for the MAC - Textfiles.com
Contents
1. OUTDOOR PROTECTION DOME for the MAC yv Mart n Version 970826 MA Assembly Procedure Triangle notch points down Reinforcement plate L shaped lip Leave top and bottom holes free Assembling the side plates 1 Remove the parts from the packing boxes 2 Assemble the plastic side plates Stand 2 plates with the L shaped lip pointing up Fit the plates together with the ends overlapping Place a metal reinforcing plate behind the joints with the notch pointing down Start 6 self tapping screws M4 x 10 mm in each joint leaving the top and bottom holes free Make sure these holes are lined up as you tighten the screws MAC 1200 Dome only Repeat with the other 2 plates 3 Place an assembled set of side plates on a level surface Sealing the polycarbonate dome with silicone is recommended but not absolutely necessary if total disassembly of the DOME is required If sealing cut 20 to 25 mm off the end of the sealant applicator tip Apply a heavy bead about 7 mm of sealant in the corner of the L shaped lip 4 Lineup the holes in the rim of the polycarbonate dome with the holes at the top of the side plates and set the dome on Place rubber grommets at the 4 screw holes between the PN 510942 Outdoor Protection Dome 2 10 11 dome and the side plates Insert screws M4 x 20 mm From inside put a washer and thumb nut on the screws and hand tighten If the nuts are hard to start behind the reinforc ing plate2. Protection Dome 4
3. s the washers may be omitted MAC 1200 Dome only Place the assembled dome and side on the other side section Rotate the upper section so that the reinforcing plates are offset 1 4 turn from the reinforc ing plates in the lower section Insert M4 x 20 mm screws in the 4 holes Place a washer and hex nut on each screw and tighten There are two ways to lead the power and control cables into the bottom of the base through the square hole or the smaller slot For temporary installations use the square hole for easier access The slot may provide a more secure cable lead for permanent installation If the slot is used remove a side plate from the base assembly in order to pass the power and control cables through the slot Feed the control cable up through the peanut shaped ventilation hole to the top of the base section Reach inside the base and plug the power cable into the male power connector This con nector feeds power to the cooling fan as well as the socket on the base Mount the base in position The DOME may be secured through 4 holes in the base Make sure that the air vents are not obstructed and that air can circulate in and out Do not locate the DOME in low spots where water can collect Install the plug on the MAC power cable See user manual for details Plug the power cable into the base Place the MAC on the base Make sure the base ventilation holes are not blocked MAC 500 600 Dome only Align the base of the MAC with
4. the raised mounting plate Lock the MAC to the base by inserting the quarter turn fasteners into the MAC base and turning them a full quarter turn clockwise Hemove the 4 screws located every 90 degrees around the top from the base Place the upper section on the base Rotate the upper section until the joints are offset 1 4 turn from the joints in the base Replace the 4 screws and tighten Safety Precautions Do not place the DOME where water can build up Always stand the DOME vertically with the clear plastic dome on top The DOME is not designed to be used in any other position Make sure the base air vents are not blocked Do not paint or cover the DOME or in any way block the light path Always connect the DOME to mains power as specified on the serial number label Use only undamaged cables rated for outdoor use Do not disassemble the base There are no user serviceable parts inside PN 510942 Outdoor Protection Dome 3 Specifications GEM eo Rs annem oe E M UT TET IP 44 e MAC 1200 Dome Power and Current 160 W 0 7 A at 230 V 50 Hz e MAC 500 600 Dome Power and Current 105 W 0 5 A at 230 V 50 Hz AC Voltage and ErequeHoy ecoute tested he bes Es 230 V 50 60 Hz amp Diameter eis che Aas ta ass vet delle d eiieh eL Eod sr epe Re aM DE sleas 825 mm 9 WIAC 1200 Dome Here B uote atout essc te tse estes 1380 mm MAC 500 000 Dome Hels ht aede radere a ret eer Dr e Pa 1020 mm PN 510942 Outdoor
Download Pdf Manuals
Related Search