Oscillating Ceramic Heater User Manual Model 8566
Contents
1. A thermal overload protector is built in to prevent overheating 2 When an overheat temperature is reached the Heater will be automatically shut off It can only resume operation when the user resets the unit To Reset Heater 1 Unplug the Heater and wait 10 minutes for the Heater to cool down 2 After the Heater has cooled down plug the unit into a 120V electrical outlet and follow the operation instructions described in this manual TROUBLE SHOOTING TIPS If your heater shuts off unexpectedly or fails to operate one of MAINTENANCE WARNING ALWAYS UNPLUG THE CORD BEFORE MOV ING OR SERVICING WARNING DO NOT IMMERSE HEATER IN WATER CLEANING IMPORTANT Clean the Heater grill and side in takes with the vacuum brush attachment of your vacuum cleaner This will remove lint and dirt from the inside of the Heater Clean the body of the Heater with a soft cloth DO NOT ATTEMPT TO TAKE APART THE HEATER the above mentioned safety feature may have been activated to prevent overheating 1 Be sure the power cord is plugged into a working electrical outlet 2 Check your Thermostat setting The Heater may be off because it has reached the desired temperature setting CAUTION Do not use gasoline benzine thinner harsh cleaners etc as they will damage the Heater NEVER use ALCOHOL OR SOLVENTS SERVICING All other servicing with the exception of general user maintenance should be performed by an authorized ser vic2. Figure 3 Pressing the or button allows you to set the desired tem perature of the Heater 1 When the or button is pressed the displayed set tem perature will begin to flash and the symbol will appear 2 Press the to increase the desired set temperature or press the to decrease the desired set temperature 3 When the air temperature reaches 2 above the set tempera ture the Heater will shut off 4 When the air temperature reaches 1 below the set temperature Rev B 12 05 the Heater will turn on 5 This function will cancel if the button is pressed and the Heater will now be in Low heat 1 NOTE It is normal for the Heater to cycle ON and OFF as it main tains the SET temperature Display reflects High Heat and Automatic Temperatue Control Function Figure 4 REMOTE CONTROL Figure 5 All the functions performed with the Remote Control work identically to the manual controls except the ability to change from F to C 1 Install the two AAA batteries supplied 2 Do not mix old and new batteries Do not mix alkaline standard carbon zinc or rechargeable nickel cadmium batteries Front View Back View of Remote of Remote an a Figure 5 3 Remote control hook is located on back of Heater Figure 6 Back View of Heater Mi CA ee 8566ESF MODEL 2RA10 8566 SAFETY FEATURE 1
3. IMPORTANT INSTRUCTIONS OPERATING MANUAL Ventilation Products 34 OSCILLATING CERAMIC TOWER HEATER with REMOTE CONTROL MODEL 2RA10 8566 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE INSTALL OPERATE OR MAINTAIN THE PRODUCT DESCRIBED PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND OR PROPERTY DAMAGE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE DESCRIPTION The AirKing Oscillating Ceramic Heater features 2 heat settings The heater oscillates 120 and comes with a remote control for convenience This unit also features a built in timer to allow up to 8 hours of operation before automatic shutdown and comes with a 6ft 1 82m 16 3 grounded cordset SPECIFICATIONS MOOT cicescatescvcescadsscecsacecssane 120 V 60 Hz CON x2eiscdosccdecesdsccaderaeded Manual Remote Setn Snir High and Low Heat Air Flow Distribution 120 Approvals UL CUL listed Close mesh blower guard meets OSHA requirements MODEL 2RA10 8566 SETTINGS HIGH LOW FAN BTU 5118 3070 Amps 12 5 7 0 0 288 Watts 1500 900 33 4 dB A 47 lt 40 47 GENERAL SAFETY INFORMATION 1 Read all instructions before using Heater 2 Use this Heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electrical shock or injury to persons 3 Make certai
4. ay to Celsius Press the same two buttons together again will change the display back to Fahrenheit 7 Upon turning the Heater on the unit will be in HIGH heat 1 1500 Watts and will display the current room temperature Figure 2 8 Press the button for LOW heat jj 900 Watts Figure 1 8566ESF MODEL 2RA10 8566 9 To turn the Heater OFF press the Power Button and un plug the Heater from the electrical outlet Display when initially turned on Figure 2 OSCILLATION Pressing the Oscillation Button will allow the Heater to oscillate back and forth To stop the oscillation press the Os cillation Button O again TIMER FUNCTION Figure 3 The timer function may be activated when the Heater display is in any function or speed This function allows you to set the length of time the Heater will run before turning itself off from 1 hour to 8 hours Pressing the Timer Button will increase the length of time by 1 hour each time this button is pressed After the display reflects 8 hours pressing the Timer Button once more will re set the Heater to run continuously The Heater will turn off when the set time has lapsed The unit can be turned back on by pressing the Power Button Q AUTOMATIC TEMPERATURE CONTROL Figure 4 Timer Function in High Heat and Automatic Temperature Control Timer Function in LOW heat
5. e representative STORAGE Store the Heater with these instructions in the original carton in a cool dry place LIMITED WARRANTY AIRKING THREE YEAR LIMITED WARRANTY Products are warranted by AirKing to the original user against defects in workmanship or materials under normal use for three years after date of purchase Any unit which is determined by AirKing to be detective in material or workmanship and returned to an authorized service location as AirKing designates shipping costs prepaid will be as the exclusive remedy repaired or replaced at AirKing s option For limited warranty claim procedures see PROMPT DISPOSITION below This limited warranty gives purchasers specific legal rights which vary from state to state LIMITATION OF LIABILITY To the extent allowable under applicable law AirKing s liability for consequential and incidental damages is expressly disclaimed AirKing s liability in all events is limited to and shall not exceed the purchase price WARRANTY DISCLAIMER AirKing has made a diligent effort to illustrate and describe the products in this literature accurately however such illustrations and descriptions are for the sole purpose of identification and do not express or imply a warranty the products are merchantable or fit a particular purpose or that the products will necessarily conform to the illustrations or descrip tions Except as provided below no warranty or affirmation of fact expressed or im
