the Dualex II User Manual
Contents
1. Lex Lighting Safety Instructions LIGHTING 1 Please keep this User Manual for future reference and be sure to pass this manual on to anyone using the fixture 2 Always make sure that you are connecting to the proper voltage as stated on the decal or rear panel of the fixture 3 This product is intended for indoor use only To prevent risk of fire or shock do not expose fixture to rain or moisture 4 Make sure there are no flammable materials close to the unit while operating 5 The unit must be installed in a location with adequate ventilation atleast 20inches 50 cm from adjacent surfaces Be sure that no ventilation slots are blocked 6 Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse rating 7 Secure fixture to fastening device using a safety chain 8 Maximum ambient temperature Ta is 104 F 40 C Do not operate fixture at temperatures higher than this 9 In the event of a serious operating problem stop using the unit immediately Never try to repair the unit by yourself Repairs carried out by unskilled people can lead to damage or malfunction and will void your warranty Please contact the nearest authorized technical assistance center 10 Never connect the device to a dimmer pack 11 Make sure the power cord is never crimped or damaged 12 Never disconnect the power cord by pulling or tugging on the cord 13 Never carry the fixture directly from the c2. ord Always use the hanging mounting bracket 14 Avoid direct eye exposure to the light source while it is on Dualex Il USER MANUAL Please read through the manual before operating this product Keep in a safe place for future reference ax x 5 C www lexlighting co uk Congratulations on purchasing your new lighting effect from Lexlighting Reading through this manual will ensure trouble free and long life operation of the unit Features 96 High Brightness LED s Red Green amp Blue Sound To Light Inbuilt Microphone Full DMX Master Slave Mode up to 4 slaves Digital Settings Display Package Spec D400cm W310cm H230cm Package Weight 3kg Approx Contents Light Unit Dualex II IEC Mains Cable UK Plug Hanging Bracket User Manual Digital Display Fuse Mode Button Down Button Enter Button Up Button Display Settings Sound to Light Music Trigger Mode To put your fixture in sound to light mode k MODE ENTER UP DOWN Press the MODE button until the first letter in the display shows 5 Then using the UP and DOWN buttons select 6 and press the ENTER button Your light is now in sound to light and will run through Programmed chases patterns one by one activated by sound using the built in Microphone Auto Mode Auto mode will run through the programmed chases patterns one by one regardless of any sound input As above simply Pre
3. ss the MODE button until 5 is displayed Using the UP and DOWN but tons select and press the ENTER button Your light is now in AUTO Mode Selecting 3 will stop the Auto Chase Mode Master Slave Mode Your Dualex allows you to connect it to other Dualex units max 4 slaves to create a stunning in sync light show This is achieved by linking XLR cables sold seperatley from each fixture using the DMX IN and DMX OUT ports Please observe the diagram below MASTER SLAVE 1 SLAVE 2 SLAVE 3 SLAVE 4 E IN G l S l S 5 3 5S 4 The above example shows the master units mode set on Sound Ac tive The 4 slaves will now also be sound active and be in sync with the master Dualex s DMX Mode DMX Digital Multiplex is a universal protocol used as a form of communication between intelligent fixtures and controllers A DMX controller sends DMX data instructions from the controller to the fixture DMX data is sent as serial data that travels from fixture to fixture via the DATA IN and DATA OUT XLR terminals located on all DMX fixtures The Dualex II is a DMX enabled fixture and the DMX mode and DMX address settings are controlled via the Digital control panel It also carries the standard 3 pin XLR connections for DMX use To set your fixture for use with a universal DMX controller Press the MODE Button and use the UP and DOWN buttons until you see ABAL on the screen press ENTER Your fix
4. ture is now set in the DMX mode on channel 1 of the DMX universe and is awaiting input from your DMX controller Based on a DMX controller having 16 channels per fixture Light 1 in the DMX universe Display ABAL Light 2 in the DMX universe Display AQ17 Light 3 in the DMX universe Display A0 3H Please consult the manual of your DMX controller for more informa tion on addressing fixtures Mounting Your Fixture Your light is designed to be hung from either a Ceiling DJ Truss or T Bar Stand The bracket comes supplied with a hole to allow mounting of the fixture Always ensure the fixture is tightly fitted to whatever it is your mount ing it too The Bracket thumb wheels can be adjusted and tightned to place your fixture at a desired position Also a safety hook is mounted on the unit Please be sure to con nect a safety chain or safety cable to the hook Care and Maintenance Cleaning your fixture will keep it looking great for many years and also ensure its long life and trouble free operation Clean your fixture with a slightly damp lint free cloth Never use chemicals to clean the fixture as this could impair its finish Always make sure the fixture is powered off before cleaning If you need to replace the fuse always make sure you replace with the same fuse specification NEVER attempt to wrap foil around the fuse
Download Pdf Manuals
Related Search