calibration instructions for the Ford Traffic Pro II
Contents
1. Distance driven and installation time required may vary with type of vehicle and local conditions After successful calibration TrafficPro II will be ready for operation and the main navigation menu will be available See Service Mode for setting the time and measuring units Service Mode To check various functions and settings or to recalibrate the system enter the Service Mode 1 Ifthe system has not been calibrated yet calibrate the system now see System Calibration on page 44 or go to step 4 If your notin the US EASTERN time zone do the following e Press the CLOCK button for more than 2 seconds and set the radio clock to your local time zone To do this press the TZ button and select your timezone from the list See further instructions in the user guide under Time Zone Selection Press the right knob to confirm changes in the clock settings menu Switch to the NAVIGATION screen by pressing the NAV button You may need to confirm receipt of the warning confirmation again Press the NAV button again to access the settings menu It is recommended at this point to Select MEASURING SYSTEM to select between U S or METRIC Canada The service menu is only available from the settings menu or from the CALIBRATION screen Press and hold in the third multifunction key and then press the fifth multifunction key to access the Service Mode Select a function test by turning the right knob and then2. The number displayed under Speed does not represent miles or kilometers per hour The number should change only while the vehicle is moving Under all other conditions the number should not change The direction of the arrows will change when the vehicle s gearshift position is changed to reverse NOTE If the numbers under Speed do not change check the speed signal hook up and connection in SocketA Ifthe direction of the arrows do not change check the reverse signal hook up and connection in SocketA See page 7 for wiring diagram The GPS receiver of your TrafficPro II requires an initial download of the most current GPS satellite information almanacs To do this park the vehicle in an open area away from buildings ensuring the GPS antenna has a clear view to the sky e NOTE Leave the system turned on Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E945 AA Copyright Ford 2002 Cs Installation Instructions e NOTE DO NOT move the vehicle during the following downloading procedure which may require 15 minutes or longer 4 Check for the GPS status messages to appear on the right of the display screen GPS ANTENNA ERROR The GPS antenna is improperly connected or defective Check the connector on the backside of the unit and the antenna cable GPS MODUL ERROR This message may be displayed while the GPS almanacs are downloading and should appear for no longer than one minute befo
3. 02
4. 1 to 0 For the internal sensor test drive around a curve The values following X and Y must change To exit the sensor test and return to Service Mode press the NAV button Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E945 AA Copyright Ford 2002 Cs Installation Instructions Service Menu SPEECH TEST Select SPEECH TEST to activate a voice test The words Please insert Navigation CD will be heard Press the knob to hear the words again To exit the SPEECH TEST and return to Service Mode press the NAV button Service Menu DEMO MODE Select DEMO MODE to demonstrate use of the system Select ON by pressing the knob briefly and then pressing and holding the knob in to confirm your selection Enter a destination as described in the user s manual To exit the DEMO MODE cancel active route guidance and follow the steps to re enter the Service Mode Select DEMO MODE and then OFF Service Menu VERSION Select VERSION to display the version of the navigation software or the last used navigation CD TROUBLESHOOTING Software reset Press the first and third multifunction buttons and the TP button at the same time An internal software system restart reset may be necessary if the unit malfunctions or becomes inoperable Hotline http www trafficpro2 com or 1 800 422 8027 Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E945 AA Copyright Ford 20
5. 945 AA Copyright Ford 2002 Cs Installation Instructions NEW or USED TIRE TREAD Then select between NEW TIRE and USED TIRE using the knob Press the right knob to confirm If tire data corrections are needed select MODIFY again to enter the correct data and then press the right knob to confirm Choose the entered data with the right knob and press the knob to confirm The unit will restart and be ready to navigate Service Menu CALIBRATION RIDE Select CALIBRATION RIDE to check the calibration status e g Status 2 and the type of positioning e g 3D After calibration WHEEL and REVERSE on the display will be replaced with the street name where you are currently driving provided the area is digitized Status 1 Navigation not available Status 2 Navigation available but navigation announcements may not be as timely as Status 3 Status 3 Navigation available at optimum accuracy Service Menu MODULE TEST Select MODULE TEST to activate a test of the internal components of the navigation system If OK is displayed press the NAV button to return to Service Mode Service Menu SENSORS Select SENSORS to activate a test of the speed signal reverse signal and internal sensors e For the speed signal test drive the vehicle several yards forward and backward The number following WHEEL will change while the vehi cle is moving In reverse gear the number following REVERSE will change from 0 to 1 or from
6. Cs Installation Instructions Initial TRAFFIC PRO Il Start Up Following the installation of the system reconnect the vehicle battery DO NOT insert a navigation CD Start the engine Press the ON button located on the TRAFFIC PRO II faceplate Enter the five digit security code using the first through the seventh a ae multifunction keys mler Cocke Humber pe e Ifan incorrect code number is entered one or two times the Enter oM I T Code Number prompt for re entering the code will appear on the display If incorrectly entered a third time Code Wait will appear and the unit will be blocked for 10 minutes Three further incorrect Cerje entries will lock the unit for an additional 10 minutes i The locking time will elapse only while the unitis on Keep the Code Card in a safe place apart from the vehicle to prevent unauthorized use of this system Attach the sticker provided to the inside of the vehicle s windshield or a window If Traffic Pro Il is disconnected from the power supply it will be theft protected upon reconnection After turning the ignition key the display will show Enter Code Number Initial Sensor Test and Global Positioning System GPS Start Up Press the first and the last multifunction keys at the same time The initial sensor test and GPS menu will appear on the display Drive the vehicle forward and rearward for the speed signal and i l t l T TT i reverse signal function test
