User Manual
Contents
1. S 4913T R Wireless HD Transmission System IN i EE m K OULUI IL ill e E lt Sa u hmn uam B m a o oe mn m El a pa kt User Manual Ver V1 0V01 Please read this User Manual throughout before using Preface Congratulations on your purchase of this product Please read this user manual carefully 1 All internal technologies of this product are protected including device software and trademark Reproduction in whole or in part without written permission is prohibited 2 All brands and trademarks of SWIT Electronics Co Ltd are protected and other relative trademarks in this user manual are the property of their respective owners 3 Due to constant effort of product development SWIT reserves the right to make changes and improvements to the product described in this manual without prior notice 4 The warranty period of this product is 2 years and does not cover the following 1 Physical damage to the products 2 Any damage or breakdown caused by use maintenance or storage not according to the user manual s instructions 3 The attenuation of signal quality resulting from being used in any special environments 4 Any damage caused by not powering the product by package supplied power adaptor 5 Any damage or breakdown not caused by the product s design workmanship or manufacturing quality etc2. 5 For any suggestions and requirements on this product please contact us through phone fax Email etc SWIT Electronics Co Ltd Address 10 Hengtong Road Nanjing Economic and Technological Development Zone Nanjing 210038 P R China Phone 86 25 85805753 Fax 86 25 85805296 Email contact swit cc Website http www swit cc For Your Safety Before start please follow the safety precautions below Do not try the followings 1 Unauthorized repairs or parts replacement or other operations 2 Inappropriate placement including but not limited to lighting fire exposure to rain water or gas 3 Switch to the power not in the voltage allowable range e The product 1 Do not use the products near water or in high humidity environments 2 Do not block the ventilation openings or get substances inside in order to avoid short circuit fire or electric shock 3 Switch the power off if any liquid or substance gets inside the product The power The products can be powered by battery or 4 pin XLR power adaptor When the batteries are attached to the products please make sure they are correctly and firmly locked Please use the package supplied power adapter For third party 4 pin XLR adaptor please make sure the voltage is within the specified range and the polarity connection is correct Please disconnect the power cable under the following situations 1 If you do not operate this monitor for a period of time 2 If the pow
3. In the same location it Supports 4 pair transmissions at most HDMI embedded audio transmission Support CH 1 and CH 2 HDMI audio wireless transmission Encryption Support AES 128 bit encryption to protect the transmission Portable transmitter The transmitter S 4913T is compact portable designed suitable for HDV camera installation Simple connection The wireless system is plug and play designed without any software connection and configuration Remark 1 The transmission distance may be different and depend on surroundings radio wave conditions buildings etc the 200 meters transmission distance may be not guaranteed 2 The wireless transmission might be interrupt if there re many other devices of 5GHz wireless bandwidth operated in the in the same location 3 Signal reception may be affected by the position height and angle of devices If reception video is not stable please physically adjust placement for the optimized signal 4 Set the antennas at 45 to each other will enhance the transmission efficiency 5 The product offers the AES 128 bit encryption to protect the wireless transmission Anyway please be ware of the intentional capture from third person 3 Product Instruction Transmitter S 4913T 3 Front View Rear View 1 HDMI HDMI input HDMI A type connector 2 DC 7 17V DC Power input socket Voltage range DC 7 17V Connector 5 5mm 2 1mm Pole tap Pin assign Outer negative In
4. got SDI Video output Video Fatra System fault Meanwhile the NET indicator is fast S 4913R 9 flashing as well Receiver Constant On Wireless connected with the transmitter Normal Flashing Searching the connection with the transmitter System fault Meanwhile the VIDEO indicator is fast flashing as well Fast Flashing ConstantOn Reserved function 4 System Connection 1 Check the match codes on the products The S 4913T and S 4913R with same match codes are allowed to transmit For example match the S 4913T with TRANSMITTER 801 code and the S 4913R with RECEIVER 801 code 2 Connect the HDMI video source with the HDMI port of S 4913T transmitter 3 Connect the SDI OUT port of S 4913R receiver with SDI monitor or receiving devices 4 Power on the S 4913T and S 4913R by battery or DC cable and the system will search wireless connection automatically and display OSD as Pic 1 5 After 10 20 seconds the wireless will be connected and the receiver will display OSD as Pic 2 Searching Connected to TX1 Pic 1 Pic 2 Recommended antenna position To ensure the transmission efficiency it is recommended to set the antennas at different angles See Pic 3 and Pic 4 5 Trouble Shooting If the receiver failed to output video correctly and OSD displayed as Pic 5 or Pic 6 please find the solution from following chart Connected to TX1 Please Check Video Sour
