User`s Manual of Computerized Sauna Room
Contents
1. I Ea o lt S lt S 3 T 5 e O bem g O A oO lt S _ g KD lt S SEN Tapping Screws Sey Right Slot 5 Install the Right Backboard Wet Sauna Room Tighten the right backboard and the bathtub with M4 4 screws Tighten the right slot with M4 16 tapping screws Tighten the left slot and the right slot with M4 16 tapping screws Please refer the Glass Door Structure for the connection method Tapping Screws Install the Backboard Wet Sauna Room i N Ra Oo Vi Insert the glass door into the left and right slot with the reference to the j glass structure NOTE All spare parts should be properly positioned go Turing Screws M4 16 Q 7 Install the Top Cover Main Body Installation Place the top cover on the backboard and slide rail connect it with the Screws M4 45 i i i i backboard with M4 45 screws and connect it with the slide rail with M4 16 screws Tighten all the screws in order with even force After finishing installation please apply glass glue at the connections for preventing steam leakage and reduce the steam temperature2. II HI IV VI User s Manual of Computerized Sauna Room M 8251 Turn on the cool and warm water input tap If there s water input into the computerized sauna room then many functions of it won t be available Connect the power supply 220V The power supply plug is equipped with leakage protection device If the power is connected the red indicator lights if the red indicator doesn t light please press the rectangle button if the red indicator remains dark it means the power supply is not available please replace the plug If the red indicator turns off after pressing the round yellow button it means the leakage protection is in good condition if the red indicator doesn t turn off please replace the plug Turn on the general power supply Press the General Power Switch ON OFF the screen will display all the indicators in 2 seconds and the computer will start self checking in 3 6 seconds the enter into the state of stand by Turn on the radio system if there s in calls the system will automatically notice 1 Turn on the radio Press FM for the radio state the speaker makes sounds Search for channels Press Frequency or Frequency to adjust the frequency of the radio 0 1MHz by each press press it for 1 second the system will automatically search the channels when find some channel the system will automatically stop in this band 2 Adjust the volume Press the Volum
3. e or Volume to increase or reduce the volume 3 Turn off the radio Press the FM button again to turn off the radio system immediately Turn on the lighting device Press the Light Button to turn on the light and press again to turn off Turn on the ventilation system Press the Ventilation Fan the screen will display the symbol of ventilation and the ventilation fan works press it again to turn off VII The use of CD audio function 1 VIII Connect the CD signal Connect the CD input plug in the computerized control box with the audio output terminal of the CD unit Press the CD Button The screen will display the CD symbol and the speaker plays CD music Press the Volume or Volume to increase or reduce the volume Press the CD button again to turn off CD function The use of sauna Time setting Press Time Setting button the screen will display the digits press the Time or Time button to set the sauna time the adjustable range is 5 60 minutes Under the normal circumstance it is preferred to set 15 minutes Once time is up the system will automatically cut off steam Temperature setting Press Temperature Setting button the screen will display the digits press the Temperature or Temperature button to set the sauna temperature the adjustable range is 35 60 C When the temperature reaches the set value the s
4. id Installation Size Water Out CY Hole 960 i Plane Size Glass Door Structure of MA 8251 Left Slot Tapping Screw Left Slot t H q ee a Installation Sketch of M 8251 In order to make you to correctly safely and conveniently install this product we divided the installation of the sauna room into several steps with detailed illustration and explanation Please install the product in accordance with the showed steps to achieve satisfied effect I Adjusting the foot bolts As the floor in the washing room may be possibly uneven it is required to move the bathtub body to the best position and adjust the bolts on the button of the body Make sure the body is parallel to the floor Check the body with gradienter and tighten the bolts 2 Install the Back Left Backboard Dry Sauna Room Tighten the back left backboard with the bathtub with M4 45 screws Tapping Screws Name Computerized Room Diagram No 8 27 Model M 8250 Reviewed by Design Date 2003 8 27 Drawing Liu Gangcheng Rainbow Sanitary Appliances Factory 3 Install the Left Backboard Dry Sauna Room Bw 3 oO H Q N un tT lt S 3 O 5 S I Oo oO Ee S 3 T 5 8 Q I a aw oO oO lt S _ g oO Men A 4 Install the Front Board Dry Sauna Room Bw 5 H Q n un z lt S 3 O lt S _
5. king press the Telephone button again to ring off X The use of remote control function The functions of the buttons on the remote controller are nearly the same as the buttons on the control panel But the remote control shall aim at the control when operating the specific functions are shown below Temperature button only for rising the temperature press once to increase 1 C the adjustable range is 35 60 C it can be set circularly Time button only for rising the time press once to increase minute the adjustable range is 0 60 minutes Radio button after finding one channel press SAVE button and then press 1 9 digit button to store the current channel in the corresponding digit for getting the stored channel turn on the radio and press the corresponding digit to reach the channel XI Turn off the computerized control system XII Press ON OFF button to turn off the screen the water tank will automatically drain out the water for 3 minutes finally the system will automatically cut off 220V power supply XIII XIV Notice Do not power on for long if the sauna won t be used for a period the power plug shall be unplugged Some unavailable functions shall be covered with insulation materials for preventing leakage For example packing the pressure pump connecting wire with isolation materials For the sack of your safety make sure the earth line of the sauna
6. room is well connected The use of massage system Insert the power supply plug power on the plug is equipped with leakage protection unit Turn on water supply 3 Turn off the drainage valve Turn on the cool and warm water valve big round handle and adjust the water temperature Adjust the switching valve small round handle to achieve the following functions A Bathtub water input Sparker bathing movable Top sparking Up and middle acupuncture massage and sole massage mg aw Lower acupuncture massage and sole massage After the water reaches the lowest level the nozzle is just submerged press the Air Start switch The nozzle starts to surf and the lamp in the bottom of the bathtub lights up Press the Adjust switch to adjust the massage force Press the Air Star switch to stop massage Turn on the water out valve to drain out the remained water the water valve consists of kick type and rotating type the kick type water valve requires to press the valve cover to drain out the water the rotating type water valve requires to be switched for 90 C For the sack of your safety make sure the earth line of the sauna room is well connected M 8251 Computerized Room Double Person Room OR arn Socket CD Socket Water Out 1200 eg if Hole Water Out Power Supply Hole i 12A 75 Cool Water 2 4 1600 ov Water Out Hole 60 Sol
7. ystem will automatically cut off steam when the temperature is lower than the set value at 2 C the steam will automatically recover Press the Steam button the screen will display the steam symbol and the steam will be generated in 1 minute the water tank will automatically input water when the water input amount reaches the set value it will automatically stop water in and automatically supply in case of inefficiency water 4 Press the Steam button again to cut off steam 5 Protection functions A After turn of steam if there s no water in the steamer or inadequate water the steam symbol on the screen will flash and the steam function will be automatically turned off thus protecting the unit B If the steamer is in fault or the temperature of the unit is very high the steamer will automatically cut off power supply IX The use of telephone function i Make a call 1 Connect the telephone line Press the Telephone button the screen will display the telephone symbol 2 Press the 0 9 digit button to input the telephone number 3 After telephone talk through the control panel 4 5 Adjust the volume by pressing the Volume or Volume button After finishing talk press the Telephone button again to ring off ii Receive a call When the telephone is ringing press the Telephone button and talk through the control panel after finishing tal
Download Pdf Manuals
Related Search