Home
        Wireless Smart On/Off Switch User`s Manual
         Contents
1. C ConT20   Wireless Smart On Off Switch User   s Manual       experience tomorrow to    Introduction    The D Control Wireless Smart On Off Switch series consist of single  gang  ES SS10    double gang  ES SS20  and triple gangs   ES SS30  wall mounted switches     These elegantly designed switches not only allows you to turn  On Off fluorescent and energy saving lights  can also be used for  incandescent  amp  halogen but cannot do dimming   but also allow you  to control them remotely  e g  through walls   using the D Control  Wireless Smart Remote  BC RC50  via radio frequency     You can now operate these swithces from the comfort of  your sofa bed or create different lightning scenes   or create different lightning scenes     Connections  Connect according to the followings     L     Live In    Light1  Light2  amp  Light3   Out to Lighting loads                ES SS10       C J  pd     L      LEHTI LIGHTS  a  F  4  El JE  pL  I  ES SS20       ES SS30    3     Installation       Features  amp  Operations     1  Local Control    Press once and release the switch to toggles the lights  On or Off    2  Remote Wireless Control  You can remotely control  this switch via radio frequency using the D Control  Wireless Smart Remote   Please refer to the BC RC50  User Manual for more information   Each gang of the  switch can register a maximum if 8 numeric button  codes and 8 scene codes  whether from one or more  remotes     Registering the D Control Remote Controller  on these S
2. mart Switches     If you press and hold the switch for about 3 seconds you will  hear a beep and will enter the    setup mode     You can then  register a button from an D Control Smart Remote on it     If an error occurs during registration  you hear 4 beeps  Please  try all over again     Erasing the pre registered Remote Controller  codes from these Smart Switches    If you continue pressing and holding for another 10 seconds  after the first beep above  you will hear another beep and  would have erased completely all the pre registered remote  controller codes on this button   Please refer to the BC RC50  User Manual for more information      Specification  on off     Operating Voltage   180 250VAC    Maximum Power 1000W   per Gang  2000W   2 Gang  2500W   3 Gang    Minimum Power 5W  Rating    Humidity   Sensitivity   Frequency   Incandescent light energy saving  light nalogen fluorescent light       Specification  Dimming      Operating Voltage  180 250VAC      Maximum Power 600W   per Gang  1600W   2 Gang  2600W   3 Gang    Rating  Humidity    Sensitivity  Frequency  light halogen fluorescent light       Precaution    1  Make sure products are installed by professionals  Please  turn off all power supply before installation    2  DO NOT install in bathroom    3  Follow the correct connections as described above    4  Total power consumption of the lights in a circuit MUST  NOT exceed the maximum power ratings of the switch    5  When power is supplied to the switch for 
3. the first time   wait for 0 1 to 0 5 minutes to charge up the switch  electronics before operating it  During this period  the  lights may flicker    6  When using the wireless remote to control the switch  it  may take up to 1 5 seconds for the switch to respond    7  It is strongly recommended that lights with CE  UL    etc    be used with these switches     9  Troubleshooting Tips     Q1  Light does not turn on    A1  Check that power is supplied to the switch    A2  Check that all wirings are correctly connected   A3  Light may be damaged  please check  amp  replace it    A4  Not enough power consumption  less than 5W  for light  bulb  please change to larger one     Q2  Can   t control by Remote Controller   A1  Low batteries  Please replace with new ones    A2  Remote Controller may be out of range  Please move closer  or change to newer batteries    A3  Remote Controller   s signal is blocked or weakened by thick  or metallic obstruction  Please move to another location and  try again    A4  Please check the Remote Controller User Manual for further  assistance     Q3  Can   t set up the scene configuration   A1  Please check the scene code    A2  The scene code has been deleted  Please register the scene  code again     Q4  Damaged switch   A1  Short circuit occurred during installation  Please check the  circuit and replace with a new switch    A2  Power consumption overloaded  Please reduce total power  consumption of the light bulb     
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
Nesl: A Nested Data-Parallel Language (Version 3.1)  Establecimientos Asistenciales  Social Housing A5 Pocket guide v4.indd  10-bit Analog to SDI Converter User Manual  このたびは当商品をお買い上げいただき誠にありがとうございます。使用  Transcend Transcend 8GB DDR3 1600MHz ECC-DIMM 11-11-11 2Rx8  DU7544 DU7546 DU7549 Du7580 DU7582 DU7585  Aroma Pasta Plus  Corrigo E User Guide    Copyright © All rights reserved. 
   Failed to retrieve file