Gamko E3 Range User Manual
Contents
1. A A 54 Defects The appliance does not start e Check the powerplug e Check the power switch next to the thermostat e Restore power by possibly replacing a faulty fuse or switch e Please notify your service partner Temperature is too high Despite the correct thermostat set point e Check that the condenser is clean see Chapter 4 Maintenance e Check that fan rotates e Remove any objects that may block the air ventilation e Check magnetic door seal clean or replace if necessary e Defrost evaporator e Thermostat is defective Please notify your service partner Temperature is too low Despite the correct thermostat set point e Thermostat is defective Please notify your service partner Water spillage e Make sure doors drawers close properly e Check that any holes made during installation are well sealed e Make sure the appliance is level e Defrost regularly perhaps additional manual defrost see manual thermostat e Please notify your service partner 55 Chapter 5 Technical information Electrical connection Refrigerant Cooling capacity Thermostat Temperature range Max shelve load Type Electric power Weight empty Lighting Locks Dimensions WxDxH Type Electric power Weight Lighting Locks Dimensions WxDxH Type Electric power Weight Lighting Locks Dimensions WxDxH Plug ready bottle coolers E3 84 220 240 V 50 Hz i R600a 515Watt 12 cc E2. NEVER be blocked It is recommended to leave the side and rear free of the cabinet free for optimum air circulation This improves cooling performance and reduces power consumption NEVER place electrical appliances in the cabinet TIP Apply the so called first in first out principle when serving cold beverages from the appliance This serves the coldest product from the refrigerated cabinet 53 Chapter 4 Maintenance Cleaning the refrigerator cabinet Proper maintenance of your product guarantees a long life Do it yourself maintenance e Before operating the appliance clean with water and a light detergent e Clean the segments regularly in case of intensive use e The ECO line cooling cabinets have a condenser in front of the appliance Please clean this condenser 1x per week for example by means of a vacuum or compressed air e Check and clean the door seals regularly Replace cracked or not properly fitting door seal immediately e Clean the drawer slides on drawers monthly annual light lubrication with grease is recommended Attention e Do not disassemble the cooling unit for cleaning e Do not use aggressive or abrasive cleaning agents e Condenser can have sharp surface clean with care e In dusty environment clean condenser more often e Clean glass doors with a mild detergent e Clean stainless steel with water and mild soap e After cleaning Stainless steel rinse and dry with a soft cloth
3. damages 51 Chapter 3 Usage Commissioning e Clean the appliance before commissioning For further details see maintenance e After the installation wait at least 2 hours before starting the appliance e Plug into a grounded outlet Thermostat Light on off Up down button settings Manual defrost Set button Using the thermostat For use and settings of the thermostat please refer to the manual supplied with this product Application with XRO7CX type thermostat To see the set point 1 Push the SET key two times the set point will be showed 2 Push the SET key three times to return to normal visualisation To change the set point 1 Push the SET key for more than 2 sec and then push the SET key again 2 The value of the set point will be displayed and the C LED starts blinking 3 To change the Set value push the UP or DOWN button 4 To memorise the new set point value push the SET key three times Note The new set value is fixed even if you leave the settings without the SET button have been pressed 52 Filling the appliance e This product is exclusively suitable for packaged beverages e Please do not store any uncovered food in the appliance e Please fill the product when it is least used Repeatedly opening of doors slows down the cooling e Please store beverages with high alcohol content always upright and ina closed container Fans and air vents in the cooling unit should
4. service technician for repairs e If the power cord is damaged it should only be replaced by the manufacturer or a qualified technician to avoid danger Refrigerant This device contains a refrigerant The type and charge of refrigerant is mentioned on the nameplate e R600a o Contact with liquid may cause cold burns o Exposure to low concentrations may lead to dizziness headache nausea and loss of coordination o After contact with liquid flush with water for at least 15 minutes Obtain medical assistance Exposure to fire may cause containers to rupture or explode Make sure the area around the appliance is always well ventilated Never open an area that is suspected of having a refrigerant leakage 44 During use e Use this product only in a dry and clean environment e Use this product exclusively for cooling of packaged beverages e Never use the device as a stepping stone e Never place electrical appliances inside the appliance e Make sure the grilles are not blocked both outside and in the cooler e Make sure the ambient temperature does not exceed the class climate A Emergency stop VAN UNPLUG POWER CABLE After use e Take care to provide safe storage disposal of the waste product see WEEE regulations 45 E OR Product description Name plate on the inside of the cabinet Door solid or glass Name Plate on the unit On off switch Thermostat light switch Air outlet beh
