Koda User Manual
Contents
1. Brackets Figure 3 Installing Removing a bracket You can remove and replace the brackets with any of the eight provided This allows you to use this system with iPods of different sizes To remove grip the inner part of the bracket and take it out After choosing the appropriate bracket you can dock your iPod to the iBass now Using 3 5mm headphone jack for connection For new generation iPods iPod shuffle or other portable audio devices connections can be made using the 3 5mm headphone cable provided with the system Connect one end of the 3 5mm cable into the headphone jack at the back of the iBass and the other end to the headphone or line out jack on your portable audio device Figure 4 3 and 4 4 When the 3 5mm cable is used the infrared remote cannot control your iPod functions and the iPod will not be recharged For music playback it is recommended that you adjust the volume of your iPod or audio device to a sufficiently loud level then adjust the volume of the iBass to your desired level GB 4 to adjust the volume of iPod or your audio devices to a sufficiently loud level then adjust the volume of the iBass to your satisfactory level Note iBass will choose 3 5mm jack input as the priority signal source to play while 3 5mm signal source and iPod is docked into iBass at the same time Connecting to the power After the iPod is docked or headphone jack is connected with your audio device properly you can now inser2. IR signal path between the remote and your iBass Wipe off the small red lens on the front end of the remote Low batteries Check the remote control battery to make sure the side is facing up as shown in Figure 5 on page 7 Replace the remote control battery when low level Software compatibility Upgrade software of your iPod For details refer to To check for iPod compatibility on page 5 Sound distortion System is not Responding Volume level too high Press Volume button to decrease the volume Sound distorted source is Mal operation Distortion and noise are easily noticed with high powered speakers when playing poor quality audio source esp WAV and MID files Try a different audio source such as a music CD or change better quality audio player Unplug the power cable After 1 min plug it again to reset the system Please contact customer service about this problem GB 8 SPECIFICATIONS O utput Power THD10 Speaker Unit Signal to Noise Ratio 15Wx2 29 x2 280dB Frequency Response 80HZ 20kHz Rated Load Impedance 4Q Power Rating 100 240V 50 60Hz 0 5A Power Consumption 40W Product Dimension HxWxD 118x310x145 mm Net Weight 750g Notes 1 The specifications listed above are for reference only 2 The technical specifications of this device are subject to changes without prior notice GB 9 UMA0219E KODA Electroni
3. that could result in a fire or electric shock 13 See product enclosure for safety related markings 14 Use proper power sources Plug the product into a proper power source as described in the operating instructions or as marked on the product Information about products that generate electrical noise If applicable this equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However this is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on you are encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment to an outlet on a different circuit than the one to which the receiver is connected Consult the dealer of an experienced radio TV technician for help This product complies with the Canadian ICES 003 Class B specification O
4. KODA USER S MANUAL iBass Music station ForiPods Made for iPod Photo iPod nano iPod mini 5th Generation iPod with video 4th Generation iPod with click wheel Madefor 3rd Generation iPod with touch wheel and buttons Please read the following instructions carefully before connecting operating or adjusting this product Please keep this manual in a convenient place for future reference CONTENTS COS E e aE e eE aa EE aa aE a 1 Important safety instructions 1 Operation introduction 3 Getting STE NICE uisattumetinsd AEAEE AEE RARE Ea 4 Using the SSII an en 5 Troubleshooting cages es nee hall DOS CIIC ANON Suz 2 222 des secondes cena tenneb encre Uece ceci 9 IMPORTANT SAFETY INSTRUCTIONS AN RISK OF ELECTRICAL SHOCK I DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICABLE PARTS INSIDE REFER SERVICING TO QUALIFIED PERSONNEL WARNING To reduce the risk of fire or electrical shock do not expose the product to rain or moisture WARNING The apparatus should not be exposed to dripping or splashing and objects filled with liquids Liquids can cause a failure and or a fire hazard The lightning flash with arrowhead symbol within an equilateral triangle alerts the AN user to the presence of un insulated dangerous voltage within the system enclosure that may be of sufficient magnitude to cons
