USER MANUAL
Contents
1. on the side of Grounding 6 Fixing Splice Tray If the OSP cable has a metallic Terminal wire to Rack earth bar sheath and tension member insert Fixed splice STI 24 6 to the the tension member into the ground rear door with bolt M3 ee and tighten it Using a screw river Note Grounding procedure cannot be skipped for safety reasons VISSEM FDF M0112C0521 VSOF FDF RM 48 USER MANUAL ea 7 OSP Cable Routing 8 Pigtail insertion 9 Optical Fiber Splicing After the cable termination protection Insert each 6pigtail cords each 0 9 Place the loose tubes 25mm Check the color of fibers and remove tubes are routed into the swing out mm into a provided 25mm protecticontaining optical fibers on the coatings module on tubes to make a cord unit for easplice tray inlet and fasten them Cut the fiber using an approved fiber sy identification tightly using cable ties cutting method Splice fibers using an approved fiber splicing method i ee B 10 Splice Storage 11 Record index card 12 Patchcord Connection 15 Completion of Work When the splicing is completed After record the contents of works Connect patchcords on the Pull out the patch cords toward the system insert sleeves into slits accordingly on the cover of splice tray close opposite side of adapters through the reserved holes the cover of splice tray a k z After the completion push the module Record the splicing list on the ca2. FDF Fiber Distribution Frame TET Swing Out Module VSOF FDF RM 48C 1 Ground terminal fixing 2 Mounting Place two plastic washers on each Mount Swing out Modules SJOF FD side and attach the grounding termi F RM 48C on a 21 open rack or a nal on the real panel cabinet using an approved installation method Note You can move the Mounting tabs to the middle to mount the module on a 19 rack COMPONENTS SJOF FDF RM 48C ITEM QTY i Sheath Steel band 2 each poe eath removing Protection tube OSP 2 each 1000mm Protection tube Cord 5 each 25mm _ _ _ i Splice Tray STI 24 6 1 each per 24 cores Cable tie 12 each Ground Terminal set 4 each ae User manual Leen 3 OSP Cable Preparation Remove the sheath from the marked Cut off about 1m from the end and point using a sheath stripper mark the stripping point using a tape optional at a 150cm point from the cut end ae 2 Remove plastic tape and dummy Leave cm from the Cable Sheath Insert fibers into the colored Prote 4 OSP Cable Clamping n fillers end and cut off the Tension Member ction tubes Push the protection tup ecure the cable to the rear side of Clean the loose tube using jelly Leave 5cm from the Cable Sheath up to the loose tube end the shelf with a provided steel band cleaner end and remove loose tubes using a loose tube cutter 5 Ground forminal fixing Connect Grounding wire to Ground Connect
3. rd atta back into the main body ched on the front door Check splicing routing storage and sys tem status before starting the operation i a a a 12 00 a KORTA ea ee a ee ee ae ele ee eee tie ee ah ee a Je O ee ce ce ee cee a a a le cecal ee a a a See a Se Se een SSE All rights reserved by VISSEM Electrionics Co Ltd
Download Pdf Manuals
Related Search