Infinity #2
Contents
1. iNOLINA LLY Ay AC Alternating Current See Definitions of Symbols section Protective earth Ground IPxy Protected against splashing water PE PN NPE Rien eine eR erat mie A va WARNING IN Attention Consult accompanying documents THIS DEVICE SHOULD ONLY BE CONNECTED TO HOSPITAL GRADE OUTLETS FAILURE TO DO SO MAY RESULT IN i C OFF B ELECTRICAL SHOCK DUE TO IMPROPER GROUNDING i i F ATTENTION ON KE CET APPAREIL DOIT ETRE BRANCH A UNE PRISE DE E TERRE ADEQUATE 22 f ADVERTENCIA gt Type B equipment R d ESTE DISPOSITIVO DESE CONECTARSE UNICAMENTE A Protected against electrical shock TOMACORRIENTES DE GRADO HOSPITALARIO 5 NO S HACE AS PUEDE PRODUCIRSE UN CHOQUE ELECTRICO A CAUSA DE UNA PUESTAA TIERRA INADECUADA 4 Dangerous voltage 70 22080 Rev S in DENTAL UNIT STANDARDS amp MAINTENANCE HANDPIEGE COMPATIBILITY This delivery system is designed to be compatible with air driven pneumatic handpieces that conform to ISO 13294 The air driven pneumatic handpieces tubing and connectors are available in either 4 hold Midwest or 3 hole Borden tubing other configurations are available under special order The end user dentist will have specified the preferred type of connection during ordering It is the responsibility of the end user dentist to procure appropriate handpieces to work with the handpiece connections specified at time of order confirmation Certain countries may have p2. Annex IX of the MDD 93 42 EEC accordingly the provisions of Annex II apply NOTE Regarding International Electrical Specification Dansereau does not supply provi sions for international power requirements This will be configured by the equipment dealer in the country of destination SAFETY AND IDENTIFICATION MARKINGS CAUTION Failure to carefully follow the Safety Labels described procedure may result in damage to EE RISK OF EXPLOSION IF USED IN THE 2 the equipment PRESENCE OF FLAMMABLE ANESTHETICS WARNING Failure to carefully follow the RISQUE O EXPLOSION FN PRESENCE DE e A PRODUITS ANESIHETIQUES INFL AMMASI FS vu described procedure may result in damage to RIESGO DE EXPLOSION SI SE UTILIZA EN the equipment and the operator PRESENCIA DE ANESTESICOS INFLAMABLES ELECTRIC SHOCK HAZARD DO NOT REMOVE COVER REFER SERVICING TO QUALIFIED SERVICE PERSONNEL gt m z g A mm E O 3 A DANGER F Risk of electrical shock present Make sure or AN power is disconnected before attempting this E gt procedure RISQUE D ELECTROCUTIDN NE PAS OUVRIR LE GOUVERCLE FAIRE APPEL UN I TECHNICIEN QUALIFI Fv AAN RJESGO DE CHOQUE ELECTRICO NO QUITE LA CUBIERTA CONTRATE EL SERVICIO CON PERSONAL DE SERVICIO CALIFICADO Os mom FEV IEC Symbols The following symbols conform to IEC labeling standards and may be located throughout the product CAUTION gt CAUTION
3. flex arm to hold a stable vertical position with items on the unit tray if required INFINITY CUSPIDOR OPERATION Ceramic Top of Cuspidor Ceramic Lower Front of Cuspidor Water Quick Disconn ct Left Side Under side of Cuspidor Cuspidor Rinse Timer Adjustment Valve Cuspidor Rinse Bowl Activation Button Cup Filler Cuspidor ee DON i Activation Button Rinse Bowl Activation Ceramic Bowl Button Mounting Screws Cuspidor Rinse Water Flow NOTE To Remove Cuspidor Bowl and access internal components remove Ceramic Mounting Screws firmly grasp the Ceramic Bowl and rotate bowl side to side while pulling up Bowl will work loose from Drain Housing Lay the Bowl to the side while working on internal components START UP AND DISINFECTING UNITS Dental Unit Start Up Check to see that the master on off toggle in in the OFF position Turn on the master air and water valves located in the dental junction box Make visual inspection for air or water leaks Turn the master on off toggle to the ON position and make a complete inspection for the leaks in the following applicable areas e Junction Box e Utility Center e Control Head e Internal plumbing of the control head Check air and water pressure on the junction box gauges The gauges must read e Air 75 to 80 psi e Water 35 to 40 psi Turn the air regulator knob clockwise to increase the pressure and counterclockwise to decrease For an accurate rea
4. America s Dental Equipment Company INFINITY DELIVERY SYSTEM w Cuspidor Owners Guide 2019 Rev 2 15 Dansereau 800 423 5657 WWW DHPDENTAL COM DANSEREAU HEALTH PRODUCTS INC AMERICA S DENTAL EQUIPMENT COMPANY Dansereau Health Products Inc has been manufacturing dental equipment for over 40 years We have compiled a significant amount of data and information regarding the manu facturing use and maintenance of dental equipment Information contained in this manual will assist you in use and maintenance of your Dansereau equipment We offer the most comprehensive 10 year warranty on USA manufactured dental equipment today Our customer service department is the most progressive within the dental industry with an ever growing series of support documents and video available thru E mail and the Internet They are easily accessible and completely descriptive for the dentist staff or any technician to use in the long term support of Dansereau Health Products Inc SUPPORT ACCESS Dansereau Health Products Inc 1581 Commerce Street Corona CA 92879 Toll Free 800 423 5657 951 549 1400 Fax 951 549 1411 Website WWW DHPDENTAL COM TESTING LABORATORIES ETL Testing Lab Report 4530937 Medical and Dental Equipment Category 6 UL 544 2nd Ed CAN CSA Testing Laboratories Report 531003 Canadian Standard for Medical Electrical Equip No 601 1 M90 US Food and Drug Administration Medical Device Regist