5. 988 x 516 x 820 840 860 E3 2222GMU82 234W 130kg 4x 6W standard 2542 x 516 x 820 840 860 Conditions Min evaporating T 5 C Max condensation T 45 C Ambient temperature 25 C 57 EC declaration EC DECLARATION CONFORMITY FOR MACHINERY Directive 2006 42 EC Annex Il sub A Manufacturer Gamko BV Address Mon Plaisir 75 4879 AL Etten Leur The Netherlands Herewith declares that the following product e ECO line type E3 E3 22 G MU82 E3 222 G MU82 E3 2222 G MU82 E3 22 G MU84 Oo A is provided as defined in The EC machines Directive 2006 42 EC Electromagnetic compatibility Directive 2004 108 EEC Directive low voltage Directive 2006 95 EEC PED pressunsed equipment Directive 97 23 EC RoHS directive 2071 65 EC Etten Leur 14 01 2014 N Govers Manager Research amp Development 58 WEEE regulation IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION KEEP THESE INSTRUCTIONS IN A SAFE PLACE THE INFORMATION CONTAINED IN THIS BROCHURE IS IMPORTANT FOR THE DISPOSAL OR RE USE OF THIS PRODUCT AT THE END OF ITS USEFUL LIFE Gamko Holding BV is attentive of the care of the environment and meets all requirements contained in the Directive 2002 96 CE known as WEEE or the Directive referring to Waste from Electrical and Electronic Equipment This product conforms to the directive 2002 96 CE At the end of its useful life the produ
6. EDITIE 14016453 E3 line Noverta Premium 000030058 Gebruiksaanwijzing Manuel d utilisation User manual Gebrauchanweisung Chapter 1 General information Thank you for purchasing a Gamko product This manual contains your warranty and maintenance instructions Please keep this document in the vicinity of this product so you will always have it at hand Please carefully read the instructions in this manual before using or install this product Failure to comply with the instructions may cause damage to the product Proper use ensures a long product lifetime All installations must comply with local government and municipal guidelines and installations are to be in accordance with the Machinery Directive If in doubt contact Gamko or your local dealer The information in this manual can be altered without prior notice ATTENTION DANGER You can be in personal danger when ignoring comments marked with this icon ATTENTION WARNING Your product may cause damage if you ignore comments warked with this icon gt gt TIP Useful tools to help you get the best performance from you product 43 A Safety precautions A Technical safety e Check cable for damage before equipment use e Use plug to remove it from the socket e Check the power supply to ensure it is suitability for this device e Make sure the product is positioned firm and level e Always engage a qualified
7. antees optimal operation of the product as well as a reducing energy consumption The legs can be used to level the product properly Adjust the stands 1 with 6 mm Allen wrench in the openings 2 until the product is level Tighten the screws 3 of the foot pieces 1 at the bottom with a wrench when the adjusting device is not accessible from the inside Plug the openings 2 on the inside with the supplied caps 49 DETAILA a Placing the shelves 50 YO Ne Place pin a in the opening b of rails Tilt the shelf support Push both sides of the shelf support towards each other and push the shelf support in place Place the shelf with the openings at the back of the cabinet onto the pins of the shelf support Lower the shelf onto between the shelf support at the front of the cabinet Electrical supply A e This product uses a separate power cable In case this power cable is damaged it Should be replaced by an original equipment manufacturer supplied cable e The power socket must be easily accessible after installation e Check the correct voltage on the basis of nameplate e Check the cable cannot be clamped or get stuck e Use of an extension cord is not recommended e If necessary allows a cable renewal by a licensed electrician Due to under or peak voltage may cause damage so that the cabinet ts turned off Gamko is not responsible for any consequential
8. ct which is to be processed separate from household waste should be transferred to a collection point of separate waste from electrical and electronic equipment The objective of the Directive 2002 96 CE is to combat the increasing volumes of waste from electrical and electronic equipment to increase the re use of electrical and electronic equipment EEE and finally to limit the total volume of waste EEE WEEE destined to be disposed of The symbol of the crossed out waste bin indicates that this product is subject to the application of this Directive It is the responsibility of the user to transfer the product to specialized collection points as indicated by local legislation or the distributor In case of installation of a new product the old WEEE product can be collected by the distributor at the same time The manufacturer importer and distributor are responsible for the collection and processing of the waste which is collected directly or through a collection point The enclosed list contains Gamko Holding BV distributors per country Any violation of the above mentioned Directive will result in sanction measures in all of these countries In general Gamko Holding BV applies the CECED interpretation European Committee of Manufacturers of Electrical household appliances according to which the WEEE legislation is applicable to portable air conditioners dehumidifiers window air conditioning split systems up to 12 kW fridge
