DEHUMIDIFIER
Contents
1. d l Operation Panel Refer to P 2 Z Buoy f Not to be blocked gt gt i ps Air Inlet Rear air inlet not to be blocked Refer to P 8 Power Cable Hanging Hole Power Cable Binder To be released when operating the unit Power Plug 3 Continuous Water Drainage Outlet Refer to P 7 Truck Wheel OPERATING INSTRUCTIONS Control Panel DEHUMIDIFY ae LAUNDRY 70 ON OFF FULL QUIET HUMIDITY C MODE Q Control Panel Lights Full Water Tank Full When this light flashes it indicates that the water tank is full or the water tank is installed incorrectly Pull out the tank and empty if it is full or reinstall if it has been installed incorrectly ON OFF Power Indication Light When power to the unit is turned on the light under ON OFF will illuminate Mode Lights Indicates mode of operation Dehumidify Laundry or Quiet mode Basically modes are fan speeds Humidity Indication Lights The indication lights 50 60 and 70 will each be illuminated when the corresponding relative humidity RH percentage has been selected by pressing the humidity button Continuous Dehumidifying Indication Light When this light is illuminated the continuous setting has been selected using the humidity button Humidity Indication Light Range of RH 50 Less than 60 60 60 and over but less than 70 70 Over 70 Button Functions 1 ON2. Use a vacuum cleaner hose attachment to clean off the dust on the surface of the air filter If the filter is dirty you may use lukewarm water or a neutral detergent solution to clean it After cleaning thoroughly dry the filter The active carbon screen cannot be cleaned You may replace as required 3 Re install the air filter Place the active carbon filter back into its Original position behind the air filter Put the clips at the bottom of the air filter into the unit and then press the air filter into position until the clips at the top fit back into their original position Store the dehumidifier in the original packaging in a ventilated dry area TROUBLE SHOOTING PROBLEM CAUSES TROUBLE SHOOTING The unit does not turn ON The dehumidification is not functioning No air is discharged from the unit Noisy operation Is the power cable disconnected Is the FULL indication light on The water tank is full or the water tank is not correctly installed Is the ambient temperature above 39 C or below 2 C Is the air filter blocked Is the air outlet blocked Is the air filter blocked Is the unit properly installed Is it tilted or unstable Is the air filter blocked Plug in the power cable correctly Empty the water from the tank and place the water tank back into its Original position or reinstall the tank into the correct position The built in protective device is in action To a
3. 6 Litres the indication light for full tank will be lit and the unit will automatically stop operating When the water tank is full empty the water carefully Drainage Procedures 1 Take out the water tank Do not remove the float or sensor in the water tank At the top of the water tank gently because the float and the sensor are used to monitor press the two sides inwards whether the water tank is full or not Damage to the float or the sensor may make the water in the tank overflow 2 Hold the handle and pull out the water If the water tank is dirty please clean it with cold or tank lukewarm water Do not use any cleaning detergents sprays or other chemicals as they will damage the unit and cause it to leak When the water tank is re installed push it back to its Original position The unit will not function when the tank is incorrectly installed Empty water here N CONTINUOUS WATER DRAINAGE This unit is equipped with a water outlet for continuous drainage Use a water tube size 15mm Always unplug the unit before attempting to install a drain Take off the water tank and open the water outlet for Continuous drainage Use a pair of pincers or a similar tool to cut open the water outlet located at the side of the unit Insert the drain hose into the water outlet opening Pass the water hose size 15mm through the water outlet opening and firmly push it into the water outlet of the main unit Do
4. model number and product name located on the Product Identification Plate the date you purchased the product and attach your purchase receipt as proof of purchase To ensure your product is covered by warranty the complete faulty product together with your purchase receipt should be returned to your retailer ONE 1 YEAR LIMITED WARRANTY Save This Warranty Information EHS International Ltd Guarantees this product free from defects in materials and workmanship for a period of one 1 year Should this unit be operated under conditions other than those recommended at voltages other than the voltage indicated on the unit or any attempts made to service or modify the unit will render this WARRANTY VOID The product you buy may sometimes differ slightly from illustration This warranty is in addition to and does not affect your statutory rights Should you have a problem with this product please call our Help Desk on 0870 742 5021 This product has been manufactured to comply with the EEC Directives 73 23 EEC and 89 336 EEC EHS Manchester M17 1RN EHS07 05
