Servos : 4 Please use common sense.
Contents
1. The ESC needs to know the max RPM under load This information is gathered during the first run after setup The ESC now knows the Maximum RPM and will save this setting Half of the throttle throw is also half the RPM etc Setting the RPM to high can overload and damage the ESC Read warranty note NOTE If you wish to change the settings repeat above procedure After switching on the ESC you always hear e One beep Setup for NiCd or NiMh Packs or e One beep setup and one beep per LiPo cell in lipo mode When the ESC receives a correct signal from the receiver and the transmitter has the throttle in the off position you ll hear a activation signal An optional PC interface cable is available from dealers with this cable more settings are available e g fixed timing hard medium soft brake and low voltage protection DATA Cells 6 16 Cells 6 12 with BEC 2 5 Lithium Polymer Max Amps 30A 10 sec 40amp Servos 4 WARRANTY The Tsunami 30 has a year limited warranty against failure All modes where the temperature control is disabled are not covered by warranty Reversed polarity of batteries is also not covered If an ESC breaks down we can measure read out the last settings in the micro processor so we can tell what mode was used and what were the settings Removing the shrink tube or soldering of any nature will also void warranty Using the PC interface cable program is also not covered under this warranty Safet2. Tsunami 30 Controller for Brushless Sensorless motors User manual RC Setup description The setup mode is started when the ESC receives pulses longer than 1 5ms full throttle for 5 seconds right after switching on Switch on transmitter Full Throttle Switch on receiver and ESC After 5 seconds you ll hear a fading 3 beeps NiCad NiMH Move Throttle to off position Wait until you hear the mode you want to select When you want to use Mode 1 wait until you hear 1 beep Mode 2 2 Beeps etc Immediately move stick to the full throttle position wait for 1 beep storage of full Throttle and Mode settings Now move the throttle to your desired start position Normally the OFF position You ll now hear confirmation of Mode 1 2 3 4 5 beeps Stick to full and than 3 fading beeps and confirmation storing of settings mode AIC type Brake Soft Over Temp Throttle Motor RPM RPM start protection Down on Stall control Limitation low voltage Protection 1 E Sailplane Medium On On On On Off On 2 Motor model Off Off On On On Off On 3 Heli Off On Off Off Off On Off 4 Contest mode Hard Off Off Off Off Off Off 5 Lipo cells 2 5cells Lipo mode 5 After programming stick to off position then wait till correct amount of cells beeps is reached stick to full wait for confirmation take battery of In Heli mode you must set a desired RPM at a desired stick position
3. y Precautions Always reed the instruction first supplied with your equipment used in conjunction with this ESC Always stay clear from a rotating Propeller rotating propellers can cause great harm body injury death or property damage Never run a motor while holding in your hands always use a Jig or mounting bracket when you want to test run a motor Please use common sense
Download Pdf Manuals
Related Search