to connect more than 6 total tubes per On Off switch Be sure that the total amount of tubes on this system are evenly split between the two channels from the On Off power switch Temporarily power your kit with any 12 volt source to ensure it is functioning properly before you move forward with the installation Simply connect the red wire from the On Off power switch to the positive terminal of the vehicle s battery and the black wire from the On Off power switch to the negative terminal of the battery or to any good ground source Power the kit and once you have determined it is functioning properly remove power from the kit Before mounting the underbody tubes please refer to the schematic below The underbody tubes on this kit must be installed in a specific way Note Each underbody tube daisy chains to the next with the included 6 feet of power wire and modular connectors with the exception of the two last tubes from each channel Ensure that each tube connector that is left unplugged is wrapped with the waterproof sealing tape Note Use the waterproof sealing tape on all connectors to ensure connections are not exposed to the elements 4 Once the kit is laid out and you have determined the kit is functioning properly you can proceed with the rest of the installation 5 Optional Raise and support the vehicle L
4. with respect to this warranty This limited warranty gives specific legal rights You may also have other rights that may vary from state to state or from country to country Some states or countries do not allow the exclusion or limitation of incidental or consequential damages so the above limitations and exclusions may not apply to you You are advised to consult applicable state or country laws for a full determination of rights
5. IF REPAIR OR REPLACEMENT FAILS TO REMEDY THE DEFECT PURCHASER S FAILURE TO MAKE A CLAIM AS PROVIDED IN PARAGRAPH 1 ABOVE OR CONTINUED USE OF THE PRODUCT SHALL CONSTITUTE AN UNQUALIFIED ACCEPTANCE OF SUCH PRODUCT AND A WAIVER BY PURCHASER OF ALL CLAIMS THERETO 3 EXCEPTIONS TO LIMITED WARRANTY LEDGLOW SHALL HAVE NO OBLIGATION TO PURCHASER WITH RESPECT TO ANY PRODUCT THAT IS SUBJECTED TO ANY OF THE FOLLOWING ABUSE IMPROPER USE NEGLIGENCE ACCIDENT MODIFICATION FAILURE TO FOLLOW THE OPERATING PROCEDURES OUTLINED IN THE USER S MANUAL FAILURE TO FOLLOW THE MAINTENANCE PROCEDURES IN THE SERVICE MANUAL FOR THE PRODUCT ATTEMPTED REPAIR BY NON QUALIFIED PERSONNEL OPERATION OF THE PRODUCT OUTSIDE OF THE PUBLISHED ENVIRONMENTAL AND ELECTRICAL PARAMETERS OR IF THE PRODUCT S ORIGINAL IDENTIFICATION TRADEMARK SERIAL NUMBER MARKINGS HAVE BEEN DEFACED ALTERED OR REMOVED LEDGLOW EXCLUDES FROM WARRANTY COVERAGE PRODUCTS SOLD AS IS AND OR WITH ALL FAULTS LEDGLOW ALSO EXCLUDES FROM WARRANTY COVERAGE ANY CONSUMABLE ITEMS SUCH AS FUSES AND BATTERIES All software and accompanying documentation furnished with or as part of the Product is furnished AS IS i e without any warranty of any kind except where expressly provided otherwise in any documentation or license agreement furnished with the Product 4 PROOF OF PURCHASE REGISTRATION The Purchaser s dated bill of sale must be retained as evidence of the date of purchase and to establish warranty el
6. INSTALLATION INSTRUCTIONS LEDGLOW goa ton SNOET O TechSupport LENGlow com Single Color SMD LED Slimline Underbody Kit Warning Please check your state and local laws before installing this LED underbody kit Every state has different policies and procedures in place regarding aftermarket vehicle accessories LEDGlow is not responsible for any fines that you may receive while using this underbody kit This kit is for off road use only Warning The installation of this kit is recommended to be installed by a licensed professional The improper installation of this kit will void all warranties The On Off power switch that is used to power the underbody tubes must be installed in a dry location inside of the vehicle Having this part exposed to water or the elements will cause the kit to fail Any water damage or corrosion to this part will void all warranties PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED UNDERBODY KIT Underbody Kit Includes 2 48 Inch Tubes e 12 Underbody Tube Brackets e 2 36 Inch Tubes e 20 Zip Ties e 1 On Off Switch e 12 Large Screws e 1 Self Sealing Waterproof Tape Underbody Kit Installation l Arrange the tubes out on the ground and test the kit to ensure proper functionality before installing This kit can safely hold a minimum of 1 48 inch 1 36 inch and 1 24 inch tube per channel however please refer to the product s description
7. dy tube into the lead wire for the driver s side tube Make sure to secure the wires tightly when going around the suspension and or exhaust Leave at least 8 inches between the exhaust and underbody tube Run the lead power wire from the passenger side underbody tube through a pre existing hole with a grommet in your firewall to the power switch If you do not have a pre existing hole in your firewall you can drill one but just be sure to add a rubber grommet to ensure the lead wire is not cut or pinched Next plug the lead wire from the passenger side underbody tube into the other male channel on the On Off power switch You can then plug the passenger side underbody tube into the lead wire for the rear underbody tube Make sure to secure the wires tightly when going around the suspension and or exhaust Leave at least 8 inches between the exhaust and underbody tube Be sure to use the included zip ties to secure and mount any bundles of wires from the underbody tubes under the vehicle in a safe location away from any direct heat sources or moving parts Once all of your connections have been made and you have tested the kit to ensure all connections are secure seal each connection by using the included waterproof self sealing tape Be sure that at least 1 inch of the wiring is also sealed with this self sealing tape which ensures the connections will not get wet and cause your kit to fail It is imperative to make sure that the wires are no