5. not block the hose 3 Place the water tank back to its original position Make regular checks when the hose is first installed to ensure that it is properly connected and there is no blockage Note Always position the angle of the drain hose downward MOVING YOUR DEHUMIDIFIER USING THE REAR WHEELS Empty the water tank before moving the unit Remember to leave adequate room for ventilation around your Dehumidifier Lift the handle and tilt the unit so that it can be easily moved on the rear wheels Take care when rolling your Dehumidifier across floors where the wheels may cause damage such as thick pile carpets and wooden floors If in doubt carry your Dehumidifier with the handle Min 50cm 20 inch f eae Min 20cm 8 inch Min 20cm 8 inch x Min 20cm 8 inch Min 20cm 8 inch MAINTENANCE AND SERVICING Before cleaning turn the unit off and unplug from the power supply To clean the unit use a soft cloth to wipe off any dust If the unit is very dirty use a damp cloth and wipe dry Do not use any cleaning detergents sprays or other chemicals as they will damage the unit Clean the air filter The air filter should be cleaned once every two weeks 1 Take off the air filter Press down the clips on the top of the air filter to remove the filter There is an active carbon filter screen attached behind the air filter Take off the active carbon screen 2 Clean the air filter
6. OFF Button In standby mode pressing the ON OFF button will start the unit and pressing the button again will switch off the unit 2 MODE Button When the MODE button is pressed the unit will select the operational mode in the cycle Dehumidification Laundry Quiet The corresponding indication light will be on 3 HUMIDITY Button The humidity in the room can be automatically set when this function is selected There are four choices 50 60 70 and Continuous The corresponding indication light will be on to show the selected humidity When the unit is turned on Continuous Dehumidifying is selected automatically In this mode the unit will automatically switch off when the water tank is full or the power is turned off If one of the other selections is made then when the ambient humidity is lower than the set RH the unit will automatically stop operating HOW TO USE YOUR DEHUMIDIFIER Operational Procedures 1 Connect the power Insert the mains plug into the power socket When the power is properly connected the power indication light will illuminate Before you turn the dehumidifier on you must make sure that the air outlet is open Adjust the air outlet to the angle you want six different angles are available Press the ON OFF button and the unit will automatically start in continuous dehumidifying mode DEHUMIDIFIER Mode Press the MODE button until the indication light for this mode is lit The unit w
7. PREM I AIR DEHUMIDIFIER PDEH2020 PLEASE READ THIS USER MANUAL BEFORE OPERATING THE UNIT Please note This unit will automatically default to Laundry Mode when the temperature is 12 C and below The unit is automatically defaulting to the defrost function under these conditions It is not possible to manually change to any other mode until the temperature is greater than 12 C IMPORTANT SAFETY INSTRUCTIONS PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING WARNING This appliance is intended for use in a domestic environment only Any other use is not recommended by the manufacturer and may cause fire electrical shocks or other injury to person or property When using electrical appliances basic safety precautions should always be followed _ aN DO 12 13 14 15 16 17 18 0 1 This unit should always be kept in an upright position to avoid any damage to the cooling system Locate the unit on a flat stable surface Operate this unit in an ambient temperature between 2 C and 39 C Ensure that the air inlets and outlets are not blocked or covered Do not place the unit too close to curtains or other objects minimum distance 0 5M When the laundry mode is operated to dry clothing please keep the clothing at a safe distance from the unit to prevent water from dropping onto the unit Never place anything on top of the unit and do not cover with any kind of material whil
