Soundelux E47 User`s Manual
Contents
1. Place E47 microphone securely in shock mount 3 Insert FEMALE end of 6 pin Tuchel cable provided with microphone into microphone Try to provide some strain relief loop when lacing cable on mic stand Do not stretch or make the cable taught 4 After cable has been laid out with plenty of slack and not in a heavily trafficked spot insert MALE end of 6 pin XLR cable into power supply 5 Verify that monitor loudspeakers are muted or that signal path does not allow monitoring of microphone during power up 6 Connect audio output Male XLR 3 with user provided cable to console or microphone preamplifier 48v phantom need not be applied nor will it damage the microphone but we recommend it not be applied if possible 7 Verify that rear panel power switch is set to off and connect IEC 320 compatible AC power cable provided with mic to power supply then wall AC outlet 8 Apply AC power Allow 1 minute before allowing monitoring of microphone For optimum performance allow the microphone to warm up for at least one hour If you follow the above steps always use a pop filter for vocals always store your E47 in a plastic bag and don t drop it your mic will have a long happy life The E47 uses a lightly damped capsule mount therefore is subject to damage from excessive handling It is also sensitive to rumble so use care in mounting placement and facility studio location Some users may find high pas filtering necessary to re2. Soundelux E47 User s Manual YOUR E47 has been shipped to you in CARDI OI D ONLY MODE The Soundelux E47 is a high quality variable directivity studio condenser microphone using vacuum tube electronics As such it requires its own proprietary power supply and cable The microphone s audio output is standard male XLR 3 pin at the power supply with positive excitation of the diaphragm at the front of the mic resulting in a positive voltage at the output XLR s pin 2 Audio output is transformer balanced CAUTION Shock Hazard Do not open microphone when connected to power source VORTI CHT Schok gefahr Bitte nicht daf mikrofon offen wenn es eingeschaltet ist in einen stoppkontakt ATTENCI ONE Choc hazard N ouvrez pas le microphone quand il y a un connectionne avec un source d eletricity ATTEZI ONE Riscchio di scossa Non aprire il microfono quando e attacato al eletricita 1 DO NOT CONNECT MICROPHONE WHEN AC POWER IS APPLIED TO POWER SUPPLY 2 DO NOT HOT SWAP POWERED MICS AND SUPPLIES 3 DO NOT swap mics and supplies Each supply has been optimized for that mic The following procedure must be followed when setting up the microphone 1 With no power applied and no connections made determine which AC Mains voltage is relevant to your location and be sure it matches the voltage indicated on the P95 power supply The mains voltage is factory preset and should only be changed at the factory 2 Attach shock mount to stand
3. move unwanted rumble from program Your E47 should be used anytime strong proximity effect and smooth tube transients are required If you would like to switch your mic to multi pattern operation E47 Pattern Change Directions from Fixed to Variable Single Capsule vs Dual Capsule Operation Modes 1 Remove 3 screws that hold headgrille assembly to body assembly Remove the headgrille assembly which contains the capsule 2 Remove single screw that holds the body tube in place Pull the body tube from the body 3 See metal plate with 2 position switch above vacuum tube area Flip switch the other way forward for variable pattern dual capsule mode or backward for Fixed Cardioid single capsule mode The words Variable Pattern and Cardioid are printed on the circuit board 4 Replace the body tube replace screw 5 Install Headgrille assembly by slightly tilting Headgrille backward so the guide pin goes into the guide pin hole then insert the connector on the headgrille to the socket on the top of the body re install the 3 screws that hold the headgrille to the body
Download Pdf Manuals
Related Search