Owners Manual - ConvaQuip Industries, Inc
Contents
1. 1 minute before inserting a different battery and using the system again If the system is not to be used for an extended period several days or weeks the battery should be removed from the controller to avoid deep discharge which can cause lasting damage to it Handling Avoid getting metal shavings or other magnetic objects on the battery poles or in the controller Wait before Operation inserting battery Not possible gt 30 seconds Not possible gt 30 seconds gt 30 seconds Not possible gt 30 seconds gt 1 minute OD g O O D z i 09 D X Z 2 x Ta ie D E x lt x lt2. MANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL KOSTANTI Total length lowest position 140 c Products which have been used for purposes other than the intended use or which have been subject to negligence abuse improper storage or handling The XXL Rehab Shower Commode Tilt is covered by one year warranty from the invoice date for materials and workmanship improper operation unauthorized modifications or damages beyond normal 8 wear and tear as determined by XXL Rehab are not covered by this warranty Seat height PAA Backrest 24 5 8 11 4 repairs to product part as well as tampering with any components will Height of footrests 40 48 c void the warranty Electric tilt 0 32 6 5 If weight capacity is exceeded the warranty will be void Any unauthorized Width of footrest 5 N BI Width between standard armrests 6 i 7 0 2 6 cm 4 cm 53 cm 110 cm 1 cm ieee spare parts from XXL RehabApS may be used in connection XXL Rehab ApS cannot accept responsibility for defects or accidents that arise when repairs are carried out by personnel who have not been approved XXL Rehab Shower Commode Tilt has been manufactured and tested in ac cordance with international standard DS EN 12182 2000 No a 8 cm Control via the control panel Capacity up down fully charged battery Approx 20 times Turning radius 15 Folding armrests Powder lacquered chromium molybdenum steel Wheels diameter 150 mm Sea
3. of the commode seat mame and the toilet bow or the bedpan Special care XXL Rehab Shower Commode Tilt Particular attention should be paid to should therefore be taken when moving the shower commode in warnings marked A above the toilet or when placing a bedpan beneath the seat In addition the shower commode may only be operated by trained personnel or people who have been instructed in its use as there will otherwise be a danger of users being injured handle and the seat frame when the seat is in its highest position There is a risk of the caregiver s hand being caught between the A Both wheels with brakes must be locked when moving a user to and from USE the shower commode and when a user is sitting in it except when it is being used as a means of transport XXL Rehab Shower Commode Tilt was designed to help people weighing up to 325 kg to be moved to and from a bathroom to shower and to use the A The shower commode seat must be in its lowest position when transport toilet ing a user There will be a serious risk of tipping if a user is transported with the seat at A There may be a risk of tipping or damaging the shower commode if it is a higher level used in connection with people weighing more than 325 kg A The shower commode was not designed to run over obstacles such as A XXL Rehab Shower Commode Tilt must only be used on a flat firm sur doorsteps etc The shower commode may only be used on a flat firm surfa
4. REHAB SHOWER CommoDE aka Model SCT715 TILT distributed by ConvaQuip Ind Inc USER MANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL Instructions for using XXL Rehab Shower Commode Tilt CAUTION CAUTIONA NUSE This product should not be used without proper instruction from a healthcare A The footplates must not be stood on or used as a step when moving the professional user or there will be a serious risk of tipping Using the product for individuals weighing more than the maximum weight bearing capacity may pose a risk for damaging the product A Risk of injury XXL Rehab assumes no responsibility for any damage or injury caused by There may be a risk of fingers or limbs being caught between the improper installation assembly or use of this product armrest and the side of the shower commode if the user is sitting in If components are damaged or missing contact XXL Rehab immediately Do NOT use substitute parts XXL Rehab cannot be held liable for faults or accidents occurring after There is a risk of feet being caught between the footplates if the repairs by service staff without written authorisation from XXL Rehab locking bolts are not correctly inserted into the holes in the footrests it when the armrests are moved into position There is a risk of fingers or limbs being caught between the shower A Please read these instructions carefully to ensure the correct use
5. ce face with a maximum gradient of 3 to avoid the risk of tipping to avoid the risk of tipping A If the user is unable to move to the shower commode unaided caregivers BEFORE USE must make sure they use correct lifting and moving techniques when help ing the user into it This applies irrespective of whether they use a hoist a The armrests must be correctly inserted into the holes in the sides of the roll board or other support when moving the user shower commode The width between the footrests can be adjusted stepwise The locking bolts MAINTENANCE AND CLEANING beneath the footplates must always be correctly inserted into the holes in the footrests The locking bolts for the footrests must not be tightened White frame components the seat and armrests can be cleaned with water outside the holes and an ordinary detergent The PUR seat must be correctly mounted on the shower commode seat To make cleaning easier the PUR foam seat can be removed and replaced frame without the use of tools A The shower commode must not be used before the armrests have been Bolts and lock nuts must be inspected regularly and tightened if necessary correctly mounted to avoid the danger of the user falling out to the side Failure to inspect bolts can lead to malfunctions g g O O D z i ep 2 i D o x lt X lt REHAB SHOWER COmmoDE aka Model SC1715 TILT distributed by ConvaQuip Ind Inc USER