5. 1080i 60 59 94 50 720p 60 59 94 50 5 1 5 9GHz License free Wireless frequency Radio modules Max Transmission distance Latency lt ims 10W lt 6 7 Packing List y OM ui ar IMAN WA QT MM S 4913R Receiver X 1 Antenna xX 7 a TIT D tap to 5 5 2 1mm Power cable x1 Pole tap cable x1 4 pin XLR DC power adaptor X 1 SWIT
6. ce Please wait this action may take up to 60Sec Pic 5 OSD Display Possible Causes Searching Connected to TX1 Please Check Video Source Please wait this action may take up to 60Sec The transmitter S 4913T is powered off Antenna unconnected of either transmitter or receiver The transmission distance is out of effective range There re obstacles between transmitter and receiver and blocked the signal transmission There s no recognized video input at transmitter side The wireless transmission is disturbed by environment such as other electronic devices in the same location The transmission distance is out of effective range Pic 6 Check the power supply of the transmitter Fix on the antennas to both transmitter and receiver and check the connection conditions Try the wireless transmission at a closer distance Try to get rid of the obstacles or operate at a closer transmission distance Check the HDMI video source and cable connections of S 4913T transmitter See the supported HDMI format at 6 Specifications Wait 60 seconds or restart the transmitter and receiver Try the wireless transmission at a closer distance 6 Specifications 3G HD SDI output x2 Output Wireless transmitting HDMI input SDI output 1080p 60 59 94 50 l 1080psf 30 29 97 25 24 23 98 Video format l 1080p 30 29 97 25 24 23 98 The same as input HDMI format
7. er cable or power adaptor is damaged 3 If the product housing is broken eo Working Environment 1 Please don t lay this product on the unstable place 2 Please don t lay the product on metal shelf in order to ensure the effective wireless transmission 3 Please don t use the products in a place with lots of moisture soot or dust About the radio waves The products adopt 5 1 5 9GHz wireless frequency with the low antenna power specified under international and U S FCC radio wave regulations Therefore a license for radio station use is not required to operate this product 1 Product Introduction This broadcast industry wireless system includes S 4913T transmitter and S 4913R receiver adopts WHDI OFDM technology supports uncompressed HDMI wirelessly transmitted in 200 meters scale and with less than 1ms latency which is widely used in on site shooting and director monitoring 2 Features Uncompressed HDMI transmission Support up to 1080p 50 60 uncompressed HDMI wireless transmission 200 meters transmission distance In open outdoor area the effective transmission distance is approx 200 meters Less than 1ms latency There s no discernible video delay and you can use it as real time on location monitoring License free operation frequency The wireless frequency is 5 1 5 9GHZ license free operated Transmitting frequencies The system will auto select from 4 ch frequencies to ensure the effective transmission
8. ner positive 3 4 5 Installation thread 1 4 20 screw thread installation 6 LED status indicators Including Video Signal and Wireless connection condition indicators 7 Antenna The description of LED status indicator Device Indicators Status Description Constant On Wireless connected with the receiver NET Normal Flashing Searching the connection with the receiver Pact cliachin System fault Meanwhile the VIDEO indicator is fast flashing as well S 4913T Transmistter Constant On The receiver S 4913R has got SDI Video output Video Normal Flashing No SDI Video output at the receiver Eee System fault Meanwhile the NET indicator is fast 9 flashing as well S 4913R Receiver Front View Rear View 1 Power Switch the power on off 2 SDI OUT 3G HD SDI output x2 BNC connector 3 V mount power adaptor Connect the S 4913R to V mount devices and supply DC power 4 LED status indicators Including Power Video Signal and Wireless connection condition indicators 5 DC IN Power the S 4913R via 4 pin XLR adaptor Voltage range DC 8 17V Pin assign No 1 negative No 4 positive 6 V mount plate Connect V mount battery to S 4913R to supply power 7 Antenna The description of LED status indicator Device Indicators Status Description Pawar Constant On Power connected and switched on Off Power disconnected or switched off NS Constant On The receiver S 4913R has
Download Pdf Manuals
Related Search