50097-456 Rev A
Contents
1. Refer to User Manual for more detailed instructions iih a TM Wa a Ca Pre filter Replacement DSD EDGE Verify both stations are idle before performing this procedure CLOSE Incoming Water Line OPEN Internal Water Supply Valve e Press the SETUP button Press 43 on the keypad then press ENTER This will open the incoming water supply solenoid valve providing a water supply to the on board 0 2 micron filter housing Note A counter on the LCD display will begin to count down from 250 to 0 in one second increments After 250 seconds the incoming water supply solenoid valve will automatically close if not manually closed sooner DRAIN Purge Line e Direct the purge line from the top of the on board 0 2 micron water filter housing into a container that holds a minimum of 1 liter of liquid e Slowly open the shut off valve located on the purge line from the on board 0 2 micron filter housing until the air is purged from the filter housing and a steady stream of water flows from the purge line e After closing the air bleed valve tap the purge line to promote the draining of the residual water within the purge line into the container e Remove the container and empty e Press the STOP button to close the incoming water supply solenoid valve and then press the STOP button again to exit the SETUP menu REPLACE Pre filters e Use the filter wrench if necessary to remove the pre filter housings e Wearing gloves remove and2. discard the filters e Clean housings using soap and water and then rinse thoroughly e Replace the corresponding filter s e Replace the filter housings You may need to moisten the O ring located at the top of the filter housings with a water based lubricant Make sure that the O ring is at the top and in place in the top of the housing e Hand tighten the filter housings DO NOT use the filter wrench MICRON MICRON OPEN Incoming OPEN Internal Water Line Slowly Water Supply Valve e Follow the instructions in Step 2 DRAIN Purge Line CHECK For Leaks e Follow the instructions e f a leak is found close the incoming water supply line in Step 3 and hand tighted the housings again e Open the water line again and check for leaks This Quick Start Guide supplements but does not replace the information provided in the DSD EDGE Endoscope Reprocessor User Manual which came with your reprocessor Endoscope reprocessing the way it should be M D IVATO RS www minntech com medivators 1 800 444 4729 2010 Minntech Corporation All Rights Reserved 50097 456 A
Download Pdf Manuals
Related Search