Home

PHP 2022 說明書 - Massage

image

Contents

1. Premier Health Products PHP 2022 User Manual d Ka gt HEALTH PRODUCTS Evergreen CO 80439 303 670 8882 www premierhealthproducts com info premierhealthproducts com User Manual PHP 2022 Table of contents Safety and Precauliois een l Assembly instructions ee 2 3 Using your Remote Control 4 5 Reeline POSITIONS nun 6 Troubleshooting Guide 7 Safety Precautions Weigh limit is 260 Ibs users over this limit will void the warranty Before Use A Follow this user guide to assemble all parts and ensure complete setup B Place the chair on a flat solid surface Use a power outlet close to the chair with good grounding and use a high quality surge protector do not share outlet with other devices Do not place chair in direct sunlight high humidity or dusty locations C Make sure the main power switch is in the OFF position before setting up the chair D Keep power cords wires and the chair away from heat sources E Do not block air circulation to the chair F Consult your medical provider prior to use especially if you have or suspect you may have heart or circulatory problems injuries or any neurological spinal orthopedic menstrual problems or any other medical conditions G DO NOT USE IF YOU ARE PREGNANT or think you might be pregnant While In Use A Keep all items away from the chair B Never use this chair to massage the h
2. ead face hands elbows knees buttocks or abdomen C Wear loose and comfortable clothes with no collars or other tight bands Remove all hard objects from pockets before use D Use for no longer than 30 minutes per session For best effect use for 15 minute sessions and no longer than 3 minutes of stationary massage in a single position E Stop use immediately if you experience any discomfort After Use A Restore chair to full upright position and fold foot rest in B Place remote control in the pocket on the left side of chair C Do not disassemble the chair or attempt maintenance or repair without contacting Premier Health Products first D If you will not be using the chair for several days turn off the main power switch in back and unplug it Turning off the main power when not in use is always a good idea Assembly Instructions Install the two rear caster 2 wheels on the legs of the seat eech Cut the two tie wraps securing the seat frame to the chair frame on the front of the chair under the calf and foot rest Two full size and one half size back pad have been included They can be inserted into the pouch on the back side of the back pillow to adjust the massage strength It is highly recommended to use one or more pads when first using your massage chair and then removing as needed Seat Place the chair back on the floor with the front face up Push the seat frame down to connect to the two
3. functions for combination effects A e me KNEADING CW When in manual mode press this button to go into kneading mode This function can be used in conjunction with Rolling Shoulder Back Waist and Full Stroke functions for combination effects WIDTH ADJUSTMENT Press and hold this button until the rollers reach the desired width The rollers will then stay in this position for the length of your massage This button can not be used in conjunction with the Kneading button BACK UP DOWN These buttons adjust the back and footrest up and down Press the down button once to auto recline press again to stop in any position Press the up button to auto recover or stop in any position Due to the unique design of this chair the back and footrest operate together and can not be operated independently of each other COMBINATION FEATURES The Kneading and Tapping buttons can be used in combination with the Shoulder Back Waist and Full Stroke for combination rolling and tapping rolling and kneading kneading and tapping as well as pin point kneading and tapping The Inversion and Zero Gravity Positions For Inversion position start with the chair in its normal upright position and pull the looped cord on the right side of the chair between the seat and arm up and to the rear Towards your hip and then let go This will lock the chair into the inversion position For Zero Gravity position start with the chair in its nor
4. m
5. mal upright position and pull the looped cord on the right side of the chair between the seat and arm up and forward towards your knee and then let go the cable will appear slightly shorter This will lock the chair into the Zero Gravity position Caution You can not change between Inversion and Zero Gravity unless the chair is in its full upright and locked position Troubleshooting ELEN D Chair jams while reclining or makes popping noises while reclining E Chair is operating erratically or won t respond to the remote Make sure chair is plugged in Make sure the main power switch ison Check the Fuse and replace if burned out fuse location is below red main power button Turn off power then check the white R wire connector under the chair it may be loose Check the yellow A wire connect under the chair it may be loose Refer to this manual and the setup instructions check to ensure the chair back is latched to the chair seat correctly page 3 Follow the procedure for B and Reset the chair by 1 turning off the power on your remote 2 turn off the power on the main switch on your char 3 unplug the power cord Allow to remain off for at least 10 minutes Then power the chair back on by reversing this sequence d ox KN D MEALTH PRODUCTS Evergreen CO 80439 303 670 8882 www premierhealthproducts com info premierhealthproducts co
6. pins on the outer sides of the base with the two locking hooks on the back Push to link the knuckle at the bottom of the chair back to the U hook at the reclining drive shaft under the seat frame Connect the yellow A wires and the white R wire connectors together Place the seat cushion on the seat frame and wrap the Velcro strips around the seat frame Arm into sa Air Bulb Line up and insert the 3 prongs on the inner side of the armrest into the holes at the edge of the seat frame Attach the wing nut to the middle prong and hand tighten Place the calf strength adjustment air bulb on the seat so not to pinch Attach the seat front cover underneath the leg by wrapping the Velcro strips around the frame Leg Rest Remote Control Functions ON OFF Power button Press this button once to turn chair on If no other buttons are pressed it will start a pre programmed 15 minute massage Press the button again to turn off and reset the chair to upright position Zan AUTO When the chair is powered on thered light will be lit indicating the chair is in the automatic mode and will Er perform a preprogrammed massage To switch to a EE manual mode press the button once and the light will go off You can now select Full Stroke Shoulder Back or Waist And complement with Kneading or SE Tapping BER Ee SHOULDER A When in manual mode press this button to confine P the rolling stroke
7. to the shoulder area only Adjust op chair Bech the Kneading or Tapping as needed FULL STROKE This is the default mode in conjunction with the Auto mode when the chair is first powered on Press this button once to go into manual rolling mode with a full stroke adjust the Kneading or Tapping asneeded BACK When in manual mode press this button to confine the rolling stroke to the back area Adjust Kneading or Tapp as needed FOOT Press this button to start your leg or foot massage at the medium speed Press again to increase to high speed press again to go to the lowest speed press again to turn off When on press and hold for 4 seconds to activate CHI back and forth motion and use the method described above to adjust speed WAIST When in manual mode press this button once to confine the rolling stroke to the waist area only adjust Kneading or Tapping as needed Remote Control Functions continued ROLLING When in manual mode the rolling button will cancel any kneading or tapping functions This button will not perform any additional functions ROLLING UP DOWN When in manual mode use these buttons to adjust or point to exactly where you would like the rollers to be set TAPPING When in manual mode press this button to begin tapping Press againto change tapping speeds pee This button can be used in conjunction with the Kneading Rolling and Shoulder Back Waist and CE Full Stroke

Download Pdf Manuals

image

Related Search

Related Contents

CodeWarrior™ Development Studio 8/16  U3000-4000_USER MANUAL.book  第96期 - 大王製紙  Manuel d`installation pour HD 800 Set - Migros  - INTEG Process Group  Bitte vor Inbetriebnahme des Gerätes lesen! Please read the manual  L`usure du rire chez Réjean Ducharme  Installation Manual  Aperio Image Analysis User`s Guide  PDFファイル  

Copyright © All rights reserved.
DMCA: DMCA_mwitty#outlook.com.