User manual for BeSafe iZi Modular-GB
Contents
1. return cannot be claimed The guarantee is not extended through repair The guarantee expires when there is no receipt when defects are caused by incorrect and improper use when defects are caused by abuse misuse or negligence SCANDINAVIAN SAFETY HTS BeSafe as N 3535 Kr deren Norway www besafe com N20022452. BeSafe Zi Modular SIze USER MANUAL aR iZi Modular Rear amp forward facing Q gt iZi Modular RF Rearfacing only Q l Rearfacing stature height 61 105 cm l Forward facing stature height 88 105 cm Max weight 18 kg UN regulation no R129 I Age 6m 4 yrs i Size SCANDINAVIAN AFET Thank you for choosing BeSafe iZi Modular RF It is important that you read this user manual BEFORE installing your seat Incorrect installation could endanger luggage seats and or slamming doors i your child Make sure you can fit no more than one finger between the harness click gt LA and your child 1 cm i D vital information DO NOT attempt to dismantle modify or add any part to the seat Warranty will be void if non original parts or accessories are used The child seat MUST NOT be installed in a front 4 passenger seat WITH AN ACTIVATED AIRBAG Never leave your child unattended in the seat iZi Modular can only be installed on the iZi Modular Prevent the seat from becoming trapped or weighed down by Make sure all passengers are informed about how to release your child in case of emergency i Size base e Make sure luggage or other objects are properly secured Unsecured e iZi Modular is approved rearfacing for children with a stature luggage may cause severe injuries to children and adults in case of height from 61 to 105 cm with a maximum weight up to 18 kg and accidents Never use the sea
3. gnets Magnets can influence electronic equipment such as pacemakers Protect any part of the child s body which is exposed to the sun We recommend that this seat is used only for children who can sit upright usually not younger than 6 months Remove the extra seat cushion when the child is over 2 years Remove the extra side supports when the child is over 2 years or earlier when the child does not fit between these side supports anymore When the child weighs over 18 kg or the shoulder height exceeds above the highest position of the shoulder straps the child must change to a seat suitable for children with a weight above 18 kg After an accident the seat must be replaced Although it may look undamaged if you were to have another accident the seat Ps STEN DV EE may not be able to protect your child to the level to which it TAG was designed rt Hl Preparing to install e Adjustable head rest la Shoulder straps 2x 1b e Side support 1c Harness buckle 1d e Seat cushion le e Central adjuster 1f Reclining handle 19 Release handle head rest 1h Front brace 1 Installation of the seat on the i Size base 1 Check if the ISOfix and floor support indicators on the base are green 2 2 Make sure that the front brace is installed on the base The operation of the front brace is described in the user manual for the base 2 3 Make sure that the seat is always in the release p
4. osition when you want to install the seat on the base or take the seat off the base The two yellow arrows on the seat and the base must be aligned 3 Use the reclining handle to adjust the recline position see step 6 4 Position the seat in the correct position on the base untill it clicks with the base and the indicator at the front shows green 3 5 When the seat is positioned rearfacing on the back seat of the vehicle you should if possible push the front seat of the vehicle backwards so that it is in contact with the child seat 4 If it is not possible to obtain contact with the child seat push the back rest of the front seat of the vehicle forward as far as possible 6 The seat can be taken off and turned around by pulling the seat release handle at the front of the base 5 6 Make sure that the two yellow arrows on seat and seatbase are aligned this is the only position where you can take off the seat The seat should only be turned around to forward facing when the child is minimum 88 cm or 15 months BeSafe recommends to use the seat rearfacing for as long as possible 8 When the seat is positioned forward facing the front brace has to be in position 1 7 9 The seat cannot be turned around in the BeSafe iZi Modular RF This seat is only to be used rearfacing N The seat can be reclined by pulling the reclining handle at the front side of the seat 8 Ina rearfacing position the seat should only be
5. t without the cover The cover is a safety feature and may only be replaced by an original BeSafe cover forward facing for children with a stature height from 88 to 105 cm with a maximum weight up to 18 kg iZi Modular RF is approved rearfacing for children with a stature height from 61 to 105 cm with a max weight up to 18 kg Important Do not use forward facing before the child is over 15 months BeSafe recommends to use the seat for as long as possible in the Do not use any aggressive cleaning products these may harm the construction material of the seat BeSafe advises that child seats should not be bought or sold second hand KEEP this user manual for later use with the seat DO NOT use the seat for longer than 7 years Due to ageing the quality of the material may change rearfacing position The harness straps must always be locked when the child is in the seat DO NOT use at home It has not been designed for home use and The harness straps must be tightened without slack and not can only be used in a vehicle twisted e When the child seat is mounted in the car check all the areas where the child seat might touch the interior We recommend using a BeSafe protection cover in these places to avoid cuts marks or discolouration to the interior of the vehicle especially in vehicles with leather or wooden interiors If in doubt consult either the car seat manufacturer or the retailer The shoulder pads contain ma
6. the marking at the sides of the seat to use the magnets to keep the harness open while you position the child 16 When the child is positioned place the shoulder straps over the child s shoulders and close the buckle CLICK 17 Pull the harness strap through the central adjuster in the direction of the arrow straight up forwards Continue pulling until the harness is a comfortable but a firm fit 18 Removing and refitting the cover Do take care when you remove the cover as re fitting the cover is done in reverse The cover of the head rest can be taken off separately by disconnecting the beads at the back and pulling off the fabric towards the front I Warning potential misuse The child seat MUST NOT be installed in a front passenger seat WITH AN ACTIVATED AIRBAG The floor support must always be used Make sure that the floor support is fully pushed down e When used in combination with iZi Modular the front brace must be fitted on the base e Make sure the indicators are green before you drive Guarantee Should this product prove faulty within 24 months of purchase due to materials or manufacturing fault except covers and harness straps please return it to the original place of purchase The guarantee is only valid when you use your seat appropriately and with care Please contact your retailer they will decide if the seat will be returned to the manufacturer for repair Replacement or
7. used in the 2 most reclined positions 9 The leg room of the seat in rearfacing position can be made larger by pulling the front brace box out from the base The front brace box has 3 positions To adjust the front brace position the seat has to be taken off and the base should be released from the isofix 10 The seat is delivered with removable SIP side impact protection This extra side impact protection should be used on the doorside of the vehicle It can be connected by slotting between the seatshell and the fabric The seat already offers high level integrated side impact protection This extra side impact protection improves the protection in the side impact still further Not on all models 17 Removal of the seat of the i Size base 1 The seat can be taken off by pulling the seat release handle at the front of the base Make sure that the two yellow arrows on seatbase and seatbase are aligned this is the only position where you can take off the seat Positioning of the child Check that the shoulder strap slots are level with your child s shoulders 12 Pull the shoulder straps up while pressing the button of the central adjuster 13 Open the harness buckle 14 The height of the shoulder straps and the head rest can be adjusted by pulling the release handle upwards at the back of the head rest and pulling the head rest up or down 15 Position the shoulder straps over
Download Pdf Manuals
Related Search