- Ocean Sensor Systems, Inc.
Contents
1. will stop recording data at 2359 hours and then start recording data again the next day at 0000 hours in the new file Note 3 See the user manual for information on changing the Wave Gauge Blue configuration2. OSSI 010 022 Wave Gauge Blue Quick Start Guide This guide will assist the user to obtain data from the Wave Gauge blue in the quickest time possible The user is advised to read the user manual in its entirety before actual deployment of the instrument After unpacking the unit check to see that there is a battery pack with a connector a DB9 serial communication cable a Wave Gauge Blue a compact flash card and Bluetooth Adaptor The Wave Gauge Blue will accept compact flash card sizes from 64MB to 64GB The top of the Wave Gauge Blue housing the part with the label unscrews from the bottom Do not screw them together too tightly or it will become difficult to reopen If the flash card is not yet installed insert the flash card with the label upside down facing you The extra ridge on the card will be to the back as indicated on the panel The battery may be plugged into the cable extending from the electronics The LED will now signal the following 1 ON FOR 3 SECONDS CARD INSERTED OK COLLECTING DATA 2 CONTINUOUS 1 SEC ON amp 1 SEC OFF OK TO REMOVE CARD STOPS AFTER CARD REMOVED 3 FAST BLINKING CARD REMOVED BEFORE CLOSING FILE OR BAD CARD FORMAT If the LED signals for 3 seconds the unit will begin to collect data normally If the red LED flashes rapidly several times the initialization has failed and the battery should be unplugged and reinserted To view the data push the small recessed button on the top of the el
3. ectronics The red LED will begin to blink at a one second interval to indicate that you may now remove the flash card Failure to push the button will cause the data to be lost Insert the flash card into a PC based flash card reader user supplied The files may be imported into the Interface Software Word Pad Exel Matlab or other text or analysis program To assemble the unit for deployment a light coating of silicon o ring grease should be applied to the o rings and sealing surfaces The battery is set into the recess in the bottom half of the unit The battery connector secured within the track on the side of the battery pack The cover or top half of the Wave Gauge Blue may now be screwed all the way down over the bottom half Do not screw the halves together too tightly as it will become difficult to separate them A very important note about the Wave Gauge Blue Note 1 Remember to tell anyone using it that they MUST NOT GET ANY SALTWATER or SWEAT INSIDE THE UNIT AS THIS WILL CORRODE THE CIRCUITRY It must be thoroughly dried before it s opened Then lay the unit down on its side Open the unit very carefully if there is any water around the 0 Ring it will not fall into the unit and can be further dried Hands must be totally dry when opening and handling the unit Note 2 If enabled The New file Interval In Days will use the last minute of the day to close that days file and open a new file for the next Day The Wave Gauge Blue
Download Pdf Manuals
Related Search