HOT DOG WARMING BLANKETS and DISPOSABLE SHEETS
Contents
1. designated holes along the edges of the blankets Cleaning General Clean the Warming Blanket between patient uses and anytime it appears soiled Follow protocols for non critical non sterile medical devices that may contact intact skin Examples of similar devices include blood pressure cuffs exam table covers operating room table pads and surgical supports In general alcohol based disinfectants are easiest to use since they are fast acting and can be sprayed or wiped on the blanket Other cleaners that are compatible with the outer surfaces of the blanket include sodium hypochlorite diluted bleach phenolic germicidal detergent and quaternary ammonium detergent Iodine containing cleaners may cause discoloration of the surface material and are therefore NOT recommended for routine cleaning Dry thoroughly before use Instructions for Use Hot Dog Warming Blankets amp Disposable Sheets Page 4 Cleaning amp Disinfection Steps The cleaning steps below are general recommendations and are not meant to replace hospital specific cleaning protocols 1 DO NOT allow cleaning fluids to get into the electrical connector 2 If visible soiling is present remove before applying a disinfectant Scrub the affected area with detergent using a soft brush or sponge to remove organic matter Rinse the surface of the blanket using a dampened cloth Do not immerse the blanket in liquids 3 Apply a low or intermediate level disinfectant to t2. WARMING BLANKETS amp DISPOSABLE SHEETS INSTRUCTIONS FOR USE INTRODUCTION Hot Dog Warming Blankets and Disposable Sheets are accessories for the Hot Dog Patient Warming System These instructions apply to the following catalog numbers Hot Dog Accessory Catalog Number Qty Pkg Warming Blanket Lower Body B103 Warming Blanket Full Body B104 Warming Blanket Multi Position B105 Warming Blanket Torso B110 Disposable Sheet Full Lower Body S104 Hot Dog Warming Blanket cables are provided separately INDICATIONS FOR USE The Hot Dog Patient Warming System is intended to prevent or treat hypothermia and to provide warmth to patients The Hot Dog Patient Warming System should be used in circumstances in which patients may not maintain a state of normothermia The Hot Dog Patient Warming System is intended primarily for use in hospitals and surgical centers including without limitation operating recovery and emergency rooms and on medical surgical floors CONTRAINDICATIONS e DO NOT warm patients during aortic cross clamping thermal injury may result e DO NOT warm patients with ischemic or non perfused limbs thermal injury may result e DO NOT warm patients receiving transdermal medication increased drug delivery may occur WARNINGS e EXPLOSION HAZARD DO NOT use the Hot Dog Controller or Warming Blankets in the presence of flammable anesthetics or oxygen enriched environments such as hyperbaric chambers oxygen tents e
3. ed by a white target is in good contact with the patient Position and secure the Warming Blanket following the instructions below for the applicable blanket model Blanket Model Blanket Positioning Securement Instructions Lower Body e Secure the Warming Blanket by tucking the unheated portions of the blanket and the sheet Full Body around the patient where possible e Secure the Warming Blanket to the patient using the included multi position reusable straps Velcro straps or tape Multi Position e Connect blanket segments to each other using the button and loop connector which is located on the inside of the blanket segments Fit the button and loop together to secure the two sections e Position the Warming Blanket on the patient so that there is good contact between the Torso blanket and the patient s chest arms and shoulders e Tuck the unheated insulated flaps around the patient s neck and shoulders Page 3 Instructions for Use Hot Dog Warming Blankets amp Disposable Sheets 6 Insert one end of the electrical cable into the appropriate port on the Hot Dog Controller Controller Model Port WOK WSK 7 Insert the other end of the cable into the electrical connector on the Warming Blanket 8 Turn the Hot Dog Controller on and select the desired temperature setting to begin warming Allow up to 10 minutes for the Warming Blanket to reach set point Refer to the Hot Dog Controller User Manual 9 If t
4. he Hot Dog Controller alarm sounds when the Warming Blanket is connected do not use the Warming Blanket Refer to the Alarms section 10 When use of the Warming Blanket is complete discard the Disposable Sheet and clean the Warming Blanket as necessary See Care and Maintenance section below CARE AND MAINTENANCE e DO NOT launder or sterilize as this may damage the Warming Blanket e DO NOT immerse the Warming Blanket in liquids e DO NOT use high level disinfectants e g gluteraldehyde peracetic acid to clean the Warming Blanket e DO NOT spray cleaning solutions into the electrical connector e DO NOT use cleaning or disinfection methods different from those recommended in the Instructions for Use without first checking with an authorized service representative to ensure that the proposed methods will not damage the equipment e DONOT use the Warming Blanket if it shows signs of damage or excessive wear such as cuts holes or loose electrical connectors Technical staff should perform inspection such as electrical leakage and resistance testing to determine if it is safe for use e DO NOT disassemble the Warming Blanket the product contains no serviceable parts If service is required call an authorized service representative for assistance Storage Store the Warming Blanket in a dry place and in a manner that prevents it from being cut or crushed Blankets may be stored folded or on hanging hooks using the
