Hook type High Pressure Washer User`s Manual MODEL
Contents
1. exposure to natural elements Water filter blocked min 1 2 e a Heer cake Hose kinked Clean the nozzle ansportation damages sales Clean the filter e Services not provided by our authorized service centers Straighten out hose e Accessories and spare parts if any provided in the package Machine often Pump spray gun is Contact your nearest Service e Damage resulted from commercial or industrial use as this product is starts and stops leaking Centre intended for DIY use only by itself Pump hoses or Wait for pump hoses or accessory Machine starts accessory frozen to thaw but no water No water supply Connect inlet water SAVE THESE INSTRUCTIONS comes out Water filter blocked Clean the filter Nozzle blocked Clean the nozzle 2 For warranty service please contact the present the warranty card and the original In case problems other than the above occur please contact your local distributor2. FLUSH THE UNIT OUT WITH PLAIN WATER ANTI FREEZE CAN DAMAGE PAINTWORK SO YOU MUST ENSURE THERE IS e NOTE The machine not suitable for connection to the potable water main FIG 15 NO ANTI FREEZE LEFT IN THE SYSTEM BEFORE USING IT AGAIN WARNING The intake water temperature must not exceed 40 The water supply must not exceed 0 7 MPa AN CAUTION The washer must only be used with clean water use of unfiltered water of corrosive chemicals will damage the washer Push the motor switch to OFF position FIG 10 Check that the electrical supply voltage and frequency Volt Hz correspond to those specified on the washer rating plate If the power supply if correct you may now plug in the washer 7 OPERATION NOTE THE MOTOR ONLY RUNS WHEN THE TRIGGER IS OPERATED CORRECT USE OF STANDARD ACCESSORIES Turn on the water supply tap fully Release the safety lock FIG 8 and FIG 9 then press the trigger for a few seconds to allow air to escape and to discharge residual pressure in the hose Keeping the trigger pressed push the switch to start the motor FIG 10 When re starting the motor always keep the trigger pressed The washer is equipped with the adjustable nozzle Jet adjustment from pencil to fan FIG 11 8 MAINTENANCE CAUTION Before working on the washer disconnect the lug from the power supply socket To ensure good performance check and clean the suction and detergent filters after every 50 hours of oper
3. TOOLEX Industrial High Pressure Washer User s Manual MODEL 595646 Fig 1 Hook type q T s N Warning Read the instructions before using the machine 1 Technical data Rated voltage AC240V 50Hz Rated input power 1800W 2 4HP Rated pressure Max pressure Rated temperature Max inlet pressure Weight 18 94kgs Water inlet 2 SYMBOLS USED TO MARK INSTRUCTIONS The following signal words and meanings are intended to explain the levels of risk associated with this product Some of the following symbols may be used on this product Please study them and learn their meaning for safe operation Before starting up your high pressure washer for the first time this instruction manual must be read through carefully Save the instructions for Indicates an imminently hazardous situation which if not a Danger l avoided will result in death later use Wanin Indicates a potentially hazardous situation which if not l l l l J avoided could result in death or serious injury Safety instructions marked with this symbol Safety Alert must be observed to prevent danger to persons o DE N Caution Indicates a potentially hazardous situation which if not Read instruction This symbol is u
4. ation FIG 12 Clean the nozzle with the tool provided Remove the lance from the gun remove any dirt from the nozzle hole FIG 13 and rinse 9 TROUBLE SHOOTING 10 Circuit Diagram Disconnect from the electrical power supply before carrying out user maintenance or checking its correct functioning ideameai ooh 7 To avoid unnecessary disappointments you should check the following before contacting 5 the service organization LOURA Ores Symptom Cause Recommended action Machine not plugged Plug in machine Motor F I in Try another socket l eS a Machine refuses Defective socket Replace fuse Switch off other P On off to start Fuse has blown machines i iteh Defective extension Try without the extension cord gt cord Bey ee eee J Pump sucking air Check that hoses and connections Capacitor 7 Valves dirty worn out are airtight oo Fluctuating or stuck Clean and replace or refer to local 11 DISPOSAL pressure Pump seals worn out distributor Clean and replace or refer to local Recycling the washer distributor E Do not dispose of electrical appliances as unsorted municipal waste use separate Fuse has blown Repla
