Home

Label

1. e The screw threads on the cap and the bulb should be free of obstructions e The application tip should be securely attached to the hole in the top e Inspect the application tips and extensions for cracks Optional Identification Label Suggested Uses This delivery system can be used to apply dust and granular formulations of pesticides Application sites include exposed surfaces cracks crevices structural voids and rodent burrows and runways Specialized tips and extensions are included to assist in plac ing dust or granules in pest harborages Problem Leaking dust or granules from the bulb Solution Inspect bulb for damage producing cracks and leaks replace bulb 22055650 Inside the parts bag is an Optional Operati ng nstru ctions Identification Label You may want to apply this to help better identify Filling Bulb the Dust Bulb in the field It can be applied in the location shown e meee protective materah aia by the pesuelve label right To obtain the best adhesion e Maintain the bulb upright during filling and capping of this label please clean the area e Do not use more than 6 ounces of dust or granular insecticide with alcohol or a similar solution in the bulb before placing label on the bulb e Add the insecticide to the bulb with the aid of a funnel to pre vent spilling e Hand tighten the cap on the bulb before application Remaining Dust or Granules e Unused pesticide in the
2. bulb should be removed prior to long term storage of the Bulb DustR Empty bulb contents into the 135 REGION SOUTH DRIVE JACKSON GA 30233 original pesticide container Toll Free 800 544 8811 Phone 678 688 5601 95138447 Rev 6 10 www bgequip com e Fax 678 688 5633 equipment company
3. BULB DUST R MODEL 1150 ED USER S MANUAL Safety Precautions Care and Maintenance e Use the cap on the delivery tube when bulb duster is not in use e Clean bulb with a nylon brush and with soap and water e Inspect the cap and application tubes for cracks inspect bulb for damage e Replace bulb if damaged and cap if it is cracked or broken e Do not fill the bulb with any liquid or gel e Remove top slowly and without squeezing the bulb e Do not transport the bulb duster without the cap in place e Direct dust or granules only at surfaces to be treated e Use only E P A approved dusts and granular formu lations e Follow label directions and wear recommended protection e Do not expose bulb to solvents or extreme heat Irouble Shooting Problem Dust leaking around the cap or application tips Solution e Hand tighten the cap e Tighten the tip attachments e Replace cap 22055651 if cracked or broken e Replace tip 22058500 or plastic ex tensions 95150905 if cracked Problem Not enough dust or granules delivered Solution Rotate the bulb to loosen the contents tilt the bulb slightly forward e Add marble or bearing in bulb to reduce dust or granule clumping B f S t rti e Add more dust or granules to bulb ctore a INQ Problem Too much dust or granules delivered e Inside of the bulb should be dry and free of Solution e Reduce the amount of pesticide in bulb obstructions

Label

Contents

Download Pdf Manuals

Related Search

Related Contents