LAN Setup Activity
Contents
1. QOS for various ports Part V 15 Reset the router to its factory default configuration 16 Reset the IMac the Windows 2000 and the Linux systems to their original network configurations What to turn in Write your report using MS Word This report should contain all the details of your work and experiences in the laboratory Make sure you point out all the difficulties and challenges that you have encountered BE SURE TO INCLUDE ALL THE NAMES OF THOSE WHO ARE INVOLVED IN THE REPORT2. LinkSysRouter DomainName jsu edu LAN IP Address 192 168 2 7 LAN Subnet Mask 255 255 255 0 WAN IP Address 205 174 50 119 WAN Subnet Mask 255 255 255 0 Default Gateway Address 205 174 50 1 DNS Server 199 88 30 4 Part II 3 Connect the router to one of the 3COM switch Diagnose and correct the problems if there are any Part II All the documentations for configuring each of the systems below can be found in the course website http cs jsu edu mcis faculty gfrancia cs450 4 Configure the Windows 2000 system s network interface card Connect the system to the router Test the connection 5 Configure the IMac system s network interface card Connect the system to the router Test the connection 6 Configure the Linux systems network interface cards Connect the systems to the router Test the connections Part IV Before doing each of the following steps that involve network security study research the topic using the Internet or the library Test your configuration after each step 7 Enable IP Filtering on the router 8 Enable MAC address Filtering on the router 9 Enable Block WAN request 10 Enable multicasting Use the multicasting program that you wrote in one of the earlier programming projects to test the setup 11 Establish VPN sessions by enabling Point to Point Protocol PPTP Pass Through 12 Enable Remote Management 13 Specify the Maximum Transmission Unit MTU 14 Enable Quality of Service
3. CS 450 Computer Networks Lab Assignment 2 A maximum of 4 students are allowed to work on this project as a group Purpose The purpose of this lab is to give you a hands on experience with configuring a heterogeneous local area network LAN using a Linksys EtherFast DSL Router a Windows 2000 system an IMac system an SGI Irix system and three 3 Linux systems Linux Linux Linux SGI Irix 209 1 74 90 124 19216821 192 168 2 2 192 168 2 3 192 168 2 4 EtherF ast Hub Router in fit eepe erer 192 168 2 7 i 205 174 50 119 J 192 168 2 6 192 168 2 9 C Beet Haat aa 25 IMac Windows 2000 C5450 Local Area Network Configuration NOTE Document all the steps you followed You will be required to submit a report in a format that will be specified at the end of this project specification Part I 1 Read the complete Linksys EtherFast documentation which is located in F USER GFRANCIA CS450 LinkSysRouter pdf 2 Configure the LinkSys EtherFast device as a router one that connects two networks together Thus it needs two 2 IP addresses one for the local area network LAN which is 192 168 2 7 and the other for the wide area network WAN which is 205 174 50 119 These addresses are static IP addresses The instructions on how to do this are found in chapters 3 and 5 of the Etherfast User s Manual Here are some pertinent information that you will need to configure the router HostName
Download Pdf Manuals
Related Search