5. ce fuse Switch off other collection facilities Incorrect mains machines d Contact your local government for information regarding the collection systems available voltage Check that the mains voltage If electrical appliances are disposed of in landfills or dumps hazardous substances can Machine stops corresponds to specification on the E leak into the groundwater and get into the food chain damaging your health and Thermal sensor model tag activated Leave the washer for 5 minutes to were Nozzle partially cool down Clean the nozzle When replacing old appliances with new ones the retailer is legally obligated to take back blocked your old appliance for disposals at least free of charge Fuse too small Change to an installation higher than the amp consumption of the 12 WARRANTY SERVICE som machine You may try without the 1 This Product has been manufactured to a high quality standard The warranty period is 3 exlen SIgn Ora month from date of purchasing Air in inlet hose Allow machine to run with open trigger until regular working ba Inadequate supply of pressure resumes invoice for the warranty service mains water Check that the water supply 3 This warranty DOES NOT apply to Machine corresponds to specifications e O rings seals valves nozzles filters pulsating Nozzle partially required e Damages to high pressure hose gun pump motor housing shells due to blocked NB Avoid using long thin hoses misuse operation errors or
6. d Thermal sensor A thermal sensor protects the motor against overloading The machine will restart after a few minutes when the thermal sensor has cooled 4 NAME OF PARTS FIG 1 1 Handle 5 Water inlet nut 9 Hose hook 2 Detergent bottle 6 Gun stock 10 Spray lance 3 Screw 7 Gun hook 15 Spray gun 4 Wheel 8 Screw 16 High pressure hose 5 PRODUCT DESCRIPTION PURPOSE e The high pressure cleaner is designed to clean vehicles machines buildings facades etc in the private sector AREAS OF APPLICATION e Never use the machine in potentially explosive areas under any circumstances e The operating temperature must be between 0 and 40 e The machine consists of an assembly with a pump which is encased in a shock absorbing housing For an optimal working position the machine comes with a lance and a non slip handle grip whose shape and configuration comply with the applicable regulations Do not cover or modify the lance or the spray nozzles in any way The high pressure cleaner is designed to be used with cold or lukewarm max 60 higher temperatures can damage the pump Do not use water that is dirty gritty or contains any chemical products as these could impair operation and shorten the life of the machine Accessories can be used to carry out work with foam cleaners sand spraying 6 ASSEMBLY Position the washer as NEAR as possible to the water supply Connect the PVC tube to the detergent connec
7. ers shall not be used by children or untrained personnel e To ensure appliance safety use only original spare parts from the manufacturer or approved by the manufacturer e WARNING The machine shall be disconnected from its power source during cleaning or maintenance and when replacing parts for mains operated machines by removing the plug from the socket outlet e WARNING High pressure hoses fittings and couplings are important for safety of the appliance Use only hoses fittings and couplings recommended by the manufacturer e Do not use the appliance if a supply cord or important parts of the appliance are damaged e g safety devices high pressure hoses trigger gun e WARNING If an extension cord is used the plug and socket must be of watertight construction e WARNING Inadequate extension cords can be dangerous e This high pressure washer must not be used at temperatures below 0 C e WARNING e Cord on drums should always be completely unwound to prevent the cord from overheating If an extension cord is used the plug and socket must be of watertight construction e Inadequate extension cords can be dangerous e Comply with the below mentioned requirements for length and cord dimensions 1 5 mm max 10 m 2 5 mm max 15 m e Power cord connections should be kept dry and off the ground If the power cord is damaged it must be replaced by the manufacturer or his service agent or similarly qualified person in order to av
8. oid a hazard Always keep the machine on a stable and flat surface during operation handling transportation and storage Sudden overturn of machine will cause injury to body In the event of accident or breakdown switch off the machine immediately e g contact with detergent rinse with an abundance of clean water WARNING ELECTRICAL SHOCK HAZARD yh Improper connection of the equipment grounding conductor can result in a risk of electrical shock Check with a qualified electrician or service person if you are unsure if an outlet is properly grounded DO NOT modify the plug provided with the appliance to fit an outlet have a proper outlet installed by a qualified electrician Mains power connection 2 The following should be observed when connecting the high pressure washer to the electric installation e The electric installation shall be made by a certified electrician e itis recommended that the electric supply to this appliance should include either a residual current device that will interrupt the supply if the leakage current to earth exceeds 30mA for 30ms IMPORTANT Only use water without any impurities If there is a risk of running sands in the inlet water i e from your own well an additional filter should be mounted Safety devices e The unloader valve can reduce pressure if it exceeds pre set values The spray gun features a locking device When the locking lever is activated the spray gun cannot be operate