7. anguage with the right knob and press the knob to confirm your selection Then select a voice either male or female with the right knob and press the knob to confirm your selection Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E945 AA Copyright Ford 2002 Cs Installation Instructions 5 Press the right knob again when the screen asks for language confir mation After this confirmation should a change in language selec tion become necessary follow the directions in the user s manual Warning Confirmation Disclaimer Confirming the receipt of this warning message indicates that you have read and understood the user s manual and that you are aware of the dangers associated with the use of this navigation equipment You must press the right knob to confirm receipt of this message before continuing with the installation procedure System Calibration After the GPS initialization is complete a calibration ride is required e Wait for the CALIBRATION screen to be displayed following the installation of the navigation software If the CALIBRATION screen doesn t appear the unit is already calibrated In this case erase the calibration as described in SERVICE MODE CALIBRATION DELETE If the unit is switched off during calibration the system will request language selection again when switched back on Anavigation CD is not absolutely necessary during calibration However without t
8. he CD the location will not be displayed It is possi ble to insert an audio CD or to listen to the radio during calibration Press the NAV button to switch back to the calibration menu The calibration ride can be performed in a non digitized area During the calibration ride the speed signal GAL will adapt to the vehicle specific data and the gyro sensor will adapt to the installation position of the unit The CALIBRATION screen may show CALIBRATION RIDE NOT POSSIBLE if the GPS FIX is not 3 D Move the vehicle to aless obstructed area for better reception After a GPS 3 D FIX is available the CALIBRATION screen will switch to CALIBRATION RIDE CAN START Drive the vehicle 200 300 yards in a straight line Then turn right or left 60 or more and drive for another 200 300 yards in a straight line Again turn and drive until the main navigation system menu appears on the display The quality of calibration will not be affected if the vehicle is not driven exactly as stated above However the calibration process will take longer Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E945 AA Copyright Ford 2002 Cs Installation Instructions The display will alert you to inadequate GPS reception With a 3 D FIX the calibration process is shorter in time and driven distance than a 2 D FIX With a 1 D FIX the calibration process won t finish and the mounting of the GPS antenna must be rechecked
9. ncorrect values Select MODIFY and press the knob to confirm to manually input settings CALIBRATION VALUES Select CALIBRATION VALUES and press the right knob to confirm UNIT ROTATION Select the degree of unit rotation by turning the right a knob and pressing it to confirm Unit rotation corresponds to horizontal ene iat okie rotation A positive value indicates a rotation of the front of the unit toward the left UNIT INCLINATION Select the degree of unit inclination by turning the right knob and pressing it to confirm A positive value for unit inclination indicates that the front of the unit is higher than the back WHEEL IMPULSES Select the number of wheel impulses per wheel revolution by turning the right knob and pressing it to confirm If this value is not known select UNKNOWN If any data corrections are needed enter MODIFY again to re enter the data and then press the right knob to confirm Confirm the correctly entered data by turning the right knob to select and TUM 0 INCLE 0 then pressing it to confirm f INPUT TIRE VALUES Once the previous settings are confirmed enter the tire data after selecting INPUT TIRE VALUES using the right knob Enter the tire size with three digits between slashes Use 0 for a place holder and for R For example tire size 185 55R15 should be input as 185 055 015 Press the right knob to confirm Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E
10. pressing the knob to confirm your selection The following functions can be selected in Service Mode GPS INFO e SENSORS CALIBRATION e SPEECH TEST CALIBRATION RIDE DEMO MODULE TEST e VERSION Subject to correction and technical modifications 2L2Z 18814 NAV SK2L2J 10E945 AA Copyright Ford 2002 Cs Installation Instructions Service Menu GPS INFO This is a function test of the GPS antenna If functioning properly with adequate GPS reception the number of satellites received e g S 5 the date and time e g 31 01 02 16 45 and the type of positioning currently possible or FIX e g 3D will be displayed To exit GPS INFO and return to Service Mode press the NAV button Service Menu CALIBRATION Deleting the Calibration If the TrafficPro II system is removed from one vehicle and installed in another it must be recalibrated The GPS almanacs are lost because the unit was disconnected from the battery It is necessary to delete the old calibration data and to repeat the initial sensor test and GPS startup DELETE Remove the navigation CD select DELETE and press the right knob to confirm The unit will now restart Return to Initial Sensor Test and Global Positioning System GPS Start Up in this installation guide MODIFY Changing the Calibration Manual calibration is recom mended only if you know the exact values of the vehicle The navigation system cannot function correctly if itis set with i
11. re GPS WAIT appears If GPS WAIT does not appear contact the hotline at 1 800 422 8027 for advice GPS WAIT The GPS reception is not currently available F 1 indicates actual date and time UTC has been received but no position has been determined Continue waiting until GPS OK appears on the display If the number values do not begin to increase within five minutes check the position of the GPS antenna and of the vehicle GPS OK GPS reception is available e F 2 indicates a two dimensional positioning F 3 indicates a three dimensional positioning e S indicates the number of satellites received and et i t te e ALM indicates the number of downloaded almanacs p A After GPS OK appears or ALM shows more than 22 satellites this menu will switch to radio mode after 2 minutes You may also press the first and the last multifunction keys at the same time to exit this menu Installing Navigation Software 1 Press the NAV button located on the TRAFFIC PRO II faceplate to enter Navigation Mode Insert the Navigation CD Eastern USA or Western USA into the slot Several activation messages will appear on the screen Asoftware installation bar graph may appear This screen may be displayed in the default language IMPORTANT WARNING DO NOT disconnect the unit from power during this process Should it become disconnected from power contact the hotline at 1 800 422 8027 for advice on how to proceed Next select a l
Download Pdf Manuals
Related Search