6. ly dangerous locations such as flammable explosive chemical laden or wet atmospheres This Heater is intended for general use ONLY 14 This Heater is not intended for use in wet or damp locations Never locate a Heater where it may fall into a bathtub or other water container 15 Do not use Heater outdoors WARNING REDUCETHE RISK OF FIRE OR ELECTRIC SHOCK DO NOT USE THIS HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES SAVE THESE INSTRUCTIONS OPERATION 1 Carefully remove the Heater from the bag and the carton 2 Place the Heater on a firm level surface WARNING Plastic or rubber tabs like the feet on this unit may stick to furniture surfaces and or hardwood floors The unit may leave a residue that could darken stain or leave permanent blemishes on the finish of certain furniture surfaces including wood surfaces and or hardwood floors 3 Plug the cord set into a 120V electrical outlet Be sure plug fits tightly in outlet 4 When the Heater is initially plugged in there will be a beep and the Power Light will come on indicating that there is power to the unit The Power Light will remain lit until the Heater is un Power plugged from the electrical out Light let Figure 1 5 Turn the Heater ON by pressing the Power Button 6 When initially turned on the Heater will display the current room temperature in Fahrenheit Press the and buttons at the same time to change the displ
7. n that the power source conforms to the electrical require ments of the Heater 4 Extreme caution is necessary when any Heater is used by or near children or invalids and whenever the Heater is left operating unat tended 5 The power cord is equipped with a three prong grounded plug that must be inserted into a matching receptacle Under no circumstances should the ground prong be cut off the plug Where a two prong wall recep tacle is encountered it must be replaced with a properly grounded three prong receptacle installed in accordance with the National Electrical Code NEC and all applicable local codes and ordinances This work must be done by a qualified electrician using copper wires only DO NOT USE A THREE PRONG ADAPTER IMPROPER CONNEC TION MAY CAUSE THIS RISK OF ELECTROCUTION USE OF SUCH ADAPTERS IS NOT PERMITTED IN CANADA 6 Where possible avoid the use of extension cords because the extension cord may overheat and cause a risk of fire If they must be used mini mize the risk of overheating by ensuring that they are UL listed a mini mum No 14 AWG rated not less than 1875 watts Never use a single extension cord to operate more than one Heater 7 Do not operate any Heater with a damaged cord or plug or after the Heater malfunctions has been dropped or damaged in any manner Return Heater to authorized service facility for examination electrical or mechanical adjust ment or repair 8 Unplug power cord before se
8. ny product believed to be defective within limited warranty first write or call dealer from whom product was purchased Dealer will give additional directions Rev B 12 05 3 8566ESF MODEL 2RA10 8566 NOTES Rev B 12 05 4 8566ESF
9. plied other than as stated in LIMITED WARRANTY above is made or authorized by AirKing PRODUCT SUITABILITY Many states and locations have codes and regulations governing sales construction installation and or use of products for certain purposes which may vary from those in neighboring areas While AirKing attempts to assure that its products comply with such codes it cannot guarantee compliance and cannot be responsible for how the product is installed or used Before purchase and use of a product please review the product application and national and local codes and regulations and be sure that the product installation and use will comply with them Certain aspects of disclaimers are not applicable to consumer products e g a some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you b also some states do not allow limitations on how long an implied warranty lasts consequently the above limitation may not apply to you and c by law during the period of the Limited Warranty and implied warranties of merchantability or fitness for a particular purpose applicable to consumer products purchased by consum ers may not be excluded or otherwise disclaimed PROMPT DISPOSITION AirKing will make a good faith effort for prompt correction or other adjustment with respect to any product which proves to be defective within limited warranty For a
10. rvicing or moving the Heater Always unplug Heater when not in use WARNING DO NOT DEPEND ON THE ON OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SER VICING OR MOVING THE HEATER ALWAYS UNPLUG THE POWER CORD 9 Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or fire or damage the Heater Do not block or tamper with the Heater in any manner while it is in operation 10 To prevent a possible fire do not block air intakes or exhaust in any man Rev B 12 05 ner Do not place on soft surfaces like a bed where openings may be come blocked 11 Always place the Heater on a stable flat level surface when operating to avoid the chance of the Heater overturning Locate the Power Cord so the Heater or other objects are not resting on it Do not run Power Cord under carpeting Do not cover Power Cord with throw rugs runners or the like Arrange Power Cord away from room traffic and where it will not be tripped over 12 This Heater is hot when in use To avoid burns do not let bare skin touch hot surfaces Always use handle when moving this Heater Keep com bustible materials such as furniture pillows bedding papers clothes and curtains at least 3 feet 0 9 m from the front of the Heater and keep them at least 1 foot 0 3 m from the sides and rear 13 A Heater has hot and arcing or sparking parts inside It must NOT be used in potential
Download Pdf Manuals
Related Search