9. rized distributor should replace it WARNING Warning Do not use this appliance without reading this instruction sheets Electric Shock Remove plug from the mains immediately if Precaution cable is damaged or cut sound power Sound power level is 96dB A i i i j i i level p e The Electric supply to this appliance should include either a residual current device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a device that E E Electrical shock electrical shock hazara will interrupt the earth circuit e WARNING This appliance has been designed for use with the cleaning agent supplied or l recommended by the manufacturer The use of other cleaning agents or chemicals may Machine not suitable for connection to the potable water mains adversely affect the safety of the appliance Potable refers to portable tanks e WARNING Do not use the appliance within range of persons unless they wear protective clothing e The electric supply connection shall be made by a qualified electrician e WARNING High pressure jets can be dangerous if subject to misuse The jet must not be directed at persons live electrical equipment or the appliance itself e Do not direct the jet against yourself or others in order to clean clothes or foot wear e Risk of explosion Do not spray flammable liquids e Disconnect from the electrical power supply before carrying out user maintenance e High pressure clean
10. sed to mark safety instructions avoided may result in minor or moderate injury Safety mark that must be observed to prevent damage to the machine and its performance Caon Without Safety Alert Symbol Indicates a situation that This symbol indicates tips and instructions to may result in property damage Indication mark simplify work and to ensure a safe operation Waste electrical products should not be 3 IMPORTANT SAFETY INSTRUCTIONS Waste products disposed of with household waste WARNING di Please recycle where facilities exist l l l l ISposa Check with your Local Authority or retailer for This appliance is not intended for use by children or other persons without assistance or recycling advice supervision if their physical sensory or mental capabilities prevent them from using it safely Always wear safety goggles or safety glasses Eye Protection with side shields or a full face shield when operating this product Before starting up your machine please check it carefully for any defects If you find any do not Children should be supervised to ensure that they do not play with the appliance start up your machine and contact your distributor Check Before Use keep To reduce the risk of injury user must keep all e The insulation of the power cord should be faultless and without any cracks If the power Bystanders Away bystanders at least 15m away cord is damaged an autho
11. tion FIG 3 The washer must be used standing on a secure stable positioned as shown FIG 2 Fit the lance into the gun and rotating it until the two parts are completely locked FIG 4 Connect the gun to the high pressure hose FIG 5 Connect the high pressure hose to the water outlet on the washer FIG 6 Connect the water supply hose to female coupler FIG 7 then connect to the water inlet of the washer The supply hose must have an internal diameter of at least 13mm 1 2 in and must be reinforced The water supply must be at least equal to the washer delivery capacity WARNING DO NOT ADJUST THE NOZZLE WHILE THE TRIGGER IS SQUEEZED RECOMMENDED CLEANING PROCEDURE Dissolve dirt by applying detergent with the fan jet to the dry surface On vertical surfaces work from the bottom upwards Leave the detergent to act for 1 to 2 minutes but do not allow to dry out Apply the high from the surface working from the bottom upwards Avoid allowing the rinsing water to run on to unwanted surfaces STORAGE FIG 12 FIG 14 Switch off the washer Turn off the water supply tap After use the detergent residuals should be removed from the tank Discharge residual pressure by pressing the trigger until no more water comes out of the lance nozzle Engage the gun safety lock Remove the plug from the socket Operate the washer with non corrosive non toxic antifreeze before storing for the winter WARNING BEFORE REUSING COMPLETELY
Download Pdf Manuals
Related Search