Home

Quick Reference Installation Instructions

1. in the Setting Menu Setup Complete The dialogue is now ended Your WMF 1400 is now ready for operation Please find out how to set operate clean and program your coffee machine in your User Manual Beverage Despensing Pressing the beverage buttons triggers dispensing of the beverage set e lluminated ring round button ready e Flashing ring round button dispensing Place receptacle underneath x Press desired beverage button Chosen beverage and progress of dispensing are shown in the display We wish you every success with your WMF 1400 I Do not confuse beans and powder containers l Recipe setting adjusted to new cup volumes Coffee machine is rinsed out on dispensing the first three beverages Dispose of the first three beverages dispensed Level 1 active Level 2 active Readiness State display with two button levels Readiness State display with one button level
2. Quick Reference Installation Instructions For initial startup on delivery ex works Please refer to WMF 1400 User Manual Pay special attention to the hazard notices and Safety chapter Unpacking Unpack the WMF 1400 and place it on a firm horizontal surface Mains Connection Connect mains cable to a fused three pin power point Mains Required Kindly note the required Mains Power and Voltage as shown on the type label of the machine Standard 230 V 50 Hz 2000 W fuse 10 A minimum Japan 200 V 50 60 Hz 2000 W fuse 15 A minimum USA 120 V 50 Hz 1900 W fuse 15 A minimum Switch On Press and hold ON OFF button K for 2 sec min WMF 1400 switches on and startup program commences The WMF 1400 takes you using step by step dialogues through the installation routine Perform each step only when instructed on the display Removing Water Tank Remove water tank remove lid Take out accessory components contained Water tank option only k Rinse out water tank and fill with clean cold mains water k Place lid on water tank and replace until it meets the stop Removing Coffee Grounds Container k Push combi spout fully upwards k Push up adjustable screen over coffee grounds container k Remove coffee grounds container and remove accessories k Replace coffee grounds container until it meets the stop k Close adjustable screen Constant Water Supply optional Carefully insert seals attached to
3. connecting tube lt Using hose connect union on rear of machine to existing water tap or anti scale filter as appropriate If using WMF AquaQuell 1 5 Filter System follow its User Manual Turn on water k Check unions for leaks and tighten if necessary LW 4 eeo ooo Drain Outlet optional lt Push drain tube with angle onto water drain connector on rear of machine Connect drain tube to mains drain via an S trap x Tube must not sag Shorten tube if necessary Mf 1400 Packaging material in box contains accessories Do not throw away For accessories and identifiaction of machine components see User Manual A Make sure that the coffee machine is in perfect condition In the event of doubt do not start up and inform WMF Service Keep original packaging in the event of any subsequent return For installation terms and conditions see User Manual Do not loosen any screws and do not remove any housing parts there is danger to life inside the machine due to mains voltage Siphon S bend odour trap as on dishwahers Fi F P F ri Order Number 33 2319 9010 Edition 1 02 10 05 The WMF 1400 takes you using step by step dialogues through the installation routine Perform each step only when instructed on the display Set Water Hardness k Request water hardness reading from water supplier or determine using WMF Carbonate Hardness Test Kit complete with Instructions in the access
4. sories Labelled Deutsche Karbonatharte dKH Fill Product Reservoir Fill Product Reservoir when requested by display Connect Fresh Milk optional k Open milk lid fully to the front Open fresh milk pack so that it is lying on the thin side and no milk runs out 5 Push preassembled milk hose into the milk pack Shorten hose as required k Place milk pack carefully in the chute When adjusting height of combi spout hose must not be stretched Replace milk lid Cooler optional lt Punch pre stamped knock out on milk lid lt Feed tube through and push into cooler When adjusting height of Combi spout hose must not be stretched i 74 i 74 e green Milk nozzle cold milk e white Milk nozzle milk at room temperature Set Cup Volumes Decide beverage receptacles for beverage dispensing and keep receptacles ready This point can be skipped if beverage receptacles are not available Touch beverage button for the desired beverage Activate test dispensing by touching Wed l Adjust cup volumes with and pads Save with H gt K gt K gt K gt K Second Button Level optional If your WMF 1400 has a second button level you can also set the cup volumes for the beverages of the second button level If the second level is available the toggle pad will be displayed Activate the respective inactive button level by touching the toggle pad The selected settings may now be adjusted at any time

Quick Reference Installation Instructions

Contents

Download Pdf Manuals

Related Search

Related Contents