to – 100 Series User Manual
Contents
1. TOCONNECT Professional a Li PROCONNECT FLIP TOP BOX SERIES USER M ANUAL PC100 Series Thank you for purchasing our professional table top connecting panel Should you require less cables than what are supplied please remove surplus cables carefully Please be careful if you cut the cables as incorrectly cut cables cannot be replaced under warranty CAUTION e Only connect the power connection to a voltage feed of 240 Volt 50Hz single phase with protective earth NOTE Maximum total load is 10A 2400W across the entire unit e There is a 10A fuse built in to the IEC 60320 rubber connector which may not be replaced by a fuse with a higher ampere value A spare fuse can be found in the fuse drawer of the IEC Plug e Do not wet the unit and keep in a dry well ventilated area e If the supply cord is damaged it shall be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid a hazard INSTALLATION e The ProCONNECT unit should be installed by a professional technician e Please check and confirm the supplied template with the size of the unit avEFEKTs or its registered dealer cannot be held responsible for damages due to incorrect cut outs e Define the point of installation accurately and mark out the area to be cut with the template or attach the template directly onto the table surface e The area to be cut should be made with the appropriate tools determined by the s2. urface M ake the cut out e Insert the ProCONNECT through the opening and position correctly e Attach the fasteners to the appropriate notches underneath the unit The area with the insert nut must be parallel to the plate and the screw head must point away from the plate Adjust the unit to the desired position and tighten with screws e Connect the Audio Visual cable ends to the respective cables sockets Please also connect the 240V Power to a Wall Plug e Ensure that the power outlet and the signal connectors are only being used with the maximum allowable voltage and current NOTE Maximum total load is 10A 2400W across the entire unit INSTRUCTIONS FOR USE e Open amp Close Flip open the lid of the unit and extend the cables that are required e Cleaning Switch off the system and pull the plug before cleaning DO NOT use any cleaning agents or water on the unit Only use a soft and lightly moisturized cloth 1 YEAR WARRANTY ON ALL PROCONNECT SERIES
Download Pdf Manuals
Related Search