5. PERATION INTRODUCTION Thanks for choosing the iBass Music Station The iBass is designed specially to work with your iPod Just listen to it now Box Content Check the carton for the parts shown in Figure 1 D E_S s ar iBass digital iPod brackets Remote control and Power pack Power cable and 3 5mm music system User s manual headphone cable Figure 1 What s included in the carton Place the iBass Music Station on a level surface The speakers are shielded which allows the system to be placed near other video displays such as TVs or computer monitors GB 3 a gp To o o f NS N D REY fe l Ce bime gt D Ss KI En UY nano mini 10GB 15GB 40GB 60GB 30GB 20GB 30GB PHOTO o S x f Getting Started Warning Please do not connect your iBass music station s power pack into a wall outlet until all of your connections are made Also please turn off your iPod before docking on the iBass Music Station Placing the correct bracket To connect your iPod with the iBass music station you will need to choose a correct iPod bracket 1 check the bottom of each bracket to identify the one that fits your iPod Figure 2 Figure 2 Labels on the eight brackets 2 Place the selected bracket over the dock 3 Press on both sides of the bracket to ensure it s firmly placed Figure 3 x
6. cs Co Ltd Allrights reserved
7. ll Toshiba lithium battery To replace please follow the Figure 5 Please note that the lighting of the room or battery life can affect the operating range of the GB 6 remote control Figure 5 Inserting a new battery TROUBLESHOOTING In case of malfunction please power off the system immediately and check the unit according to following table If the problem still exists please contact the dealer or the manufacturer Symptom iPod Audio source is not responding No Sound Problem iPod does not dock properly 3 5mm stereo cable isn t connected properly Power cable is not connected Power isn t turned on Volume Level too low No playable file on iPod Solution Please ensure proper bracket is placed for your iPod Refer to Placing the correct bracket on page 4 Unplug the iPod from the docking station to see any obstructions in the connector or in your iPod Connect 3 5mm stereo cable to the audio source Make sure the signal cable is inserted firmly into the correct jack amp is fully connected in the line out audio out or the headphone jack on your sound card or other audio source Make sure the iBassis plugged in and the LED is illuminated Press Play Pause button on the remote control to go into playback condition Press POWER button on the remote control if your iPod indicator light is off please repeat pressing POWER button Unp
8. lug the power cable for 1 minute then plug it back to reset the system The volume level might be too low press Volume button to adjust Make sure your iPod is on and a track is selected for playback Mute is on Software compatibility problem iBass might be in MUTE condition Press MUTE again Make sure your iPod is running with compatible software refer to To check for iPod compatibility on page 5 Remove your iPod and replace it after few minutes You may need to do this for few times GB 7 No Sound Your iPod is not charging After quickly undocking or docking your iPod Make sure the power cable is securely plugged in to a functioning wall socket The symbol on the small connector is matched with that on rear panel of the iBass Refer to Figure 4 4 on page 5 Make sure your iPod is firmly seated in the dock Remove your iPod from the dock wait for 5 seconds and return it to the dock Unplug the power cable for 1 minute then plug it back to reset the system Remote Control is not functioning properly iPod does not dock properly Remote Control is not pointed toward the infra red window Remove your iPod from the dock wait briefly then reset it You may need to do this for few times Try the remote from different locations and see if it works Strong lighting or other room conditions may cause the problem Make sure nothing blocks the infrared
9. near water or moisture Do not use this product near a bathtub washbowIl kitchen sink laundry tub in a wet basement near a swimming pool or anywhere else that water or moisture are present 6 Clean only with a dry cloth Unplug this product from the Electrical socket before cleaning 7 Do not block any ventilation openings Install in accordance with the manufacture s instructions To ensure reliable operation of the product and to protect it from overheating put the product in a position and location that will not interfere with its proper ventilation For example do not place the product on a bed sofa or similar surface that may block the ventilation openings Do not put it in a built in system such as a bookcase or a cabinet that may keep air from flowing through its ventilation openings 8 Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat 9 Protect the power cord from being walked on or pinched particularly at plugs and the point where they exit from the apparatus 10 Only use attachments accessories specified by the manufacturer 11 Refer all servicing to qualified service personnel Do not attempt to service this product yourself Opening or removing covers may expose you to dangerous voltages or other hazards GB 2 12 Do not let objects or liquids enter the product as they may touch dangerous voltage points or short out parts