5. acuum Fitting installed within the Dental Junction Box a SY EH i l i J J av Pi Dental Unit is Assembled y N and Installed OPERATING INSTRUCTIONS Handpiece Connections 3 Way Syringe 2 High Speed w Water 3 High Speed w Water 4 Low Speed No Water Handpiece Controls 1 High Speed Air Adjustment 2 High Speed Air Adjustment 3 Low Speed Air Adjustment Delivery System Controls 1 Master On Off Toggle 2 Water Flow Adjustment Water On Off Toggle Air Lock Flex Arm OD 4 Operation Specifications 1 3 way syringe offers two buttons to activate and air and water flow both buttons can be activated and creating an air and water mist 2 High speed handpiece connections are threaded connection for attachment of a high speed dental handpieces Water and air are supplied 3 Low speed handpiece connection is a threaded connection for attachment of a slow speed dental handpiece Air is only supplied 4 High and low speed adjustments increase or decrease air flow to dental hand pieces 5 Master on off toggle extremely important item that turns off dental delivery system at the conclusion of the work day Must be on to use dental delivery system 6 Water flow adjustment increases or decreases water flow to handpieces 7 Water on off toggle turns on or off water flow to handpieces 8 Air lock flex arm toggle activated a brake in the flex arm mechanism to allow the
6. articular regulations regarding which handpieces are acceptable for use e g countries in the European Union require handpieces which meet the requirements of the medical devices Directive 93 42 EEC NOTE Regarding International Electrical Specification Dansereau does not supply provisions for international power requirements with the dental unit SUGGESTED TOOLS Allen Wrench Set 9 16 Socket Wrench 7 16 Open End Wrench Chanell Locks 1 2 Socket Wrench REPLACEMENT PARTS The following represents a condensed list of maintenance parts that may be used during the normal lifespan of the dental unit Contact Dansereau direct for a complete list of additional parts 800 423 5657 Master Shut Off Valve Filter DA1238B Saliva Ejector Tip QTY 5 4DA1284 2 Ny Amalgam Trap Solids Filter QTY 10 DA1234 Amalgam Trap Mounting Bracket DA1231 I DENTAL JUNCTION BOX CONNECTIONS Local building codes and regulations may require licensed plumbers and electricians to install utilities Make sure all plumbing conforms to prevailing local building codes and regulations Air Supply from Compressor 1 2 pipe NPT protruding 1 from floor or wall with 1 2 x 3 8 compressor fitting angle stop required Supplied by contractor Air pressure from dental air compressor operating range 80 to 100 PSI Air from dental air compressor must be clean and dry Air plumbing lines must be flushed clean before making final dental junct
7. ding from the gauge bleed off the air pressure by using the air syringe button on the 3 way syringe Adjust the air pressure regulator knob in half turn steps CAUTION Pressure adjustments should be completed in a series of short steps Avoid running handpieces for extended periods longer than is required to check pressure Extended running with no load can damage the handpiece No handpiece should ever be run without a bur in the chuck CAUTION When not in use the master switch should be left in the OFF position The master switch is an important safety device that must be utilized to prevent accidental flooding and water leaks STERILIZATION TECHNIQUES Infection control in the dental facility continues to be a high priority for all staff working within the dental office OSHA the ADA and CDC are all involved in this complex is sue Dansereau will not attempt to specify the required intervals for disinfection nor can they recommend the overall best surface disinfectant You can refer to the appro priate organizations for more information on disinfecting your dental equipment Techniques Barrier Technique Dansereau does advocate the barrier technique whenever possible The use of dis posable barrier s with changes between patients will ensure the finish and appear ance will be preserved Chemical Disinfection If chemical disinfection is the disinfection method of choice it is imperative that a mild soap and warm wate
8. ion box connects Water Source 1 2 pipe NPT protruding 1 from floor or wall with 1 2 x 3 8 compressor fitting angle stop required Supplied by contractor Water Pressure Operating Range 40 to 80 PSI Water plumbing lines must be flushed clean before making final dental junction box connects Electrical 1 2 conduit and box with duplex outlet supplied by contractor Wire electrical box as per code Horizontally no higher than 4 from finished floor Central Vacuum Vacuum system plumbing specifications to be supplied by central vacuum sys tem supplier Terminate in the dental junction box according to dental junction schematics Confirm line sizes with central vacuum system supplier Gravity Drain Cuspidor 1 Tube protruding 1 from finished floor NOTE Conform to local building codes Vented plumbing trap is required INFINITY UNIT SIMPLE ASSEMBLY GUIDE DISREGARD TELESCOPING ASST ARM IF CUSPIDOR SYSTEM IS INCLUDED Remove Unit 1 3 Install Telescoping Assistants from Shipping Pallet Arm on Bi Folding Arm p N wae ap Place the Mounting Plate Under 9 the Steel Plate for the Dental Chair Align with the 5 Holes 4 Install Amalgam Trap on Telescoping Assistants Arm pr WA AR ut I 5 Insert Master Valve Nipple into the Angle Stop and Tighten Nut Using Socket Wrench Install all 5 Bolts with Locking Washers 6 Slide on the Vacuum Tubing to the V
