MX-G20 MKII - marrex technology co.,ltd
Contents
1. MKII uses a highly sensitive antenna and upgraded GPS chipset to enhance the speed of positioning Highlights e GPS data hold If the GPS signal is lost the MX G20 MKII will automatically reuse the last valid GPS information for tagging the current photo Once the receiver is turned off the stored GPS data will lost e Built in Li ion battery A built in rechargeable battery can continuously run for up to 6 hours Tip The MX G20 MKII will automatically suck power from the camera when it is in low battery e Fast acquisition Highly sensitive antenna and upgraded GPS chipset accelerate the satellite searching speed In good weather and open sky the unit takes 60 seconds for a cold start 15 seconds for a warm start and 1 second for a hot start e 3 axis electronic compass Provide accurate azimuth Range 0 3599 Specifications Channels 66 capturing channels 22 tracking channels Tracking sensitivity 163dBm Capturing sensitivity 146dBm Positioning accuracy 3m CEP50 without SA 2 5m SBAS Data format NMEA 0183 Battery 900mAh rechargeable Li ion battery 3 axis electronic compass Azimuth range 0 359 Dimension LxWxH 75mm x 50mm x 31 5mm Weight Approx 65g 2 3 oz Product Structure Shutter Release Interface USB Interface Connect to camera Charge Power Button LED Operation Charge Please turn the MX G20 MKII off Connect the GPS receiver to a power sour2. User Manual MX G20 MKII GPS Receiver For Nikon WWW marrex cn Statement Please read this manual carefully before using and strictly operate and store in accordance with the instructions Please save it for your future reference If the user manual cannot help you to solve certain problems please ask your retailer for help or email us info marrex cn Cautions e Do not use the unit under water and don t expose it to rain Please store it in a cool dry place e Please charge the unit strictly according to related rules Otherwise damage might be caused to the battery e Please do not move it from overheated to supercooled conditions frequently as well as keep away from heat sources such as heater and oven e Please be careful to install the MX G10M MKII gently to avoid damage to the device or camera e Please turn off the power when left unused Product Introduction General Introductions The Marrex MX G20 MKII is a new version of GPS receiver specially designed for Nikon DSLR cameras It is very useful for photographers to organize stock photos With the MX G20 MKII figuring out when where and why a certain photo was taken is not a problem anymore When connected to the camera and positioned successfully the GPS information longitude latitude elevation and Coordinated Universal Time will be recorded as EXIF data The MX G20 MKII is equipped with a built in Li ion battery and LED indicator In addition the MX G20
3. arges for returning the product to Marrex Technology This warranty only applies where a defect has arisen wholly or substantially as a result of faulty manufacture parts or workmanship during the warranty period This warranty does not cover e Any damage caused by human factors including using the products in abnormal conditions and operating the device in ways not in accordance with the user manual e Any damage caused by incorrect use or poor maintenance or when persons not authorized by Marrex Technology have carried out alterations or repairs e Force majeure events such as fire flood lightning strike earthquake e Customers who cannot show a valid invoice Marrex Technology reserves all the rights for the ultimate interpretation e Hanging strap Compatibility Nikon D4 D4s D3 series D300 series D2X D2XS D2HS Df D810 D810a D800 D800E D750 D700 D600 D610 D200 D7200 D7100 D7000 D5500 D5300 D5200 D5100 D5000 D3300 D3200 D3100 D90 COOLPIX P7800 P7700 Packing List e MX G20 MKII main unit e USB cable e N1 cable e N3 cable e Aclip To attach the MX G20 MKII to your camera strap e Wired shutter release e User manual e Warranty card COPYRIGHT 2011 2021 MARREX TECHNOLOGY A brand of DSQN Web www marrex cn Email info marrex cn
4. ce travel adapter a computer or any other USB port which provides standard 5 volts with supplied USB cable or to your camera with N1 N3 cable Please short press the power button to enter charging mode the LED will blink red When the GPS unit has been fully charged the LED turns to solid green Please note For successful charging please do not long press the power button otherwise it will enter the working mode Charging from a computer will slower charging speed For long time shooting please take a power bank with the supplied USB cable with you Power On and Off Press the power button for more than 3 seconds to turn the MX G20 MKII on Press the power button 9 for more than 3 seconds to turn the MX G20 MKII off LED Status Blinking Red Charging Charging Mode Solid Green Fully charged Blinking Green Acquiring satellites Working Mode Solid Green Satellite connection successful Solid Red Low battery Setup Guide Turn the camera off Press the power button for more than 3 seconds to turn on the GPS receiver The LED on the GPS receiver will blink green indicating that it is searching for satellites When a steady satellite signal is captured the LED will stop blinking It takes about 60 seconds to start the receiver up when cold 15 seconds if you just shut it down then restart and 1 second to wake it up For successful positioning you must be outdoors with good weather and a s
5. ky unobstructed by tall buildings Mount the MX G20 MKII to the camera s hot shoe or secure it to your camera s neck strap or neck strap lug with the supplied strap and clip leaving the shoe free for use with a flash or other device Select the correct camera connecting cable N1 or N3 for your camera The MX G20 MKII GPS receiver is compatible with Nikon DSLR cameras with a GPS setup menu including but not limited to the following N1 Ten Pin Cable Nikon D2X D2XS D2HS D3 series D4 DAS D200 D300 series D700 D800 D800E D810 D810a N3 Flat Cable Nikon Df D90 D600 D610 D750 D3100 D3200 D3300 D5000 D5100 D5200 D5300 D5500 D7000 D7100 D7200 COOLPIX P7800 P7700 For cameras with a ten pin remote terminal on the front of their bodies e Insert the t end of the N1 USB cable into the data port of the MX G20 MKII When inserting the cable please be sure that the end is oriented correctly and do not use force e The pins on the end of the N1 cable should line up with the holes of the ten pin remote terminal on the your camera s body please gently insert the cable and tighten the locking nut For cameras with a rubber accessory terminal cover on the side of their bodies e Insert the Y end of the N3 cable into the data port of the MX G20 MKII When inserting please be sure that the end is oriented correctly and do not use force e Insert the A end of the N3 cable into the accessory port under the te
6. rminal cover on the side of the camera body When inserting please be sure that the end of N3 is oriented correctly and do not use force Turn on your camera View GPS position on the camera Menu gt SETUP MENU GPS Position i3 SETUP MENU es GPS e Image authentication 7 Copyright information Y Save load settings Latitude N 22 37 661 Longitude E114 03 872 Auto meter off F Position Use GPS to set camera clock ON GPS 4 Virtual horizon 8 Non CPU lens data AF fine tune Firmware version Altitude 123m Heading 13 80 UTC 29 05 2015 09 14 15 Once you begin shooting the geotag information of each photo will be displayed on the camera s LCD LATITUDE N 22 37 661 LONGITUDE E 114 03 872 ALTITUDE 127m TIME UTC 29 05 2015 09 16 34 HEAD ING f C oo NIKON D700 106 198 Geotag information can be viewed on a computer when images are uploaded to photo sharing sites like Nikon s my Picturetown and Flickr or opened in imaging software such as Nikon ViewNX2 Picasa ACDsee GEOsetter Opanda EXIF Lightroom FSviewer Warranty Marrex Technology Co provides a one year warranty under normal use and lifelong paid maintenance from the date you purchase this product Marrex Technology will repair or replace the product under warranty for free during the one year valid period but customers should pay for shipping and insurance ch
Download Pdf Manuals
Related Search