Instruction Manual CAUTION: Do not point Infrared Emitter directly
Contents
1. Night Owl Optics ia S b DRE A pA ENIGATONISIONI ES ion Manual n S t r u ci l 0 n d n u d CAUTION Do not point Infrared Emitter directly into eye at close range WARNING Never look through this device directly at or near the sun There is a risk of BLINDING YOURSELF Children should only use this device under supervision Keep packaging materials away from children There is a risk of SUFFOCATION Attention Indoor Lighting may cause the image to PULSE or STROBE This device is intended for use in the dark The NexGen s primary purpose is to amplify natural outdoor light for viewing objects at a distance If you test indoors with the lights turned on the 60Hz frequency of indoor lighting systems will cause the image to pulse or strobe This is not a defect DANGER to your child RISK of physical injury This device contains electronic components that are battery powered Never leave a child unsupervised with this device The device should only be used as per these instructions otherwise there is a serious RISK of ELECTRICAL SHOCK Children should only use this device under supervision Keep packaging materials plastic bags rubber bands etc away from children There is a risk of SUFFOCATION Batteries should be kept out of children s reach When inserting batteries please ensure the polarity is correct Leaking or damaged batteries can cause injury if they come into contact with the skin If you2. Special operating characteristics If the device has initially been used in cold conditions and is then brought into a warmer room allow it to stand in its case for at least 2 3 hours to avoid any condensation forming on the electro optical elements Never immerse the device in liquids Do not expose the device to either rain or strong sunlight Avoid exposure to severe shock or heat sources which may damage the device The following table provides a list of possible problems which may occur during the operation of the device TROUBLESHOOTING Problem Possible cause Solution The device cannot be switched on batteries Check to ensure the correct polarity of the Reposition Batteries Switch the device off and then on again Poor image quality Check whether the eyepiece and lens are appropriately adjusted Ensure that the lenses are not dirty Carefully clean the lenses with a soft and lint free cleaning cloth e g microfiber Customer Service If you experience any problems with your device or if your device is in need of service please call our customer support number 1 800 444 5994 The hours of operation are 8 00 a m 5 00 p m MST Monday to Friday LIMITED ONE YEAR WARRANTY Congratulations on the purchase of your new Night Vision device This certifies that the Warrantor warrants this product to be free of defects in material and workmanship when used in accordance with the accompanying ow
3. each object you view Operating Control Use the MODE BUTTON to select the best illumination setting for the environment you are in Successive presses of the MODE BUTTON allow you to select among one of five preprogrammed settings Each setting is a combination of IR illumination and frame rate More IR illumination allows you to see farther but too much IR illunmiadinatshordistances may overexpose the image Slower frame rates lower numbers allow the sensor to collect more light resulting in increased low light illumination But a lower frame rate setting also results in a slower refresh rate and less efficient tracking of moving objects Mode Settings are as follows IR Illumination Frame Rate 1 1 3 Power 30 fps 2 FULL Power 30 fps 3 1 2 Power 15 fps 4 FULL Power 15 fps 5 FULL Power 8 fps Toggle among the different settings and use the selection that is best for the light environment you are in Each time the xGen is powered on the illumination setting resets to the 1 default setting Operating Conditions While intended for viewing in the dark use in daylight will not damage the device but may result in a temporarily overexposed image Do not expose to rain extreme heat or shock CAUTION Do not point Infrared Emitter directly into eye at close range Keep out of reach of children The infrared emitter emits a BRIGHT although invisible beam of light As with any bright light do not point into the eye
4. Compartment door with lock Introduction The Night Owl Optics xGen Digital Night Vision Viewer features the latest innovations in affordable consumer night vision technology Designed for viewing out to a distance of 70 yards with the assistance of a powerful built in infrared illuminator the xGen viewer performs in low light conditions or complete darkness Battery installation 1 Rotate the locking tab counterclockwise to unlock the battery cover and flip it open 2 Install 3 AA 1 5volt alkaline batteries as shown in illustration 6a Pg 4 Please note polarity of batteries 3 Close the battery compartment and rotate the tab clockwise to lock it shut Start Up Move power switch to the ON position Focus The xGen has two focusing mechanisms 1 The EYEPIECE allows you to focus your individual eyesight onto the microdisplay 2 The OBJECTIVE LENS brings objects at different distances into focus Press the MODE BUTTON to see characters on the microdisplay With these characters illuminated rotate the EYEPIECE until the characters come into focus After focusing the EYEPIECE to your eyesight no further adjustment of the EYEPIECE is necessary unless you move it accidentally Then rotate the OBJECTIVE LENS to bring objects in your field of view into focus The xGen requires manual focusing Just as your eyesight must refocus on objects at varying distances you must also rotate the OBJECTIVE LENS to focus precisely on
5. need to handle such batteries please wear suitable safety gloves TIPS on cleaning S Remove the batteries before cleaning LM Clean the exterior of device with a dry cloth Do not use cleaning luids so as to avoid causing damage to electronic components Protect the device from dust and moisture Store the device in he bag supplied DISPOSAL g Dispose of the packaging material s as legally required Important It is advisable to remove the batteries when the device is not used for more than 24 hours This prevents the batteries from leaking and extends their service life Please do not use rechargeable batteries since the base voltage they provide is insufficient We recommend using high performance type AA 1 5 V alkaline batteries Technical Data Model xGen Sensor Resolution 640 X 480 pixels VGA Micro Display Resolution 320 X 240 pixels QVGA Magnification 2 1x FOV in degrees 12 degrees Field of view at 200 ft 40 ft Minimal Focal Distance 1M Eyepiece Adjustment 4 Diopter Battery Requirements 3 AA alkaline batteries not included Dimensions 4 8 X 1 65 X 3 10 Weight 7 oz without batteries Lens Diameter 20mm Infrared Illuminator Built In DC 4 5V 778 Includes 3 batteries AA Carry bag Instruction manual Xx C aes Power Switch Mode button Ocular Lens Eyepiece V Objective Lens Infrared Illuminator IR a Battery Compartment b
6. ner s manual Warrantor s obligation under this Warranty shall be limited to the original purchaser to repair or replace free of charge within the specified period of Warranty This Warranty is not transferable This Warranty does not apply to any Night Vision products that have been subject to indirect damage due to misuse abuse accident and alteration due to the attempt to repair a unit by a non authorized repair agent During the Warranty period Warrantor and or any of its affiliates or authorized repair agents will at their discretion repair or replace defective parts in the warranted products free of charge Proof of purchase is required to make a claim under this warranty PROCEDURE FOR WARRANTY CLAIM Please contact our Night Vision Customer Service Representative by mail or telephone for return authorization Warrantor will not accept any returns unless they contain a return authorization number issued by a Night Owl Optics Customer Service Representative To return your device for service please pack in its original carrying case Also please pack the unit with enough protective material so it does not get damaged or scratched during shipment Please include your name shipping address telephone number along with proof of purchase and a brief note describing the defect The unit will be repaired or replaced at the discretion of the Warrantor In the event the repairs are not covered by this Warranty an estimate will be sent for
7. your approval NOTE TO CUSTOMERS OUTSIDE THE USA This warranty may vary in other countries check with your distributor for details Warranty does not cover shipping costs Night Owl Optics 1465 H Henry Brennan Dr El Paso Texas 79936 1 800 444 5994 www nightowloptics com Errors and technical changes reserved MxGen Rev 2 Made in China 060412
Download Pdf Manuals
Related Search