6. e driven in one direction normally in Flat battery If the battery level goes below a minimum level while operating the actua tors 1 short buzzer tone is sounded The actuators will stop immediately and the controller will shut down The battery must be charged You must wait at least 1 minute before inserting a new battery into the controller If you are using actuators with position feedback hall efect you will need to perform O point calibration See section about 0 point calibration below Battery mounted in charger The yellow LED lights up when the charger is connected to power Place the Extreme battery load battery in the charger by sliding it in and rotating it until it is pulled into The battery may become too hot if it is subject to extreme load due to re place by the magnets The green LED will flash at approx 1 second intervals peated operations in rapid succession thereby activating the batterys safety while the battery is being charged Once charging is complete the green LED thermostat The controller will shut down and the battery must be allowed to remains permanently lit Remove the battery by rotating it 90 degrees It will cool for at least half an hour before being used again You must wait at least then be ejected and be ready for use 1 minute before inserting a different battery into the controller If you are using actuators with position feedback hall effect you will need to perform Once the battery is ful
7. ly charged insert it into the controller Follow the same 0 point calibration See section about 0 point calibration below procedure as for the charger If everything is OK the controller will simply sound a beep 3 seconds once the battery is in place If the system has any NB An alarm only sounds during operation of the actuators No alarm will faults the beep will be followed by 2 or 5 buzzer tones sound while the system is inactive even if the battery is close to requiring recharging It is therefore recommended that you always keep a charged 2 long buzzer tones The controller requires 0 point calibration battery on hand when using the system See section about 0 point calibration below 0 point calibration If you use actuators with position feedback hall effect you will need to per form 0 point calibration on the controller so that the innermost position of the actuators can be recorded This must be done for all actuators which use position feedback The controller will sound 2 long buzzer tones following the beep when the battery is inserted if 0 point calibration is required 5 short buzzer tones The battery must be charged See above It is not possible to operate the actuators The two fault notifications maybe sounded successively if both faults are present It is also possible to initiate manual 0 point calibration by holding in both buttons for the relevant actuator s for 12 seconds The controller sounds a beep f
8. ollowed by 2 long buzzer tones and 0 point calibration can be performed by pressing the in button and holding it so that the given actuator s is are driven in Hold down the button until the actuators have been driven fully in The controller has now been 0 point calibrated and the system may be used normally The actuators can only be driven in during 0 point calibration g E O O D 1S ep E D x Z w x 2 i D o x lt x lt Battery controller and remote control Battery mounted in the controller ready for use REHAB SHOWER COMMODE aka Model SCT715 TILT distributed by ConvaQuip Ind Inc USER MANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL TIPS It is recommended that you follow the tips below to achieve the best results and avoid problems in daily operation General Always wait at least 2 seconds after the last actuator has stopped before removing the battery from the controller Otherwise controllers using posi tion feedback may not have time to store the position and the controller will have to be 0 point calibrated again If the battery s safety thermostat is activated due to overload the battery must be allowed to cool for at least half an hour before being used again A new battery may be inserted into the controller after 1 minute If two or more actuators which operate in parallel become misaligned the cont
9. roller will automatically shut them down It will then be necessary to perform 0 point calibration again as described in section about O0 point calibration TROUBLESHOOTING If problems or irregularities arise you should go through the points below in consultation with a technician where appropriate Check that all connectors are correctly attached to the controller Check that the controller sounds a beep when the battery is inserted If the actuators cannot be operated perform a 0 point calibration as explained above The following table lists the alarms which can be sounded by the controller what causes them and the action required in each situation Note the waiting times in the right column as it is important that these are observed ear None None operation Min level during operation Stops can only drive in Insert battery 5 x short 3 x short Shutdown Stops and shuts down If none of the above resolve the problem please contact the supplier MANUFACTURER XXL Rehab Fuglebaekvej 1D DK 2770 Kastrup Denmark Tel 45 70 25 25 22 Fax 45 70 25 25 44 www xxl rehab com Batteries Always use batteries which are in good condition and fully charged when inserted into the controller You can extend the lifetime of the battery by occasionally recharging it even though it is not fully discharged If the battery level drops below the critical level and the system shuts down you must wait at least
10. t back armrests Polyurethane IP klassification IP44 ISO klassification ISO 09 12 03 23 Frame Calibration Hold both buttons for about 20 seconds XXL Rehab Shower Commode Tilt REHAB SHOWER CoOommoDE aka Model SC1715 TILT distributed by ConvaQuip Ind Inc USERMANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL USERMANUAL Instructions for battery and actuators PREPARATION When the battery requires recharging transfer it to the charger as described above It is recommended that you keep an extra battery on hand to avoid Before the system may be used the battery must be charged using the disruption to operation accompanying charger It takes 5 8 hours to fully charge a battery Always wait at least 2 seconds after the last actuator has stopped moving before removing the battery Otherwise the controller may not have time to store the position and it may be necessary to perform O point calibration as described in section about 0 point calibration NORMAL OPERATION During normal operation the actuator is driven in an out using the approprt ate buttons on the remote control Situations may arise which require a particular action These situations are described below Low battery level If the battery level goes below a warning level while operating the actuators 3 short buzzer tonesare sounded This means that the battery requires recharging and the actuators can therefore only b
Download Pdf Manuals
Related Search