10. ss te to turn off your system with LED off press again turn on with LED on 2 Press wr to mute the system press again or turn volume control to resume 3 Press tm to pause iPod playing press again to play 4 Press and i to track forward and track back respectively Press and Hold for rewind amp fast forward 5 Press we and to adjust the master volume of the system 6 Press and to adjust the treble volume 7 Press amp and sto adjust the bass volume 8 Press to bypass the music signal even you have tuned up your system by adjusting its treble and bass More Functions 1 AUTO MEMORY FUNCTION iBass will store your volume and treble and bass setting even it is power off unless iBass is unplugged 2 AUTO STANDBY iBass will be automatically turned to Standby if the iBass is not in use or no signal input for 2 minutes or above Under STANDBY condition Battery Recharge function for iPod is still working if it is docked It stops until it is totally charged To resume from STANDBY press any button in remote control except POWER Note Your iPod navigation controls are fully functional when it is docked in the system except the volume jog wheel It is only functioned when the iPod is connected via the headphone jack Replacing remote control battery Replace the battery when it stops working or the control range is minimized Recommended to use a Lithium Cell CR2025 Duracell Eveready Energizer Maxe
11. t the power pack into a wall outlet Figure 4 1 to Figure 4 4 Te S 8 J a DA Figure 4 3 iBass digital music system Figure 4 4 Figure 4 System connection Checking your iPod compatibility To ensure the infrared remote control to work as expected your iPod must have the proper or later iPod software version installed To check your iPod for the software version currently installed select Settings About Version on the iPod display If upgrade is needed please visit the website below and follow the instructions there for a free download http www apple com ipod download USING THE SYSTEM Your iBass is power on as soon as you plug it in You should hear the music immediately If you do not please refer to Troubleshooting on page 7 The and buttons on either side of the dock is the master volume control of the system Press and hold or to increase or decrease the volume Once your iPod is docked power is recharged automatically until it s fully charged To turn off your system totally please remove your iPod from the dock unplug the system from the power supply GB 5 Note When earphone is plugged into your iPod sound comes from both the earphone and the system Remote Control Functions To use the remote control please ensure the battery is installed properly 1 Pre
12. titute a risk of electric shock The exclamation point within an equilateral triangle alerts the user to the presence of important operating and maintenance instructions in this owner s guide WARNING No naked flame sources such as lighted candles should be placed on the apparatus Note This product is intended to be used only with the power supply provided Where the mains plug is used as the disconnect device such disconnect device shall remain readily operable This product must be used in doors It is neither designed or tested for use outdoors in recreation vehicles or on boats This product conforms to the EMC directive 89 336 EEC and to the Low Voltage Directive 73 23 EEC GB 1 WARNING Keep the remote control battery away from children since batteries are a choke hazard It may cause a fire or chemical burn if mishandled Do not recharge disassemble heat above 100 C 212 F or incinerate Danger of explosion if battery is incorrectly replaced Replace only with Lithium Cell CR2025 Duracell Eveready Energizer Maxell Toshiba lithium battery Please dispose of used batteries properly following any local regulations Do not incinerate Important Safety Instructions 1 Read these instructions for all components before using this product 2 Keep these instructions for future reference 3 Heed all warnings on the product and in the owner s guide 4 Follow all instructions 5 Do not use this apparatus
Download Pdf Manuals
Related Search