ANTIBACTERIAL HAND VAC
Contents
1. Gebruiksaanwijzing User manual Gebrauchsanweisung Mon KA Mode d emploi An ANTIBACTERIAL HAND VAC WITH UV LIGHT CVH5743M 09 09 HOME APPLIANCES Montiss English SAFETY REGULATIONS 1 Before using the device please read this user manual carefully Do not use the appliance if the plug the mains cord or other components are damaged 3 Ifthe mains cord is damaged you must have it replaced by Van den Berg Products a service centre authorised by Van den Berg Products or similarly qualified person in order to avoid a safety hazard 4 Repairs should be carried out by a qualified technician only Improper repairs may damage the unit and endanger the user Before use check whether the mains voltage corresponds with rating label of the device This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction regarding the use of the appliance by a person responsible for their safety 7 Keep the device out of reach of children Careful supervision is required if the device is used near children Never allow children to use the device 8 Only use the device for its intended purpose as described in this user manual 9 Do NOT use the unit outside or on wet surfaces 10 Do NOT touch the unit or the plug with wet hands 11 Never immerse the product into water or2. Before replacing the lamp ensure sure the vacuum cleaner is switched off and unplugged at the mains The standard life span of the bulb under normal use will be 2 to 3 years Replacement can be obtained at www muppaz nl detailed in our service form Detach the protection grill on the bottom of the base unit see detailed instruction in Cleaning the UV C lamp Unscrew the screws surrounding the protective housing using a screw driver Using a small pair of pliers at one end of the bulb the silver part rotate the bulb through 90 and remove the protective tube from the bulb 22 English Montiss Insert the new bulb into the protective tube and insert the tube back into the device and rotate by 90 to secure Replace the protective housing and tighten all screws Replace the protection grill and clip back into place see detailed instruction in Cleaning the UV C lamp Safety switches The UV C light will only be activated when the vacuum cleaner is in full contact with the surface being cleaned On the bottom of the base unit there is a pressure sensitive wheel Fig 9 that is activated when placed in contact with a surface that needs to be cleaned There are also another 3 sensors that must also be activated for the UV C lamp to work Fig 9 Do not manually override the pressure sensitive wheel or cover the sensors Pressur KR Sensitive Sensors Wheel 23 Montiss En
3. cleaner is inserted release the lever and press the vacuum cleaner down until you hear a CLICK see pictures below Step 1 Montiss English Step 2 Step 3 1 Switch on the unit using the on off switch Fig 1 The UV lamp will come on when the UV safety switch is in contact with the surface This can be checked through the verification windows on top of the unit Caution prolonged exposure to UV light can be harmful Do not override the safety switches manually Caution do not attempt to pick up large or sharp objects as these may cause damage to the vacuum cleaner Fig 2 Fine dust such as plaster and cement must not be picked up as they will block the filter English Montiss Using the hand vacuum only To remove the cleaner from the base press the lever at the rear and lift the handle Certain tasks may require the use of the nozzle or brush attachments These tools are stored in the base unit Fig 3 4 and 5 Guidelines for cleaning your mattress and or bed In order for the UV C light to be fully effective against dust mite and bacteria it is important that the area is exposed to UV C light for adequate time Please adhere to the following guidelines 1 It is best to start in one corner of the bed 2 Press the unit flat against the mattress 3 In order for the UV C light to activate all sensors must be placed on the mattress 4 Ensure the unit is moved in a smooth and
4. steady motion 5 TO ensure every part of the mattress is covered follow a set plan such as detailed in diagrams A and B 6 With double beds it is advised to clean one side at a time 7 Move the UV C vacuum at a speed less than 20 seconds per meter and repeat 3 times 8 Itis advisable to clean both sides of the mattress if possible 9 We suggest a similar method for bedding such as duvets and pillows 10 Used Mattresses It is best to clean on a daily basis for the first 7 days and than once a month thereafter New Mattresses it will be sufficient to clean once a month only 11 If cleaning carpets follow a similar method CARE AND MAINTENANCE Dust container and filter Allergy sufferers When emptying any vacuum cleaner it is difficult to avoid exposure to dust To minimize this risk of exposure please ensure that you encase the dust container in a large bag to empty it and close the bag as tightly as possible round the container Remove the container and close the bag as tightly and quickly as possible and dispose of this immediately It is advisable to wear disposable clothes and a face mask while emptying the cleaner If at all possible ask a non allergy sufferer to empty the dust container when required Montiss English It is important to ensure that the dust container is emptied and the filter cleaned regularly If it is not done the cleaner will lose its effectiv
