Home
        EMO CABLE TESTER E447 INSTRUCTIONS FOR
         Contents
1. 2 CONTINUITY 3    Oo e o e oO 2 ee oO 0  l 2 3   2 3   2 3  CROSS WIRE 1 2 CROSS WIRE 2 1 CROSS WIRE 3 1    E E D C D o      amp  A Mote  On cables which show continuity tauta  l 2 3 l J E l J 5 tis possible for the cable also to be    cross wired a condition which the CABLE  CROSS WIRE 1 3 CROSS WIRE 2 3 CROSS WIRE 3 2 i  TESTER will only show after the shot has    2 E S 2 E T C     been corrected  tis therefore recommended  l 2 3 l 2 3 l 2 3 that cables are checked after repair to ensure    SHORT 1 2 SHORT l 2 SHORT 2 3 that all faults have been corrected     C G C     D e Although the table may appear a little  2 l 2 5 l    c complicated  a short time spent experimenting  SHORT 1 3 SHORT 2 3 SHORT 1 3 with the CABLE TESTER should allow the user   amp      amp  j O d to identity faults in cables without needing to    F 1 J 3   3 3 reter to the table     SHORT 1 2 3 SHORT 1 2 3 SHORT 1 2 3  O OO    O oO    O O G  3 3    l 2 l 2 l a E    LEL iit   OIPEM CIRCUIT 1 OPEM CIRCUIT 2 OPEN CIRCUIT 3                REMOTE CABLE TESTER       I 2 3        O C  FUSE TEST        Hada in Cagle boy EM CLEY STEMS LTO  Durt Gey    E M O  Systems  Crowther Road  Washington  NE38 OBW  UK   Tel  44  0 191 418 1000   www emosystems co uk  Our Policy is one of continuous development  all specifications and design details are subject to change without notice  2     
2. SYSTEMS  EMO CABLE TESTER E447    INSTRUCTIONS FOR USE    CAUTION  UNDER NO CIRCUMSTANCES SHOULD THE UNIT BE CONNECTED TO ANY EQUIPMENT WHICH IS IN  OPERATION OR CONNECTED TO MAINS POWER     Models    EMO Remote Cable Tester E447  25 447     Description    The Remote Cable Tester is a compact test set allowing the user to locate most continuity fault conditions within profes   sional audio equipment     Contents      E447 Remote Cable Tester    Dummy Plug    Test leads    Power    The CABLE TESTER is powered by a 9V battery  type 4022  MN1604  6LR61 or equivalent   Old PPS style   The battery  can be changed by removing the lid of the unit  When replacing the lid ensure that the battery lead is not trapped  Correct  operation of the battery can be established by placing a short circuit across the Fuse Test terminals and observing the  LED in Button 3  If the LED is dull or fails to light then the battery should be replaced  This should be done at least annually  to prevent any possible leakage     Cable Testing    The remote end of the cable to be tested should be located and the dummy plug inserted  The near end should then be  connected to the tester and each of the three buttons pressed in sequence  The results can be interpreted by consulting  the table overleaf     Fuse Testing    The unit will test most commonly used fuse links  Place the fuse across the Fuse Test terminals ensuring that the fuse end  caps make good contact  If intact  the red    FUSE TEST    LED will l
3. ight  Correct operation of this section may be confirmed  by placing a screwdriver across the terminals  Other items  such as theatre lamps  etc   may be tested in this way if their  connections have suitable spacing  e g  Par 64 lamps  15A round pin theatre lamps  etc     Continutity    By use of the Test Leads  continuity of external circuits may be checked and the result observed on the red    CONTINUITY     LED  Please note that the LED will illuminate  with reduced brightness  even when considerable resistance is in circuit   This section also gives an audible indication     Note  When testing cables the CABLE TESTER cannot determine where the faults actually lie  only if the fault exists  For exam   ple     In the case of a cable shown to have an open circuit  the fault could lie in either of the connectors or in the cable  itself  In these circumstances use of the continuity section of the CABLE TESTER can be invaluable  In the case of  screened cables  connection of the screen to the correct pins can only be determined by a visual inspection     E M O  Systems  Crowther Road  Washington  NE38 OBW  UK   Tel  44  0 191 418 1000   www emosystems co uk  Our Policy is one of continuous development  all specifications and design details are subject to change without notice  cy    SYSTEMS    EMO CABLE TESTER E447  INSTRUCTIONS FOR USE    Table    ee o 0O G   o G O      l 2 5 l 2 3 l 2 3 4                      This line shows a correctly wired cable   CONTINUITY 1 CONTINUITY 
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
Hisense SERO7 Tablet User Manual  Käyttöohje 2 Benutzerinformation 12 Οδηγίες Χρήσης 23  Ducane 3400 Gas Grill User Manual  Gesit GBB15 Quick Start Guide  Magnavox 42MF439B Flat Panel Television User Manual  MANUAL DE INSTRUCCIONES BATIDORA DE MANO BM 863    Copyright © All rights reserved. 
   Failed to retrieve file