Users Manual
Contents
1. POOnnCHCON Model DB10L Installation of 9 volt Alkaline Battery Your Door Beacon is powered by a 9 volt Battery purchased separately Use only Alkaline Battery The battery compartment is located in the bottom of the unit To remove the cover push in the direction of the arrow Connect 9 volt battery to the terminals Position battery into the recessed compartment and replace the cover To mount unit on the door Unit should be positioned on the inside of the door of the room you will be in An Over the Door Hanging Bracket is included that allows you to easily hang your Door Beacon on any standard door It also allows the convenience of moving the Door Beacon to a different door Insert Hanging Bracket from bottom as shown Your Door Beacon can also be hung in place on the door by installing a screw where you want the unit positioned Position high onto door at eye level Hang the Door Beacon onto the screw by using the hole on the molded bracket at the back of the unit To attach the Door Beacon to the door with the supplied Velcro separate the two Velcro pieces by pulling apart Attach the thick plush piece of the Velcro to the inside of the door after removing the paper backing Press the adhesive side firmly against the door Secure the other section of Velcro to the back of the Door Beacon unit first removing the paper backing and then pressing the adhesive to the unit The Door Beacon can then be sec2. other countries contact us for a quote Send unit to GLOBAL ASSISTIVE DEVICES INC 1121 East Commercial Boulevard Fort Lauderdale FL 33334 Disclaimer In no event shall Global Assistive Devices Inc be held liable for any special incidental indirect or consequential damages whatsoever including but not limited to damages for loss of property personal injury loss of privacy failure to meet any duty negligence and any other loss whatsoever however caused even if Global has been advised of the possibility of such damages This disclaimer of liability applies to any damages or injury including but not limited to those caused by any failure of performance of the product Responsibility for selection safety and suitability of any product rests with the consumer Circumstances or consequences arising out of or in any way related to the use of or inability to use our products is the responsibility of the consumer Global Assistive Devices Inc cannot be held liable in any way
3. ured by pressing the Velcro on the unit against the Velcro on the door Attach Velcro on back as shown To use the Hi Lo Off Sensitivity Switch The switch on the side of the unit marked H L and O allows for user adjustment In the H High position the sensitivity to the vibration of a knock is greater This would be used on a thick heavy door as an example A thinner lighter door might best have the switch in the L Low position because of lower sensitivity Adjust the switch to suit your personal requirements to achieve maximum results It is suggested that the unit be turned to the O OFF position when not in use When unit is in the OFF position the light will not flash Before sending for Service If your Door Beacon ceases to operate check amp replace the battery if required ONE YEAR LIMITED WARRANTY Your DOOR BEACON is warranted to be free from defects in material or workmanship for one year from the date of purchase This warranty does not apply to any unit that has been subject to misuse negligence of accident At its option Global Assistive Devices Inc may select to replace the entire unit rather than repair it For Service return the device with dated proof of purchase in a secure package insured and shipping prepaid Please include a note describing exactly what is wrong with the unit Include 9 95 check money order Visa Master Card Discover or American Express for return Shipping within the U S A
Download Pdf Manuals
Related Search