8. igibility Registration of any Product or of this limited warranty is voluntary and failure to register will not diminish any rights available under this warranty DISCLAIMER OF WARRANTY EXCEPT FOR THE FOREGOING WARRANTIES LEDGLOW HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2 312 3 OF THE UNIFORM COMMERCIAL CODE OR IN ANY OTHER STATE STATUTE LIMITATION OF LIABILITY THE LIABILITY OF LEDGLOW IF ANY AND PURCHASER S SOLE AND EXCLUSIVE REMEDY FOR DAMAGES FOR ANY CLAIM OF ANY KIND WHATSOEVER REGARDLESS OF THE LEGAL THEORY AND WHETHER ARISING IN TORT OR CONTRACT SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT FOR WHICH SUCH CLAIM IS MADE IN NO EVENT SHALL LEDGLOW BE LIABLE TO PURCHASER FOR ANY SPECIAL INDIRECT INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING BUT NOT LIMITED TO COMPENSATION REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER GOVERNING LAW This non transferrable limited warranty shall be governed by the law of the State of New Jersey U S A and the United States of America excluding their conflicts of laws principles The courts of Camden County New Jersey shall have the exclusive jurisdiction over any legal action
9. nsumer purchaser resells the Product or transfers the vehicle on which the Product is installed An original retail consumer purchaser is a person who originally purchases the Product or a gift recipient of a new Product that is in its original packaging and unopened This limited warranty is subject to all of the following terms and conditions TERMS AND CONDITIONS 1 NOTIFICATION OF CLAIMS WARRANTY SERVICE IF PURCHASER BELIEVES THAT A PRODUCT IS DEFECTIVE IN MATERIAL OR WORKMANSHIP WRITTEN NOTICE WITH AN EXPLANATION OF THE CLAIM SHALL BE GIVEN PROMPTLY BY PURCHASER TO LEDGLOW ALL WARRCANTY CLAIMS MUST BE MADE WITHIN THE WARRANTY PERIOD AND ANY PRODUCTS RETURNED TO LEDGLOW MUST BE SHIPPED IN ACCORDANCE WITH LEDGLOW S PROCEDURES INCLUDING USE OF RMA NUMBERS SUPPLIED BY LEDGLOW AFTER NOTIFICATION THE REPAIR OR REPLACEMENT OF ANY PRODUCT OR PART THEREOF SHALL NOT EXTEND THE ORIGINAL WARRANTY PERIOD THE SPECIFIC WARRANTY ON THE REPAIRED PART ONLY SHALL BE IN EFFECT FOR A PERIOD OF NINETY 90 DAYS FOLLOWING THE REPAIR OR REPLACEMENT OF THAT PART OR THE REMAINING PERIOD OF THE PRODUCT WARRANTY WHICHEVER IS GREATER 2 EXCLUSIVE REMEDY ACCEPTANCE PURCHASER S EXCLUSIVE REMEDY AND LEDGLOW S SOLE OBLIGATION IS TO SUPPLY OR PAY FOR ALL LABOR NECESSARY TO REPAIR ANY PRODUCT FOUND TO BE DEFECTIVE WITHIN THE WARRANTY PERIOD AND TO SUPPLY NEW OR REBUILT REPLACEMENTS FOR DEFECTIVE PARTS LEDGLOW WILL REFUND THE PURCHASE PRICE FOR SUCH PRODUCT ONLY
10. nt the underbody kit s On Off switch in a safe and secure location inside of your vehicle Run the lead power wire from the front underbody tube through a pre existing hole with a grommet in your firewall to the power switch If you do not have a pre existing hole in your firewall you can drill one but just be sure to add a rubber grommet to ensure the lead wire is not cut or pinched This underbody kit s On Off power switch can be powered one of two ways i Connect the red power wire to any 12 volt source If you need to extend the power wires be sure to only use 16 or 18 gauge automotive grade wire If you are running the power wire to the battery it must go through the firewall by using an existing grommet or by drilling a hole and adding a new grommet which is available at any auto parts store Be sure to use the included inline fuse within 6 inches from the battery ii This underbody kit can also be powered directly from your vehicle s fuse box If you are powering the kit via the fuse box we recommend using LEDGlow s Expandable Circuit which is available at www LEDGlow com Connect the black wire to a good unpainted metal surface A few good ground sources can be found under the dash at any main bracket or grounding block the negative terminal of your battery or any engine ground Next plug the lead wire from the front underbody tube into one of the male channels from the On Off power switch You can then plug the front underbo
11. t mounted to any direct heat source or to any moving parts Any excess length on the tube power wire will have to be bound up and secured tightly with zip ties DO NOT SHORTEN OR CUT ANY OF THE UNDERBODY TUBE WIRES THIS WILL DESTROY THE KIT AND VOID ALL WARRANTIES Lower the vehicle if it was raised power the kit and test it for full functionality Once the vehicle is on the ground turn the steering wheel as far as it can go in both directions to ensure the tubes and or wires are not coming in contact with your tires or any other moving parts For accessories replacement parts and or technical support please visit www LEDGlow com for more information INSTALLATION INSTRUCTIONS L pG LOW Tech Support ee eena ee O ENT 2 om ONE YEAR NON TRANSFERRABLE LIMITED WARRANTY AND DISCLAIMER LEDGlow Lighting LLC LEDGlow warrants to the original retail consumer purchaser and not any other purchaser or subsequent owner that this Product will be free from defects in material or workmanship for a period of one 1 year from the purchase date This warranty does not cover any Product that is 1 installed incorrectly or 2 damaged by collisions vandalism other accidents or similar causes For a period of one 1 year from the date of purchase at no charge to the Purchaser LEDGlow will repair or replace this Product if it is determined by LEDGlow to be defective After the watranty period the Purchaser must pay all charges for parts and labor
Download Pdf Manuals
Related Search