8. e in use This product is intended for domestic and light office use ONLY and not for commercial industrial or outside use To protect against electrical shocks do not immerse unit plug or cord in water or spray with liquids Do not operate the unit with a damaged cord or plug after it malfunctions or has been dropped or damaged in any way Return to an authorised service facility for examination and repair Never unplug the unit without switching off first as this could damage the electronic circuits in the unit Always empty the water tank before storing the unit away Always unplug the unit when not in use or moving location To disconnect from the power supply grip the plug and pull from the power socket Never pull by the cord Close supervision is necessary when any appliance is used by or near children and pets Do not run power cord under carpeting or cover with rugs or runners Arrange the cord away from areas where it may be tripped over Never operate or store the unit in direct sunlight To repair the unit take it to a qualified service engineer Repairs carried out by unqualified people may cause damage to the unit or injury to persons or property and void the warranty Where possible avoid the use of an extension cable as they may overheat and cause a risk of fire Only use an extension cord after ensuring it is in perfect condition Do not use the unit without the AIR FILTER Check the household voltage to ensure it matches
9. ill start dehumidifying and the air outlet volume will be at the moderate level LAUNDRY Mode Press the MODE button until the indication light for this mode is lit The unit will start operation in the laundry mode and the air outlet volume will be at high level which is suitable for high dehumidification or drying clothes or other articles When the ambient temperature is below 12 C a protection device in your dehumidifier will operate This engages the electronic defrost program The unit will now only operate in the Laundry mode with the fan speed at high level The compressor will operate intermittently by switching on for 40 minutes and switching off for 10 minutes The mode cannot be changed until the ambient temperature rises above 12 C When the temperature is above 35 C this program will also come into operation to protect the compressor from overheating QUIET Mode Press the MODE button until the indication light for this mode is lit The unit will start operation in quiet mode and the air outlet volume will be at low level which reduces the noise of your dehumidifier In high temperature and humidity conditions this mode should not be used While your Dehumidifier is turned ON press the ON OFF button The dehumidifier will stop operating NEVER unplug your Dehumidifier without first switching it OFF at the control Panel EMPTY WATER TANK Water tank is full If the water tank is full approx 4
10. the units rated specification before operating SAVE AND READ THESE IMPORTANT SAFETY INSTRUCTIONS BS Plug Wiring Wiring Instructions Should it be necessary to change the plug please note the wires in the mains lead are coloured in accordance with the following code BLUE NEUTRAL BROWN LIVE GREEN AND YELLOW EARTH As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows 1 The BLUE wire is the NEUTRAL and must be connected to the terminal which is marked with the letter N or coloured BLACK 2 The BROWN wire is the LIVE and must be connected to the terminal which is marked with the letter L or coloured RED 3 The GREEN YELLOW is the EARTH and must be connected to the terminal which is marked with the letter E or or coloured GREEN OR GREEN YELLOW 4 Always ensure that the cord grip is positioned and fastened correctly If a 13A BS 1363 fused plug is used it must be fitted with a 13A fuse If in doubt consult a qualified electrician Wiring for a 13 Amp Plug BS1363 Please note The Earth Terminal is marked with the letter E or Earth symbol Earth Green Yellow Neutral N Blue Brown If the supply cord is damaged it must be replaced by the manufacturer or an authorised service centre in order to avoid a hazard 2 PARTS DESCRIPTION Front Panel Air Outlet lt g
11. void damage to the unit under unfavourable your dehumidifier is unable to be switched on Do not use the dehumidifier in such circumstances Clean the air filter Remove the blocking substance from the air outlet Clean the air filter Place the unit on a firm base Clean the air filter PLEASE NOTE THE FOLLOWING Unit is in Laundry Mode and When the ambient temperature is below 12 C a protection device in your will not manually change to dehumidifier will operate This engages the electronic defrost program any other Mode The unit will now only operate in the Laundry mode with the fan speed at high level The compressor will operate intermittently by switching on for 40 minutes and switching off for 10 minutes The mode cannot be changed until the ambient temperature rises above 12 C When the temperature is above 35 C this program will also come into operation to protect the compressor from overheating The fan motor runs but the If the unit is switched on within 3 minutes after the power is turned off the compressor is not activated protective device of the unit will operate The compressor will be automatically re activated after a 3 minute delay SPECIFICATIONS Power 420W Voltage 220 240V 50HZ N W 14 2kg G W 16 0kg SERVICE amp WARRANTY Do not operate the unit with a damaged cord or plug after the unit malfunctions has been dropped or damaged For your convenience record the complete
Download Pdf Manuals
Related Search