5. any other liquid 12 Keep the vacuum cleaner and the accessories indoors and in a dry place 13 Do not use the appliance if any of the openings are blocked 14 Keep the device free of dust lint hair and anything that may reduce the air flow 15 Apart from replacing the UV C bulb this appliance contains no user serviceable parts 16 There are a number of safety switches on the bottom of the unit These switches prevent the UV lamp activating when the product is removed from the cleaning surface The UV lamp will reactivate when placed back on the cleaning surface 17 For your safety do not try to manually override the safety switch 18 Do not touch the UV C bulb directly after use as it will be hot and may burn 19 Do not pull the plug from the wall socket by its power cord To pull the plug from the wall socket take the plug and carefully pull it from the wall socket 20 Do not leave the device unattended when the plug is in the wall socket Remove the plug from the wall socket when you are not using the device or when carrying out maintenance 21 Turn the power switch to oft before you pull the plug from the wall socket or before placing the plug in the wall socket 22 Do not pull or carry the unit by its power cord and do not use the power cord as a handle Do not close the door on the power cord or pull it around sharp edges or corners 23 Do not use any accessories that are not recommended by the supplier especially not ac
6. cessories that have not been supplied with the device 24 Always switch the product off before you attach or remove the accessories 25 This unit is designed for vacuuming dry material Do NOT try to suck up liquids or moist materials of any sort as there will be a high risk of electric shocks 26 Do NOT vacuum anything burning or smoking like cigarettes matches or hot ashes 27 Do not vacuum hot liquids acids and solvents 28 Do not vacuum any sharp objects 29 Do not use any harsh cleaning chemicals to clean the unit as this may lead to discolouring of the unit 30 Keep the unit away from heat sources such as radiators to prevent deformation of the plastic parts GK English Montiss THE PRODUCT D 1 DESCRIPTION OF THE PARTS Handheld vacuum cleaner l 2 On off switch 3 Lever to lock handheld unit 4 Base unit 5 Verification windows 6 UV lamp 7 Lamp protection grill 8 UN safety switches PRODUCT FEATURES Sterilising function of the UV light kills 99 9 of all bacteria An ideal device to remove bacteria from your mattress and eliminate mites from your home Perfect for cleaning and treatment of the fabric of your sofa s curtains and carpets Can be used for thorough cleaning cat and dog baskets Ideal for allergy sufferers USE OF THE DEVICE UV C and vacuum function combined Press the lever down Insert the vacuum cleaner while holding the lever down Once the vacuum
7. eness It is best to empty and clean after each use Disconnect the cleaner from the supply and separate it from the base section by pressing the lever Press the dust container lock button to release the dust container from the vacuum See Fig Pull the filter assembly outwards and empty the dust from the container into a waste bin See Fig 7 Fig 7 Unlock the outer microfiber filter by twisting to the right The HEPA filter should pull away freely from the main casing The filter should be cleaned every time the dust container is emptied by tapping them on the side of the dust bin to release any trapped dust Reassemble in reverse order Cleaning the UV C lamp During use dust will settle on the protection cover which may reduce the effectiveness of the UV C light It is therefore important to clean this periodically Detach the protection grill on the bottom of the base unit by pulling the 2 clips up with your thumbs see picture below a 20 English Montiss Use a soft lint free cloth to wipe any dust or dirt away from the protective tube surrounding the UV C bulb 1 Relocate the protection grill by inserting the 3 pins in the openings on the front side of the device 2 After inserting these pins push the grill down at the side of the 2 clips until it locks in its place you will hear a click see picture below Step 2 Step 3 21 Montiss English Replacing the UV C lamp
8. glish TROUBLE SHOOTING Full dust container Empty dust container UV light not Vacuum cleaner not Ensure the cleaner is securely locked in activated fitted to base unit position correctly Sensor switches only operate when the Safety switch not base is level and in contact with the depressed or sensors surface being cleaned not activated DISPOSAL OF YOUR APPLIANCE 1 When this crossed out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002 96 EC 2 All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities 3 The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health 4 For more detailed information about disposal of your appliance please contact your city office waste disposal service or the shop where you purchased the product TECHNICAL DETAILS Model number CVH5743M Power 400W Nominal voltage 220 240V Nominal frequency 50Hz UV C lamp power SW UV C wavelength 253 7nm Montiss is a registered brand name of Van den Berg Products BV IJzerwerf 10 12 6641 TK Beuningen The Netherlands www vdbergproducts com 24
Download Pdf Manuals
Related Search