User Manual For Jump
Contents
1. terminal 3 Start the vehicle 4 When the vehicle starts disconnect red and black clamps from the vehicle battery terminals within 30 seconds 1 2 3 F Warnings Make sure the indicator is green or yellow when jump starting the vehicle DO NOT jump start the vehicle if the light is Red 2 DO NOT connect the clamps to the wrong terminal Otherwise it may damage the jump starter and the vehicle battery 3 Always check if the jumper clamps are well connected check if the vehicle battery connector is rusted or dirty clean it before jump starting the vehicle DO NOT jump start again after 3 attempts Otherwise it will damage the jump starter Make sure to check your vehicle if it has other trouble 4 Charge mPower JUMP when the indicator is RED color 5 DO NOT connect the two clamps Otherwise it may be dangerous 6 DO NOT disassemble the jump starter Otherwise it may be dangerous H TOXIC AND HARMFUL SUBSTANCES aE and amount of toxic and harmful substances in jump starter eam Pate O Indicate all homogeneous materials hazardous substances content are below the MCV limit specified in the Standard 2002 95 EC RoHs Always take care when using the appliance This appliance is not intended for use by young or infirm persons without supervision Do not use as a toy Do not allow the appliance to become wet Do not immerse the appliance in water S Do not operate the appliance in explosive atmospher2. MmMpaowJjer Pechnologies ER MANUA Thank you for choosing the mPower Jump Always follow basic safety precautions when using electrical appliances Read all instructions carefully Please keep this instruction manual for easy reference Model mPower JUMP A Product Layout battery indicator light _ __ 14V1A Input Port p j T Switch on battery indicator ight _ Battery clamps B Technical Specifications Operating temperature 20 C 60 C 4 F 140 F za00syeles C Parts list 1 Jump Starter 2 100V 240V home charger 3 User manual D Indicator Instruction Press the switch and check the battery storage level according to the color of indicator Indicator Color Red Yelow Green Storage level Low Battery Half Battery Full Battery E Charging for jump starter itself Use the home adaptor to charge mPower JUMP while the indicator is YELLOW or RED color 1 Plug the home adaptor into the wall socket 2 Connect 14V1A Input port of mPower JUMP to the other end of home adaptor F Jump start 12V vehicle instruction Follow the instruction as below when your vehicle can t start because of low battery dead battery or low temperature 1 Press the switch and check the indicator color make sure the light is GREEN or YELLOW 2 Connect the RED clamp to the vehicle s positive battery terminal and connect the BLACK clamp to the vehicle s negative battery
3. es such as in the presence of flammable liquids gases or dust ii m Do not modify or disassemble mPower JUMP Only a repair technician may repair this unit Do not expose the appliance to heat X Do not store in locations where the temperature may exceed 158 F Charge only at ambient temperatures between 32 F and 140 F Charge only using the charger provided with the appliance Under extreme conditions battery leakage may occur Carefully wipe the liquid off using a cloth and avoid skin contact when you notice liquid on the batteries In case of skin or eye contact rinse immediately with clean water and seek medical attention At the end of their useful life discard the appliance with due care for the environment and in accordance with government regulations 1 WARRANTY INFORMATION 1 We offer a limited warranty for this product against any defects in material and workmanship for a period of 6 months from the date of purchase by the end user consumer The conditions of the warranty are as follows 2 The warranty is only valid upon presentation of the original receipt from dealer retailer by the original purchaser with the product to be repaired or replaced 3 The warranty is void if the serial number date of purchase and label has been removed or tampered with 4 The warranty does not cover damage or product failure resulting from normal wear and tear physical abuse improper in
4. stallation misuse modification or repairs by unauthorized third parties 5 We do not assume responsibility for any loss or damage incurred during shipment or as a result of a force majeure 6 We are not liable for any incidental or consequential damages arising from the use or misuse of this product 7 All warranty claims are limited to repair or replacement of the defective product and at the sole discretion of mPower Technologies Inc 8 If we repair or replace the product the product will be covered for the remaining time of the original warranty period Repair or replacement may involve the use of reconditioned units which are equivalent in function Replaced part or product becomes the property of mPower Technologies Inc 9 Consumable components such as batteries are not covered by the warranty mPower Technologies Inc 587 Connecticut Ave Norwalk CT 06854 1 877 674 2738 Applied Standard GB T 16287 2000 The product is insured by Everest
Download Pdf Manuals
Related Search