User`s Manual Pocket InfraRed Thermometer Model IR201
Contents
1. User s Manual EXTECH _ NSTRUMENTS A FLIR COMPANY Pocket InfraRed Thermometer Model IR201 Introduction Congratulations on your purchase of Extech s IR201 Pocket InfraRed Thermometer This device allows the user to take non contact temperature measurements simply by pointing the meter and LCD pressing a button This meter with proper care will provide years of safe reliable service Specifications General Specifications Measure MAX Laser Range Specifications Ranges Resolution 50 to 270 C 58 to 518 F 1 C 1 F Display 3 digit 2000 count LCD display Power off Automatic shutoff after approx 8 seconds Laser power Laser power less than 1mW red Operating Temperature 0 to 50 C 32 to 122 F Operating Humidity Max 80 RH Power Supply 2 x AAA battery Weight 76g 2 7 oz Size 94 x 51 x 25 mm 3 7 x2 x 1 20 to 270 C 4 to 518 F 2 5 of reading 2 C or 3 F Accuracy 50 to 20 C 58 to 4 F 5 C or 10 F Recommended 5cm to 91cm 2 to 36 measuring distance Emissivity settings 0 95 fixed Distance to Target 6 1 IR Measurements Taking Measurements Point the meter toward the object being measured then press and hold the MEASURE button The meter will turn ON and take a reading Read the measured temperature on the LCD The meter turns off automatically approxima2. sed batteries accumulators at collection points in your community or wherever batteries accumulators are sold Disposal Follow the valid legal stipulations in respect of the disposal of the device at the end of its lifecycle LASER RADIATION DO NOT STARE INTO BEAM DIODE LASER lt 1mW Output at 675nm CLASS II LASER PRODUCT Copyright 2005 Extech Instruments Corporation All rights reserved including the right of reproduction in whole or in part in any form IR201 EU EN V2 1 6 09
3. tely 8 seconds after the MEASURE button is released While pressing the MEASURE button Press the LASER button to turn on the laser pointer Press the MAX button to display and hold the highest reading The display will update with each higher reading The object being measured should be larger than the spot size as illustrated in the distance to spot diagram Measurement considerations If the surface of an object to be measured is covered with frost dust or other materials surface cleaning must be performed before accurate measurements can be made High Reflective Surfaces If the surface of an object to be measured is highly reflective with a very low emissivity value apply masking tape or apply flat black paint to the surface to raise to improve the accuracy of the measurement Diameter of Spot 3 7 6cm em 12 30em 7 18 46cm gt Distance to Object Ratio Displaying F or C Open the battery compartment move the slide switch located in the opening beneath the outermost battery Battery Replacement A flashing display indicates that the AAA batteries which power the meter have weakened Open the battery compartment on the rear of the meter replace the batteries and close the compartment You as the end user are legally bound Battery ordinance to return all used batteries and accumulators disposal in the household garbage is prohibited You can hand over your u
Download Pdf Manuals
Related Search