9. l dam ages will be allowed All replacement parts claimed defective will be filled in the usual manner such invoice being subject to adjustment after the alleged defective material has been returned and inspect by the manufacturer The warranty does not cover damage resulting from improper installation maintenance accident or misuse
10. n our Dental Chairs and Delivery Systems with complete features listed below 3 Years 100 4 10 Years Prorated Annually Delivery System Internal Tubing against leaks Master Valve Regulators Handpiece Control Blocks Not Gaskets Light Posts Automatic Handpiece Holders Delivery Sys tem Water and Air Flow Control Valves Stool Cylinders Manual Chair Switches De livery System Flex Arm Delivery System Telescoping Arm Cuspidor Frame 1 Year 100 Diamond Dental Light Chair Foot Control Stool Ring Stool Seat Stool Casters Circuit Board and Prepositioning Switches 6 Months 100 Base and Unit Cover parts 3 way syringes Delivery System Foot Control and Fiber Optics Systems 30 Days 100 Dental Light Bulbs Fiber Optic Light Bulbs X ray View Box Light Bulbs Broken or User Damaged Items are Not Covered under Warranty Minimum Maintenance is required in order to quarantee full use of warranties All dental delivery systems require clean dry air to allow the proper lifespan to the micro valves within the dental delivery system If your air compressor does not have an adequate drying and filtration system the warranties of the micro valves on off toggle valves relays regulators master valves foot controls 3 ways syringes and automatic blocks may be void GUARANTEE Dansereau will guarantee against defects in material and workmanship Defec tive parts will be repaired or replaced no claim for labor or consequentia
11. r be used once per day to mitigate the residual effects of chemical disinfection solutions When using chemical disinfection solutions always pay strict at tention to use detail including appropriate measurements when using concentrated disinfection solutions disinfection solutions used in the recommended strength can be relatively harmless to surfaced of dental equipment Unacceptable Disinfectants GConditional Accepted Disinfectants Disinfectants with the following Disinfectants with the following compositions will harm the surface compositions have been found to be finishes of dental equipment and the LEAST HARMFUL to equipment are not recommended Use of surfaces by our test methods these products will void your warranty Chemical Composition Chemical Composition Strong Phenols lodophors Phenol Alcohol Combinations Mild Phenols Sodium Hypochlorite Household Bleach Glutaraldehyde Phenol Sprays Alcohol Alcohol Based Wipes Synergized Super Quat Household Cleaners Phenol Water Sprays Damage and discoloration of the surface finishes caused by disinfectants are NOT covered by warranties lodophor based disinfectants will cause yellow staining on many surfaces Regular washing with soap and water will minimize this staining lodophor neutralizers such as Promedyne are also available WARRANTIES Dansereau has the most comprehensive product warranty programs available to the dentist today We offer a 10 Year Warranty o
12. ry 202716 DENTAL UNIT SPECIFICATIONS No Electrical Components are installed in the Dental Unit Dental Unit Weight 97Ibs IEC Medical Device Classification Classification 2A Type B Operation Mode No Electric in Dental Unit Splash Protection IPX4 Maximum Torque of Accessory Items 60lbs ft 81 N m DANSEREAU HEALTH PRODUCTS INC AMERICA S DENTAL EQUIPMENT COMPANY TECHNICAL DESCRIPTION The dental delivery system is a combination of dental equipment components used to carry position and control the devices used in the practice of dentistry Delivery systems provide handpiece connections that deliver air water and vacuum to the patient Delivery systems generally have several components all are needed to provide dentistry including a control head cuspidor system assistants utilities and a junction box Delivery systems can be mounted to the wall cabinet dental chair or a mobile cart Air water vacuum drain and generally enter the system through the junction box Shut off valves and pressure regulators are located in the junction box Tubing delivers air water and vacuum to the control head for operating pneumatic items The control head contains adjustment knobs for controlling handpiece pressure and the amount of coolant air and water The dentist controls the rate and flow through the pres sure applied to the foot control or syringe buttons The dental chair is classified as a Class 2A product under rule 11 of
Download Pdf Manuals
Related Search