9. ind and side Air supply front Height adjustable feet adjustable from the inside and outside 46 Name Plate Gamko BV Mon plaisir 75 4879 AL Etten Leur the Netherlands Gamko CE Type Product type number Refr R Refrigerant type and charge Pwr cons Electric power of cooling unit optional light Supply voltage and frequency Nominal current Climate class lt 4 3x4W max Voltage 220 240V 50 Hz Reg nr 201202 123456 Year of construction Hermetically sealed system 7 X Unique serial code oe Climate class A refrigerator is specified to work within certain temperatures limits This product is suitable for the following class N from 16 C to 32 C Refrigerant A ECO line Noverta Premium R600a Natural refrigerant See safety precautions 47 Chapter 2 Installation Q Tip Never place a refrigerator near any heat sources A Operating principle Cooling works by extracting heat from one space and discharge it to the environment It is recommended to leave at least 10 cm around the appliance for optimal cooling Gees n oe i P Please make sure the air supply and exhaust are not blocked 48 Placing the appliance Place the product in the desired position on a flat surface 2 Place a water level on the product The product is best placed with feet 1 to provide adequate air circulation around the cabinet This guar
10. lectronic 2 C t m 18 C default set point 6 C 2 x 50kg per door E3 22MU84 210W 72kg optional 1434 x 516 x 840 860 880 E3 222MU84 210W 96kg optional 1988 x 516 x 840 860 880 E3 2222MU84 210W 120kg optional 2542 x 516 x 840 860 880 TE E3 22GMU84 222W 82kg 2 x 6W standard 1434 x 516 x 840 860 880 E3 222GMU84 228W 106kg 3 x 6W standard 1988 x 516 x 840 860 880 E3 2222GMU84 234W 130kg 4x 6W standard 2542 x 516 x 840 860 880 Conditions Min evaporating T 5 C Max condensation T 45 C Ambient temperature 25 C 56 Electrical connection Refrigerant Cooling capacity Thermostat Temperature range Max shelve load Type Electric power Weight empty Lighting Locks Dimensions WxDxH Type Electric power Weight Lighting Locks Dimensions WxDxH Type Electric power Weight Lighting Locks Dimensions WxDxH Plug ready bottle coolers E3 82 220 240 V 50 EA i R600a 515Watt 12 cc Electronic 2 C t m 18 C default set point 6 C 2 x 50kg per door E3 22MU82 210W 72kg optional 1434 x 516 x 820 840 860 E3 222MU82 210W 96kg optional 1988 x 516 x 820 840 860 E3 2222MU82 210W 120kg optional 2542 x 516 x 820 840 860 LE E3 22GMU82 222W 82kg 2 x 6W standard 1434 x 516 x 820 840 860 E3 222GMU82 228W 106kg 3 x 6W standard 1
11. nly qualified service personnel should work on this product for maintenance and service purposes d The processing of fluorinated gas in this product such as recharging of the refrigerant must be in compliance with European Community regulation EC No 842 2006 on certain fluorinated gases and the applicable local regulations A R600a Warning a Hermetically sealed system b In case refrigerant leakage is detected the area should be ventilated and qualified service personal should be alerted C Only qualified service personnel should open this product and exchange the cooling unit 60 Gamko BV Mon Plaisir 75 4879 AL Etten Leur P O Box 274 4870 AG Etten Leur The Netherlands www gamko nl 80
12. s and plug in freezer compartments Nevertheless it is possible that in the various member countries differences in legislation are detected In case some products are not included on the list of WEEE products following national legislation the national legislation should be adhered to the WEEE directives applicable to products that are not included in the scope of these national legislations should be omitted The directive does not apply to products sold outside the European Union In case the product is to be sold outside the European Union it is not necessary to adhere to the WEEE directive however the vendor distributor has to guarantee that local legislation is being observed For further information please refer to the local authority for waste collection the vendor distributor installer who supplied the product or directly to Gamko 59 GWP ODP table This product may contain fluorinated gases as mentioned under the Kyoto treaty Chemical name of refrigerant see name plate R134a R600a Global Warming Potential GWP of refrigerant CO 1 1300 3 Ozone Depletion Potential ODP of refrigerant R12 1 O O VAN R134a Warning a Hermetically sealed system D Emissions of the gas must be avoided The fluorinated gas may never escape into the atmosphere during installation use and disposal If leakage of fluorinated gas is detected the leak must be repaired as soon as possible and emission of the gas to be stopped C O
Download Pdf Manuals
Related Search