5. he entire blanket by spraying or wiping Follow the disinfectant manufacturer s application instructions to ensure disinfection 4 Dry thoroughly before use ALARMS If the Warming Blanket temperature exceeds one degree above set point or other fault conditions exist an audible alarm sounds and the Controller Alarm Light illuminates red for the port that is alarming The Controller will automatically discontinue power to the Warming Blanket When the operating temperature is regained the alarm will shut off and normal function will be restored If the Alarm Light illuminates steadily and the alarm continues to sound turn the Controller Mains Power Switch to the OFF position and disconnect the Warming Blanket from the Controller If the Controller senses an over current the audible alarm will sound and all alarm lights will illuminate Power will be lifted from all ports and the Controller will need to be turned off to reset If all Alarm Lights illuminate after resetting the Controller discontinue use of the Warming Blanket DEFINITION OF SYMBOLS Attention consult accompanying documents Serial Number Manufacture Date Temperature Sensor Transport and Storage Humidity Range Latex Free This Side Down Reference Number Use only with Hot Dog Patient Warming Controller Keep Dry Transport and Storage Temperature Range Not Sterile This Side Up BF Patient Applied Part according to IEC60601 1 L
6. ith warming ensure that surgical prep solution instructions for use are followed Care should be taken to place the patient s body in contact with the labeled sensor on the Warming Blanket DO NOT fold or wrinkle the Warming Blanket during use as localized heat build up may occur in the overlapped area Always use a patient barrier such as a Hot Dog Disposable Sheet or thin bed sheet between the patient and the Warming Blanket Warming Blanket placement should be considered during X ray imaging as the white labeling and internal wiring located primarily along the edges of the blankets may appear in images INSTRUCTIONS FOR USE l Inspect the surface of the Warming Blanket for damage e g cuts holes loose electrical connections Do not use the Warming Blanket if it is damaged Place a suitable patient barrier such as a Hot Dog Disposable Sheet or thin bed sheet over the patient Follow the instructions on the Hot Dog Disposable Sheet labeling to ensure proper positioning Place the Warming Blanket on top of the patient barrier ensuring the heated portion of the Warming Blanket black side faces the patient On blankets with unheated areas the heated portion of the blankets are marked with the heating area symbol See Definition of Symbols section Warning DO NOT place the Warming Blanket under the patient and DO NOT roll or fold blankets during use Ensure that the Warming Blanket temperature sensor indicat
7. ot Number Store as directed in instructions for use Conforms to European Medical Device Directive 93 42 EEC Return to Authorized Representative Protect from sharp objects Discontinue use if product is cut or damaged Page 5 Instructions for Use Hot Dog Warming Blankets amp Disposable Sheets EU Authorized Representative In USA Manufactured by Outside USA Manufactured by Authorized Service Representative Hot Dog USA Hot Dog International LLC EU Authorized Representative 7536 Washington Ave South 6581 City West Parkway Emergo Europe Eden Prairie MN 55344 USA Eden Prairie MN 55344 USA Molenstraat 15 888 439 2767 TEL 952 465 3500 2513 BH The Hague www HotDog USA com FAX 952 465 3501 The Netherlands www hotdogwarming com Tel 31 0 70 345 8570 Fax 31 0 70 346 7299 Hot Dog is a trademark of Augustine Biomedical Design registered in the U S Patent amp Trademark Office Patents Pending 2010 Augustine Biomedical Design All rights reserved P N 1718EN Rev D 05 2010
8. tc e DO NOT place Warming Blankets under the patient e Inspect Warming Blankets prior to use for signs of damage or excessive wear such as cuts holes or loose electrical connections If signs of wear are evident do not use the Warming Blanket until it is inspected by technical staff e DO NOT continue to use the Hot Dog Patient Warming System if the over temperature indicator and or alarm continue to sound after reset e Caution should be taken when using electric warming devices with HF surgical instruments or endocardial catheters in respect to potential equalization e DO NOT place Warming Blankets under straps that are used to secure the patient to the OR table e Hot Dog Warming Blankets and Disposable Sheets are not sterile Take appropriate precautions as necessary to protect the sterile field e Use only with Hot Dog Controller Models WCOX or WCSX Instructions for Use Hot Dog Warming Blankets amp Disposable Sheets Page 2 CAUTION Federal law USA restricts this device to sale by or on the order of a licensed healthcare professional PRECAUTIONS Use under the direct supervision of a clinician Monitor the patient s vital signs regularly during warming according to institutional protocol If vital sign instability occurs notify the clinician Care should be taken when using multiple warming methods The risk of skin irritation caused by pooling of surgical prep solutions under the patient may increase w
Download Pdf Manuals
Related Search